DataSheet.es    


PDF NL10276BC30-34R Data sheet ( Hoja de datos )

Número de pieza NL10276BC30-34R
Descripción TFT COLOR LCD MODULE
Fabricantes NEC 
Logotipo NEC Logotipo



Hay una vista previa y un enlace de descarga de NL10276BC30-34R (archivo pdf) en la parte inferior de esta página.


Total 28 Páginas

No Preview Available ! NL10276BC30-34R Hoja de datos, Descripción, Manual

Global LCD Panel Exchange Center
www.panelook.com
TFT COLOR LCD MODULE
NL10276BC30-34R
38cm (15.0 Type)
XGA
LVDS interface (1port)
PRELIMINARY DATA SHEET
DOD-PP-1202 (1st edition)
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.
Document Number: DOD-PP-1202 (1st edition)
Published date: March 2011 CP(N)
1 ¤ NEC LCD Technologies, Ltd.
2011 All rights reserved.
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com

1 page




NL10276BC30-34R pdf
Global LCD Panel Exchange Center
www.panelook.com
NL10276BC30-34R
2. GENERAL SPECIFICATIONS
Display area
Diagonal size of display
Drive system
Display color
Pixel
Pixel arrangement
Dot pitch
Pixel pitch
Module size
Weight
Contrast ratio
Viewing angle
Designed viewing direction
Polarizer surface
Polarizer pencil-hardness
Color gamut
Response time
Luminance
Signal system
Power supply voltage
304.128 (H) u 228.096 (V) mm
38cm (15.0 inches)
a-Si TFT active matrix
262,144 colors (6bit)
1,024 (H) u 768 (V) pixels
RGB (Red dot, Green dot, Blue dot) vertical stripe
0.099 (H) u 0.297 (V) mm
0.297 (H) u 0.297 (V) mm
326.5 (W) u253.5 (H) u 11.5 (D) mm (typ.)
970g (typ.)
600:1 (typ.)
At the contrast ratio t 10:1
x Horizontal: Right side 80q (typ.), Left side 80q (typ.)
x Vertical: Up side 80q (typ.), Down side 80q (typ.)
At DPS terminal= Low or Open: Normal scan
x Viewing direction without image reversal: Up side (12 o'clock)
x Viewing direction with contrast peak: Down side (6 o'clock)
x Viewing angle with optimum grayscale (J2.2): Normal axis
(perpendicular)
Antiglare
3H (min.) [by JIS K5600]
At LCD panel center
50% (typ.) [against NTSC color space]
Ton+Toff (10%mo 90%)
18ms (typ.)
At IL= 50mA / One circuit
400cd/m2 (typ.)
LVDS 1port
(Receiver: Equivalent of THC63LVDF84B, THine Electronics Inc.)
[6-bit digital signals for data of RGB colors, Dot clock (CLK),
Data enable (DE)]
LCD panel signal processing board: 3.3V
LED Backlight type:
Backlight
Power consumption
Replaceable part
x Lamp holder set: Type No.:150LHS36
Recommended LED driver board (Option)
x LED driver board: Type No.:150PW02F
x Corresponding wiring harness: Type No. 150CBL02
At IL= 50mA / One circuit, Checkered flag pattern
9.8W (typ.)
PRELIMINARY DATA SHEET DOD-PP-1202 (1st edition)
5
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com

5 Page





NL10276BC30-34R arduino
Global LCD Panel Exchange Center
www.panelook.com
NL10276BC30-34R
4.4 POWER SUPPLY VOLTAGE SEQUENCE
4.4.1 LCD panel signal processing board
VCC
Note1
0V
ON
3.0V
0.1ms < Tr < 80ms
OFF
2.5V 3.0V
20ms max.
ON
Toff > 200ms
Display signals*,
Function signals
Note2
0V
0.01ms < t < 50ms
VALID period
0.01ms < t < 50ms
* These signals should be measured at the terminal of 100: resistance.
Note1: If there is a voltage variation (voltage drop) at the rising edge of VCC below 3.0V, there is a
possibility that a product does not work due to a protection circuit.
Note2: Display signals (D0+/-, D1+/-, D2+/-, CLK+/-) and function signals (MSL, DPS) must be set
to Low or High impedance, except the VALID period (See above sequence diagram), in order
to avoid the circuitry damage.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. If a customer stops the
display and function signals, VCC also must be shut down.
4.4.2 LED driver board
Display signals,
Function signals
Note1
Note2
VALID period
LED backlight: ON
Note1: These are the display and function signals for LCD panel signal processing board.
Note2: The backlight should be turned on within the valid period of display and function signals, in
order to avoid unstable data display.
PRELIMINARY DATA SHEET DOD-PP-1202 (1st edition)
11
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com

11 Page







PáginasTotal 28 Páginas
PDF Descargar[ Datasheet NL10276BC30-34R.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
NL10276BC30-34BDLCD ModuleNLT
NLT
NL10276BC30-34DLCD ModuleNEC
NEC
NL10276BC30-34RTFT COLOR LCD MODULENEC
NEC

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar