DataSheet.es    


PDF APXE100ARA151MF80G Data sheet ( Hoja de datos )

Número de pieza APXE100ARA151MF80G
Descripción CONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORS
Fabricantes NIPPON CHEMI-CON 
Logotipo NIPPON CHEMI-CON Logotipo



Hay una vista previa y un enlace de descarga de APXE100ARA151MF80G (archivo pdf) en la parte inferior de esta página.


Total 2 Páginas

No Preview Available ! APXE100ARA151MF80G Hoja de datos, Descripción, Manual

CONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORS
Surface Mount
PXENPCAPTM-
Series
Super low ESR, impedance and high heat resistance have been obtained by using
conductive polymer as electrolyte.
(ESR and rated ripple current values are improved from PXA series.)
Rated voltage range : 2.5 to 16Vdc, Capacitance range : 33 to 2,700µF
Suitable for DC-DC converters, voltage regulators and decoupling applications used on
computer motherboards etc.
Solvent resistant type (see PRECAUTIONS AND GUIDELINES)
RoHS Compliant
Halogen Free
SPECIFICATIONS
PXF P34
Lower ESR
PXE
Lower ESR
PXA P38
Items
Characteristics
Category
Temperature Range
Rated Voltage Range
Capacitance Tolerance
Surge Voltage
Leakage Current
Dissipation Factor
(tan )
Low Temperature
Characteristics
(Max. Impedance Ratio)
Endurance
-55 to +105
2.5 to 16Vdc
±20% (M)
Rated voltage×1.15
Shall not exceed values shown in STANDARD RATINGS.
(at 20, 120Hz)
(at 105)
(at 20after 2 minutes)
0.12 max.
(at 20, 120Hz)
Z(-25)/Z(+20)1.15
Z(-55)/Z(+20)1.25
(at 100kHz)
The following specifications shall be satisfied when the capacitors are restored to 20after the rated voltage is applied for 2,000 hours
at 105.
Appearance
No significant damage
Capacitance change
≦±20% of the initial value
D.F. (tanδ)
150% of the initial specified value
ESR
150% of the initial specified value
Bias Humidity
Leakage current
The initial specified value
The following specifications shall be satisfied when the capacitors are restored to 20after subjecting them to the DC rated voltage at
60, 90 to 95% RH for 1,000 hours.
Appearance
No significant damage
Capacitance change
≦±20% of the initial value
D.F. (tanδ)
150% of the initial specified value
ESR
150% of the initial specified value
Surge Voltage
Leakage current
The initial specified value
The capacitors shall be subjected to 1,000 cycles each consisting of charge with the surge voltage specified at 105for 30 seconds
through a protective resistor(R=1kΩ) and discharge for 5 minutes 30 seconds.
Appearance
No significant damage
Capacitance change
≦±20% of the initial value
D.F. (tanδ)
150% of the initial specified value
ESR
150% of the initial specified value
Failure Rate
Leakage current
The initial specified value
0.5% per 1,000 hours maximum (Confidence level 60% at 105)
*Note : If any doubt arises, measure the leakage current after the following voltage treatment.
Voltage treatment : DC rated voltage is applied to the capacitors for 120 minutes at 105.
DIMENSIONS [mm]
MARKING
Terminal Code : A
W
0.3max.
L±0.3 (Note)
A±0.2
(Note) L±0.5 for HA0, HC0, JA0, JC0
Size Code φD L A B C
W
E61 5 5.8 5.3 5.3 5.9 0.5 to 0.8
F61 6.3 5.8 6.6 6.6 7.2 0.5 to 0.8
F80 6.3 7.7 6.6 6.6 7.2 0.5 to 0.8
H70 8 6.7 8.3 8.3 9.0 0.7 to 1.1
H80 8 7.7 8.3 8.3 9.0 0.7 to 1.1
HA0 8 10.0 8.3 8.3 9.0 0.7 to 1.1
HC0 8 12.0 8.3 8.3 9.0 0.7 to 1.1
J80 10 7.7 10.3 10.3 11.0 0.7 to 1.1
JA0 10 10.0 10.3 10.3 11.0 0.7 to 1.1
JC0 10 12.2 10.3 10.3 11.0 0.7 to 1.1
P
1.4
1.9
1.9
3.1
3.1
3.1
3.1
4.5
4.5
4.5
EX) 2.5V390µF
E49A
390
2.5V
PART NUMBERING SYSTEM
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
A PXE A RA M G
Supplement code
Size code
Capacitance tolerance code
Capacitance code (ex. 47µF:470,100µF:101)
Taping code
Terminal code
Voltage code (ex. 6.3V:6R3,10V:100)
Series code
Category Please refer to "Product code guide (conductive polymer type)"
Product specifications in this catalog are subject to change without notice.Request our product specifications before purchase and/or use. Please use our products based on the information contained in this catalog and product specifications.
36 CAT. No. E1001O

1 page





PáginasTotal 2 Páginas
PDF Descargar[ Datasheet APXE100ARA151MF80G.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
APXE100ARA151MF80GCONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORSNIPPON CHEMI-CON
NIPPON CHEMI-CON

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar