DataSheet.es    


PDF TC74HC4051AFT Data sheet ( Hoja de datos )

Número de pieza TC74HC4051AFT
Descripción 8-CHANNEL ANALOG MULTIPLEXER/DEMULITIPLEXER
Fabricantes Toshiba Semiconductor 
Logotipo Toshiba Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de TC74HC4051AFT (archivo pdf) en la parte inferior de esta página.


Total 14 Páginas

No Preview Available ! TC74HC4051AFT Hoja de datos, Descripción, Manual

TC74HC4051,4052,4053AP/AF/AFT
TOSHIBA CMOS Digital Integrated Circuit Silicon Monolithic
TC74HC4051AP,TC74HC4051AF,TC74HC4051AFT
TC74HC4052AP,TC74HC4052AF,TC74HC4052AFT
TC74HC4053AP,TC74HC4053AF,TC74HC4053AFT
TC74HC4051AP/AF/AFT
8-Channel Analog Multiplexer/Demultiplexer
TC74HC4052AP/AF/AFT
Dual 4-Channel Analog
Multiplexer/Demultiplexer
TC74HC4053AP/AF/AFT
Triple 2-Channel Analog
Multiplexer/Demultiplexer
TC74HC4051AP, TC74HC4052AP,
TC74HC4053AP
The TC74HC4051A/4052A/4053A are high speed CMOS
ANALOG MULTIPLEXER/DEMULTIPLEXER fabricated with
silicon gate C2MOS technology. They achieve the high speed
operation similar to equivalent LSTTL while maintaining the
CMOS low power dissipation.
The TC74HC4051A has an 8 channel configuration, the
TC74HC4052A has a 4 channel × 2 configuration and the
TC74HC4053A has a 2 channel × 3 configuration.
The digital signal to the control terminal turns “ON” the
corresponding switch of each channel a large amplitude signal
(VCC VEE) can then be switched by the small logical amplitude
(VCC GND) control signal.
For example, in the case of VCC = 5 V, GND = 0 V, VEE = 5 V,
signals between 5 V and +5 V can be switched from the logical
circuit with a single power supply of 5 V. As the ON-resistance of
each switch is low, they can be connected to circuits with low
input impedance.
All inputs are equipped with protection circuits against static
discharge or transient excess voltage.
Features
High speed: tpd = 15 ns (typ.) at VCC = 5 V, VEE = 0 V
Low power dissipation: ICC = 4 μA (max) at Ta = 25°C
High noise immunity: VNIH = VNIL = 28% VCC (min)
Low ON resistance: RON = 50 Ω (typ.) at VCC VEE = 9 V
High noise immunity: THD = 0.02% (typ.) at VCC VEE = 9 V
Pin and function compatible with 4051/4052/4053B
TC74HC4051AF, TC74HC4052AF,
TC74HC4053AF
TC74HC4051AFT, TC74HC4052AFT,
TC74HC4053AFT
Weight
DIP16-P-300-2.54A
SOP16-P-300-1.27A
TSSOP16-P-0044-0.65A
: 1.00 g (typ.)
: 0.18 g (typ.)
: 0.06 g (typ.)
1 2012-02-29

1 page




TC74HC4051AFT pdf
Absolute Maximum Ratings (Note 1)
TC74HC4051,4052,4053AP/AF/AFT
Characteristics
Symbol
Rating
Unit
Supply voltage range
Supply voltage range
Control input voltage
Switch I/O voltage
Control input diode current
I/O diode current
Switch through current
DC VCC or ground current
Power dissipation
Storage temperature
VCC
VCC-VEE
VIN
VI/O
IICK
IOK
IT
ICC
PD
Tstg
0.5 to 7
0.5 to 13
0.5 to VCC + 0.5
VEE 0.5 to VCC + 0.5
±20
±20
±25
±50
500 (DIP) (Note 2)/180 (SOP, TSSOP)
65 to 150
V
V
V
V
mA
mA
mA
mA
mW
°C
Note 1:
Exceeding any of the absolute maximum ratings, even briefly, lead to deterioration in IC performance or
even destruction.
Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly
even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute
maximum ratings and the operating ranges.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test
report and estimated failure rate, etc).
Note 2: 500 mW in the range of Ta = −40 to 65°C. From Ta = 65 to 85°C a derating factor of 10 mW/°C should be
applied up to 300 mW.
Operating Ranges (Note)
Characteristics
Symbol
Rating
Unit
Supply voltage range
Supply voltage range
Supply voltage range
Control input voltage
Switch I/O voltage
Operating temperature
Control input rise and fall time
VCC
VEE
VCC-VEE
VIN
VI/O
Topr
tr, tf
2 to 6
6 to 0
2 to 12
0 to VCC
VEE to VCC
40 to 85
0 to 1000 (VCC = 2.0 V)
0 to 500 (VCC = 4.5 V)
0 to 400 (VCC = 6.0 V)
V
V
V
V
V
°C
ns
Note: The operating ranges must be maintained to ensure the normal operation of the device.
Unused control inputs must be tied to either VCC or GND.
5 2012-02-29

5 Page





TC74HC4051AFT arduino
Package Dimensions
TC74HC4051,4052,4053AP/AF/AFT
Weight: 1.00 g (typ.)
11 2012-02-29

11 Page







PáginasTotal 14 Páginas
PDF Descargar[ Datasheet TC74HC4051AFT.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
TC74HC4051AF8-CHANNEL ANALOG MULTIPLEXER/DEMULITIPLEXERToshiba Semiconductor
Toshiba Semiconductor
TC74HC4051AFT8-CHANNEL ANALOG MULTIPLEXER/DEMULITIPLEXERToshiba Semiconductor
Toshiba Semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar