DataSheet.es    


PDF CAV25512 Data sheet ( Hoja de datos )

Número de pieza CAV25512
Descripción 512-Kb SPI Serial CMOS EEPROM
Fabricantes ON Semiconductor 
Logotipo ON Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de CAV25512 (archivo pdf) en la parte inferior de esta página.


Total 14 Páginas

No Preview Available ! CAV25512 Hoja de datos, Descripción, Manual

CAV25512
512-Kb SPI Serial CMOS
EEPROM
Description
The CAV25512 is a 512−Kb Serial CMOS EEPROM device
internally organized as 64Kx8 bits. This features a 128−byte page
write buffer and supports the Serial Peripheral Interface (SPI)
protocol. The device is enabled through a Chip Select (CS) input. In
addition, the required bus signals are clock input (SCK), data input
(SI) and data output (SO) lines. The HOLD input may be used to pause
any serial communication with the CAV25512 device. The device
features software and hardware write protection, including partial as
well as full array protection.
On−Chip ECC (Error Correction Code) makes the device suitable
for high reliability applications.
Features
Automotive Temperature Grade 1 (−40°C to +125°C)
10 MHz SPI Compatible
2.5 V to 5.5 V Supply Voltage Range
SPI Modes (0,0) & (1,1)
128−byte Page Write Buffer
Additional Identification Page with Permanent Write Protection
Self−timed Write Cycle
Hardware and Software Protection
Block Write Protection
− Protect 1/4, 1/2 or Entire EEPROM Array
Low Power CMOS Technology
1,000,000 Program/Erase Cycles
100 Year Data Retention
SOIC, TSSOP and WLCSP 8−lead Packages
This Device is Pb−Free, Halogen Free/BFR Free, and RoHS
Compliant
VCC
SI
CS
WP
HOLD
SCK
CAV25512
SO
VSS
Figure 1. Functional Symbol
This document contains information on some products that are still under development.
ON Semiconductor reserves the right to change or discontinue these products without
notice.
www.onsemi.com
SOIC−8
V SUFFIX
CASE 751BD
TSSOP−8
Y SUFFIX
CASE 948AL
WLCSP−8
C8A SUFFIX
CASE 567MB
PIN CONFIGURATION
Pin A1
Reference
CS
1
SO
VCC
HOLD
WP
SCK
SI
VCC
VSS
SI SCK
WP HOLD
SOIC (V), TSSOP (Y)
SO
VSS
CS
WLCSP (C8A)
(Top View)
Pin Name
CS
SO
WP
VSS
SI
SCK
HOLD
VCC
PIN FUNCTION
Function
Chip Select
Serial Data Output
Write Protect
Ground
Serial Data Input
Serial Clock
Hold Transmission Input
Power Supply
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 14 of this data sheet.
© Semiconductor Components Industries, LLC, 2016
September, 2016 − Rev. 4
1
Publication Order Number:
CAV25512/D

1 page




CAV25512 pdf
CAV25512
Status Register
The Status Register, as shown in Table 8, contains a
number of status and control bits.
The RDY (Ready) bit indicates whether the device is busy
with a write operation. This bit is automatically set to 1 during
an internal write cycle, and reset to 0 when the device is ready
to accept commands. For the host, this bit is read only.
The WEL (Write Enable Latch) bit is set/reset by the
WREN/WRDI commands. When set to 1, the device is in a
Write Enable state and when set to 0, the device is in a Write
Disable state.
The BP0 and BP1 (Block Protect) bits determine which
blocks are currently write protected. They are set by the user
with the WRSR command and are non−volatile. The user is
allowed to protect a quarter, one half or the entire memory,
by setting these bits according to Table 9. The protected
blocks then become read−only.
The WPEN (Write Protect Enable) bit acts as an enable for
the WP pin. Hardware write protection is enabled when the
WP pin is low and the WPEN bit is 1. This condition
prevents writing to the status register and to the block
protected sections of memory. While hardware write
protection is active, only the non−block protected memory
can be written. Hardware write protection is disabled when
the WP pin is high or the WPEN bit is 0. The WPEN bit, WP
pin and WEL bit combine to either permit or inhibit Write
operations, as detailed in Table 10.
The IPL (Identification Page Latch) bit determines
whether the additional Identification Page (IPL = 1) or main
memory array (IPL = 0) can be accessed both for Read and
Write operations. The IPL bit is set by the user with the
WRSR command and is volatile. The IPL bit is
automatically reset after read/write operations.
The LIP (Lock Identification Page) bit is set by the user
with the WRSR command and is non−volatile. When set to
1, the Identification Page is permanently write protected
(locked in Read−only mode).
Note: The IPL and LIP bits cannot be set to 1 using the same
WRSR instruction. If the user attempts to set (“1”) both the
IPL and LIP bit in the same time, these bits cannot be written
and therefore they will remain unchanged.
Table 8. STATUS REGISTER
76
WPEN
IPL
5
0
4 3 2 10
LIP
BP1
BP0
WEL
RDY
Table 9. BLOCK PROTECTION BITS
Status Register Bits
BP1 BP0
00
01
10
11
Array Address Protected
None
C000−FFFF
8000−FFFF
0000−FFFF
Protection
No Protection
Quarter Array Protection
Half Array Protection
Full Array Protection
Table 10. WRITE PROTECT CONDITIONS
WPEN
WP
0X
0X
1 Low
1 Low
X High
X High
WEL
0
1
0
1
0
1
Protected Blocks
Protected
Protected
Protected
Protected
Protected
Protected
Unprotected Blocks
Protected
Writable
Protected
Writable
Protected
Writable
Status Register
Protected
Writable
Protected
Protected
Protected
Writable
www.onsemi.com
5

5 Page





CAV25512 arduino
PIN # 1
IDENTIFICATION
TOP VIEW
CAV25512
PACKAGE DIMENSIONS
SOIC 8, 150 mils
CASE 751BD
ISSUE O
E1 E
SYMBOL
A
A1
b
c
D
E
E1
e
h
L
θ
MIN
1.35
0.10
0.33
0.19
4.80
5.80
3.80
0.25
0.40
NOM
1.27 BSC
MAX
1.75
0.25
0.51
0.25
5.00
6.20
4.00
0.50
1.27
D
A1
A
eb
SIDE VIEW
Notes:
(1) All dimensions are in millimeters. Angles in degrees.
(2) Complies with JEDEC MS-012.
h
θ
L
END VIEW
c
www.onsemi.com
11

11 Page







PáginasTotal 14 Páginas
PDF Descargar[ Datasheet CAV25512.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
CAV25512512-Kb SPI Serial CMOS EEPROMON Semiconductor
ON Semiconductor
CAV25512H512-Kb SPI Serial CMOS EEPROMON Semiconductor
ON Semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar