DataSheet.es    


PDF L9338MD Data sheet ( Hoja de datos )

Número de pieza L9338MD
Descripción QUAD LOW SIDE DRIVER
Fabricantes STMicroelectronics 
Logotipo STMicroelectronics Logotipo



Hay una vista previa y un enlace de descarga de L9338MD (archivo pdf) en la parte inferior de esta página.


Total 8 Páginas

No Preview Available ! L9338MD Hoja de datos, Descripción, Manual

® L9338
QUAD LOW SIDE DRIVER
WIDE INPUT VOLTAGE RANGE FROM -24V
UP TO +45V
WIDE OPERATING SUPPLY VOLTAGE
RANGE FROM 4.5V UP TO 32V
REVERSE BIASING PROTECTED (VS = -24V)
VERY LOW STANDBY QUIESCENT CUR-
RENT < 2µA
PROGRAMMABLE SIGNAL TRANSFER PO-
LARITY
TTL AND CMOS COMPATIBLE INPUTS
DEFINED OUTPUT OFF STATE OFF FOR
OPEN INPUTS
FOUR OPEN DRAIN DMOS OUTPUTS, WITH
RDSon = 1.5 at 25°C and VS > 6V
OUTPUT CURRENT LIMITATION
CONTROLLEDOUTPUTSLOPE FOR LOW EMI
OVERTEMPERATURE SHUT-DOWN
INTEGRATED OUTPUT CLAMPING FOR
FAST INDUCTIVE RECIRCULATION VFB > 45V
STATUS MONITORING FOR
- OVERTEMPERATURE
- DISCONNECTED GROUND OR SUPPLY
BLOCK DIAGRAM
ORDERING NUMBERS: L9338D (SO20)
L9338MD (SO20 (12+4+4))
VOLTAGE
ESD: ALL PINS ARE GUARANTEED TILL 2kV
HUMAN BODY MODEL
DESCRIPTION
The L9338 is a monolithic integrated quad low
side driver realized in advanced Multipower-BCD
technology. It is intended to drive lines, lamps or
relais in automotive or industrial applications.
IN4 CHANNEL 4
IN1
=&
OUT4
OUT1
CHANNEL 1
PRG
THERMAL
SHUTDOWN
4
DIAGNOSTIC
LOGIC
DIAG
EN
March 2000
Vint
REFERENCE Vlogic
GND VS
D95AT149
1/8

1 page




L9338MD pdf
CIRCUIT DESCRIPTION
The L9838 is a quad low side driver for lines,
lamps or inductive loads in automotive and indus-
trial applications.
All INputs are TTL or CMOS compatible. This al-
lows the device to be driven directly by a micro-
controller. For the noise immunity, all inputs have
a Schmitt-trigger with a hysteresis of typ. 100mV.
Each input stage has an input voltage protection
from -24V to 45V. The device can be activated
with a ’high’ signal on ENable input. ENable ’low’
switches the device into the sleep mode. In this
mode the quiescent current is less than 10µA. A
high signal on PRoGramming input changes the
signal transfer polarity from noninverting into the
inverting mode. Normally this pin is connected to
VS or GND. These pins (PRG and EN) are inter-
nally fixed at low status by open input condition.
Independent of the PRoGramming input, the
OUTput switches off, if the signal INput pin is not
connected.
Each output driver has a current limitation of min
0.4A and a seperate thermal shut-down. The ther-
mal shut-down deactivates that output which ex-
L9338
ceeds Temperature switch off level. About 20K
below this temperature threshold the output will
be activated again. This means, that each output
is able to sink continuously 285mA without acti-
vating thermal shut-down at 85°C ambient tem-
perature (SO20). The slew rate of the output is
limited to max. 14V/µs to reduce the electromag-
netic interference, but not for the enable transfer
characteristic (see fig. 1). An integrated active fly-
back voltage limitation clamps the output voltage
during the flyback phase of inductive loads to typ.
50V. The power DMOS switches ON, if the device
is enabled and the OUTput swings below ground.
This protection avoids the activation of parasitics
inside the power DMOS.
The DIAGnostic is an open drain output. The logic
status depends on the PRoGramming pin. If the
PRG pin is ’low’ the DIAG output becomes low, if
the device works correctly.
At thermal shut-down of one channel, discon-
nected ground or supply voltage the DIAGnostic
output becomes high. If the PRG pin is ’high’ this
output is switched off at normal function and
switched on at overtemperature.
DIAGNOSTIC TABLE
Pins
EN
Normal function
H
H
H
H
L
Overtemperature,
disconnected ground or
supply voltage
H
Overtemperature
H
PRG
L
L
H
H
X
L
H
X = not relevant * selective for each channel at overtemperature
IN
L
H
L
H
X
X
X
OUT
L (on)
H (off)
H (off)
L (on)
H (off)
H (off) *
H (off) *
DIAG
L (on)
L (on)
H(off)
H(off)
H(off)
H (off)
L (on)
5/8

5 Page










PáginasTotal 8 Páginas
PDF Descargar[ Datasheet L9338MD.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
L9338MDQUAD LOW SIDE DRIVERSTMicroelectronics
STMicroelectronics

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar