DataSheet.es    


PDF SD45216SAGTR Data sheet ( Hoja de datos )

Número de pieza SD45216SAGTR
Descripción HIGH EFFICIENCY STEP-DOWN DC/DC CONVERTER
Fabricantes Silan Microelectronics 
Logotipo Silan Microelectronics Logotipo



Hay una vista previa y un enlace de descarga de SD45216SAGTR (archivo pdf) en la parte inferior de esta página.


Total 8 Páginas

No Preview Available ! SD45216SAGTR Hoja de datos, Descripción, Manual

SD45216_Datasheet
HIGH EFFICIENCY STEP-DOWN DC/DC CONVERTER WITH
ADJUSTABLE CURRENT LIMIT FOR AUTOMOTIVE APPLICATIONS
DESCRIPTION
The SD45216 is a high efficiency step down DC-DC converter
with adjustable current limit in compact SOP-8 package,
including an error amplifier, ramp generator, current comparator,
slope compensation, current sense and logic driver. It also
integrates a current error amplifier to have a constant voltage
and constant current control.
Peak current mode PWM control with external adjustable
compensation provides a stable and high efficient operation over
a wide range of load currents. By means of an on board current
sense resistor and the availability of the current sense pins, a
current limit programming is very simple and accurate.
The internal robust P-channel DMOS transistor with a typical of
100 massures high efficiency even at high output current level.
The internal limiting current of typical value of 3 A, output short
and over temperature protection, protect the device from
APPLICATIONS
accidental damage.
* Automotive applications
The internal fixed switching frequency of 120 kHz, and the * Chargers for NiCd, NiMH batteries
SOP-8 package pin allow building an ultra compact DC/ DC * Simple step-down converters with
converter with a minimum board space.
adjustable current limit
FEATURES
* Adjustable current generator
* Up to 2A output current
* Up to 90% Efficiency
* Input Voltage Range: 8V to 40V
* 120 kHz Internal Jitter Frequency for lower EMI
* Patent -Pending Short Circuit Protection
* Patent -Pending Output Voltage Compensation
* Adjustable current limit
* Over Temperature Protection
* Small SOP-8 Package
ORDERING INFORMATION
Part No.
SD45216SA
SD45216SATR
SD45216SAG
SD45216SAGTR
SD45216JA
SD45216JATR
Package
SOP-8-225-1.27
SOP-8-225-1.27
SOP-8-225-1.27
SOP-8-225-1.27
ESOP-8-225-1.27
ESOP-8-225-1.27
Marking
45216SA
45216SA
5216SAG
5216SAG
45216JA
45216JA
HANGZHOU SILAN MICROELECTRONICS CO.,LTD
Http://www.silan.com.cn
Material
Pb free
Pb free
Halogen free
Halogen free
Pb free
Pb free
Packing
Tube
Tape&Reel
Tube
Tape&Reel
Tube
Tape&Reel
REV:1.0
2010.10.27
Page 1 of 8

1 page




SD45216SAGTR pdf
SD45216_Datasheet
Component Selection
— Inductor Selection
The SD45216 can utilize small inductors due to its fast 120kHz switching frequency. Typically, a 100μH
inductor is recommended for most applications. Larger values of inductance will allow greater output current
capability by reducing the inductor ripple current. Increasing the inductance above will also increase size.
The inductor current ripple is typically set for 20% to 40% of the maximum inductor current (IP). The inductor
should have low ESR (series resistance of the windings) to reduce the power losses, and must be able to
handle the peak inductor current without saturating. To minimize radiated noise, use a shielded bobbin
inductor.
— Output and Input Capacitor Selection
Low ESR (equivalent series resistance) capacitors should be used to minimize the output voltage ripple. The
parallel of multilayer ceramic and electrolytic capacitors is an excellent choice as they have extremely low
ESR and are low cost. A parallel of 10μF ceramic capacitor and 470μF electrolytic capacitor is sufficient for
most applications. Larger values may be used to obtain extremely low output voltage ripple and improve
transient response.
Low ESR input capacitors reduce input switching noise and reduce the peak current drawn from the battery. It
follows that ceramic capacitors are also a good choice for input decoupling, and should be located as close as
possible to the device. A 10μF input capacitor is sufficient for virtually any application.
For all the ceramic capacitors above, X5R and X7R dielectric materials are preferred, for their ability to
maintain capacitance over wide voltage and temperature ranges.
TYPICAL APPLICATION CIRCUIT
Figure 1. Application Circuit for 5V/2A Output
Note: The circuit and parameters are reference only, please set the parameters of the real application circuit based
on the real test.
HANGZHOU SILAN MICROELECTRONICS CO.,LTD
Http://www.silan.com.cn
REV:1.0
2010.10.27
Page 5 of 8

5 Page










PáginasTotal 8 Páginas
PDF Descargar[ Datasheet SD45216SAGTR.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
SD45216SAGTRHIGH EFFICIENCY STEP-DOWN DC/DC CONVERTERSilan Microelectronics
Silan Microelectronics

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar