DataSheet.es    


PDF FT6336 Data sheet ( Hoja de datos )

Número de pieza FT6336
Descripción Self-Capacitive Touch Panel Controller
Fabricantes FocalTech Systems 
Logotipo FocalTech Systems Logotipo



Hay una vista previa y un enlace de descarga de FT6336 (archivo pdf) en la parte inferior de esta página.


Total 18 Páginas

No Preview Available ! FT6336 Hoja de datos, Descripción, Manual

FT6X36
Self-Capacitive Touch
Panel Controller
INTRODUCTION
The FT6X36 Series ICs are single-chip capacitive touch panel controller IC with a built-in 16 bit enhanced Micro-controller unit
(MCU).They adopt the self-capacitance technology, which supports single point and gesture touch or two points. In conjunction with
a self-capacitive touch panel, The FT6X36 Series ICs implement the user-friendly input function and are widely used in various
portable devices, such as smart phones, MIDs ad GPS.
The FT6X36 series ICs include FT6236/FT6336/FT6436L/FT6436, the difference of their specifications will be listed individually in
this datasheet.
FEATURES
Self-Capacitive Sensing Techniques support single point
touch and gesture or two point touch
Absolute X and Y coordinates or gesture
1 point and gestures / 2 points supported
High immunity to RF and power Interferences
Auto-calibration: Insensitive to Capacitance and Environ-
mental Variations
Built-in Enhanced MCU
FT6236 supports up to 22 or 28 channels of sensors /drivers
FT6336 supports up to 36 channels of sensors /drivers
FT6436L supports up to 42 channels of sensors /drivers
FT6436 supports up to 46 channels of sensors /drivers
Report Rate: Up to 100Hz
Support Interfaces :I2C
Support single film material TP and triangle pattern without
additional shield
Internal accuracy ADC and smooth filters
Support 2.8V to 3.6V Operating Voltage
Support independent IOVCC
Built-in LDO for Digital Circuits
High efficient power management with 3 Operating Modes
Active Mode
Monitor Mode
Hibernation Mode
Operating Temperature Range: -40°C to +85°C
ESD:HBM≥7000V,MM≥350V
FocalTech Systems Co., Ltd
· www.focaltech-systems.com
Document Number: D-FT6X36-DataSheet-20140724-V0.3
Revised July. 24, 2014

1 page




FT6336 pdf
In this mode, the chip is set in a power down mode. It shall respond to the “RESET” or “Wakeup” signal from the host processor. The
chip therefore consumes very little current, which help prolong the standby time for the portable devices.
Host Interface Figure 2-3 shows the interface between a host processor and FT6X36. This interface consists of the following three
sets of signals:
Serial Interface
Interrupt from FT6X36 to the Host
Reset Signal from the Host to FT6X36
TP S
TP Module
FT6X36
Serial
Interface
RSTN
/INT
Host
Figure 2-3 Host Interface Diagram
The serial interface of FT6X36 is I2C. The details of this interface are described in detail in Section 2.5. The interrupt signal (/INT) is
used for FT6X36 to inform the host that data are ready for the host to receive. The RSTN signal is used for the host to reset FT6X36.
After resetting, FT6X36 shall enter the Active mode.
2.4 Serial Interface
FT6X36 supports the I2C interfaces, which can be used by a host processor or other devices.
2.4.1 I2C
The I2C is always configured in the Slave mode. The data transfer format is shown in Figure 2-4.
SDA
MSB
SCL
1
START or
repeat START
2 3~6 7
ACK from
slave
89
ACK
ACK from
receiver
1 2 3~7 8 9
ACK
Stop
Figure 2-4 I2C Serial Data Transfer Format
SLV addr
Data[n]
Data[n+1]
Data[n+2]
S
A[6:0]
W A D[7:0]
A D[7:0]
A D[7:0]
AP
Figure 2-5 I2C master write, slave read
THIS DOCUMENT CONTAINS INFORMATION PROPRIETARY TO FOCALTECH SYSTEMS CO.,LTD., AND MAY NOT BE
REPRODUCED, DISCLOSED OR USED IN WHOLE OR PART WITHOUT THE EXPRESS WRITTEN PERMISSION OF
FOCALTECH SYSTEMS CO.,LTD.
Copyright © 2014, FocalTech Systems Co.,Ltd . All rights reserved
Version 0.3 Page 3 of 18

5 Page





FT6336 arduino
4 PIN CONFIGURATIONS
Pin List of FT6X36
Table 4-1 Pin Definition of FT6X36
Name
FT6236H
Mg
FT6236G
MA
Pin No.
FT6336D
MB
FT6436D FT6436L
Qf DQb
Type
VREF
1
1 47 56 53 PWR
S1 2
2 48 1 54 I/O
S2 3 3 1 2 55 I/O
S3 4 4 2 3 56 I/O
S4 5 5 3 4 1 I/O
S5 6 6 4 5 2 I/O
S6 7 7 5 6 3 I/O
S7 8 8 6 7 4 I/O
S8 9 9 7 8 5 I/O
S9 10
10
8
9
6 I/O
S10 11
11
9
10 7 I/O
S11 12 12 10 11 8 I/O
S12 13 13 11 12 9 I/O
S13 14 14 12 13 10 I/O
S14 15 15 13 14 11 I/O
S15 16 16 14 15 12 I/O
S16 17 17 15 16 13 I/O
S17 18 18 16 17 14 I/O
S18 19 19 17 18 15 I/O
S19 20 20 18 19 16 I/O
S20 21 21 19 20 17 I/O
S21 22 22 20 21 18 I/O
S22 23 23 21 22 19 I/O
S23 24 22 23 20 I/O
S24 25 23 24 21 I/O
S25 26 24 25 22 I/O
S26 27 25 26 23 I/O
S27 28 26 27 24 I/O
S28 29 27 28 25 I/O
S29 28 29 26 I/O
S30 29 30 27 I/O
S31 30 31 28 I/O
S32 31 32 29 I/O
S33 32 33 30 I/O
S34 33 34 31 I/O
S35 34 35 32 I/O
S36 35 36 33 I/O
S37 37 34 I/O
Description
Generated internal reference voltage.
A 1μF ceramic capacitor to ground is
required.
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
Capacitance sensor /driver channel
THIS DOCUMENT CONTAINS INFORMATION PROPRIETARY TO FOCALTECH SYSTEMS CO.,LTD., AND MAY NOT BE
REPRODUCED, DISCLOSED OR USED IN WHOLE OR PART WITHOUT THE EXPRESS WRITTEN PERMISSION OF
FOCALTECH SYSTEMS CO.,LTD.
Copyright © 2014, FocalTech Systems Co.,Ltd . All rights reserved
Version 0.3 Page 9 of 18

11 Page







PáginasTotal 18 Páginas
PDF Descargar[ Datasheet FT6336.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
FT6336Self-Capacitive Touch Panel ControllerFocalTech Systems
FocalTech Systems

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar