|
|
Número de pieza | QN8006LB | |
Descripción | High Performance Digital FM Transceiver | |
Fabricantes | Quintic | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de QN8006LB (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
No Preview Available ! QN8006B/8006LB
High Performance Digital FM Transceiver for Portable Devices
__________________________ General Description __________________________
The QN8006 is a high performance, low power, fully integrated single-chip stereo FM transceiver designed for cell phones,
PMP/PNDs, and portable radios. It integrates both FM receiving and transmitting functions, auto-seek and clear channel
scan, and antenna tuning to ease matching in real applications. Advanced digital architecture enables superior receiver
sensitivity, crystal clear audio, unsurpassed spectral purity, ultra-low harmonic and spurious levels, and high immunity to
TDMA burst noise.
With its small footprint, minimal external component count and multiple clock frequency support, the QN8006 is easy to
integrate into a variety of small form-factor low power portable applications. An integrated voltage regulator enables direct
connection to a battery and provides high PSRR for superior noise suppression. A low-power Standby mode extends battery
life. ESD protection is on all pins. The QN8006 is fabricated in highly reliable CMOS technology.
_____________________________ Key Features _____________________________
• Worldwide FM Band Receive and Transmit
• 76 MHz ~ 108 MHz full band tuning in
50/100/200 kHz step sizes
• 50/75µs pre-emphasis and de-emphasis
• High Performance FM Receiver (FMR)
• Superior sensitivity: 1.2µVEMF
• High SNR: 66dB Stereo
• Ultra Low THD: 0.03%
• High interference rejection
• Integrated adaptive noise cancellation (SNC, HCC,
SM)
• Auto channel seek
• High Performance FM Transmitter (FMT)
• 66dB Stereo SNR, 0.03% THD
• Maximum 121dBµVp RF output level with 42dB
adjustable range
• Integrated Clear Channel Scan
• RDS/RBDS Transmit & Receive (QN8006B
Supported)
• Supports US and European data service,
including TMC (Traffic Messaging Channel)
• Very Low Power Consumption
• 9.2mA (Transmit Mode), 17mA (Receive Mode)
• Integrated voltage regulator, direct connect to battery
• Power saving IDLE and Standby modes
• Low shutdown leakage current
• Flexible Audio Interfaces
• Digital audio interface supports I2S and a variety of
PCM data formats with 4 different data rates
• Programmable analog audio input/output
• Integrated audio AGC and soft clipping
• Ease of Integration
• Small footprint, 4 x 4 x 0.85 mm3 QFN24
• Adaptive antenna tuning
• Low cellular and GPS band spurs
• High Immunity to TDMA (GSM/GPRS) burst noise
• Multiple crystal frequencies supported
• 2-wire and 3-wire control interfaces
• Robust Operation
• -250C to +850C operation
• ESD protection on all input and output pads
_____________________________ Typical Applications __________________________
Cell Phones / PDAs / Smart Phones
Portable Audio & Media Players
GPS Personal Navigation Devices
Automotive Accessories
Rev 2.08 (04/10)
Confidential A
Copyright ©2010 by Quintic Corporation
Confidential Information contained herein is covered under Non-Disclosure Agreement (NDA).
Page 1
1 page 2 PIN ASSIGNMENTS
QN8006B/8006LB
(Top View)
ALO 1
ARO 2
AUGND 3
ALI 4
ARI 5
AGND 6
Exposed Pad
Pin 25
(AGND )
- far side -
18 XTAL 2
17 XTAL 1
16 XCLK
15 WS
14 DOUT /INT
13 MCK
Figure 2: QN8006B Pin out
Rev 2.08 (04/10)
Confidential A
Copyright ©2010 by Quintic Corporation
Confidential Information contained herein is covered under Non-Disclosure Agreement (NDA).
Page 5
5 Page SYMBOL
PARAMETERS
Notes:
1. FORCE_MO=0;
CONDITIONS
QN8006B/8006LB
MIN TYP MAX UNIT
Table 8: Timing Characteristics
(Vcc = 2.7 ~ 5.0 V, TA = -25 ~ 85 oC, unless otherwise noticed. Typical values are at Vcc = 3.3V and TA = 25oC).
SYMBOL
PARAMETER
CONDITIONS
MIN TYP MAX UNIT
From rising edge of CEN to
τpup Chip power-up time 1 PLL settled and transmitter
ready for transmission.
TMOUT [1:0] = 00
τastby
Auto Standby time 2
TMOUT [1:0] = 01
TMOUT [1:0] = 10
TMOUT [1:0] = 11
τchsw
Channel switching
time1
From any channel to any
channel.
1
3
5
Never
0.6
0.1
Sec
Min
Sec
Transmitter Timing
τwkup
Wake-up time from
standby to transmit
25 200 msec
τCCS Clear channel scan time Per channel.
5 msec
Receiver Timing
τwkup
Wake-up time from
standby to receive
Standby to RX mode.
200 msec
Mode switch time from RX mode to TX mode.
τtrx receive to/from
transmit
TX mode to RX mode.
500 µsec
100 msec
τtune Tune time
Per channel, including Seek 1, 3.
5
msec
Notes:
1. Guaranteed by design.
2. Chip automatically goes from IDLE to standby mode; TMOUT = 11 equivalent to auto standby disabled.
3. More time is required until audio is output.
Rev 2.08 (04/10)
Confidential A
Copyright ©2010 by Quintic Corporation
Confidential Information contained herein is covered under Non-Disclosure Agreement (NDA).
Page 11
11 Page |
Páginas | Total 30 Páginas | |
PDF Descargar | [ Datasheet QN8006LB.PDF ] |
Número de pieza | Descripción | Fabricantes |
QN8006L | High Performance Digital FM Transceiver | Quintic |
QN8006LB | High Performance Digital FM Transceiver | Quintic |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |