DataSheet.es    


PDF CM6800T Data sheet ( Hoja de datos )

Número de pieza CM6800T
Descripción EPA/85+ PFC+PWM COMBO CONTROLLER
Fabricantes Champion Microelectronic 
Logotipo Champion Microelectronic Logotipo



Hay una vista previa y un enlace de descarga de CM6800T (archivo pdf) en la parte inferior de esta página.


Total 27 Páginas

No Preview Available ! CM6800T Hoja de datos, Descripción, Manual

http://www.championmicro.com.tw
CM6800T (Turbo-Speed PFC+Green PWM)
EPA/85+ PFC+PWM COMBO CONTROLLER
Design for High Efficient Power Supply
GENERAL DESCRIPTION
CM6800T is a turbo-speed PFC and a Green PWM controller.
It is designed to further increase power supply efficiency while
using the relatively lower 380V Bulk Capacitor value.
Switching to CM6800T from your existing CM6800 family
boards can gain the following advanced performances:
1.) Hold Up time can be increased ~ 30% from the
existing 6800 power supply
2.) Turbo Speed PFC may reduce 420 Bulk Capacitor
size
3.) 420V bulk capacitor value may be reduced and PFC
Boost Capacitor ripple current can be reduced
4.) No Load Consumption can be reduced 290mW at
270VAC
5.) Better Power Factor and Better THD
6.) Clean Digital PFC Brown Out
7.) PWM transformer size can be smaller
8.) Superior Surge Noise Immunity
9.) To design 12V, 5V, and 3.3V output filters can be easy
10.) The stress over the entire external power device is
reduced and EMI noise maybe reduced; PFC inductor
core might be reduced
11.) Monotonic Output design is easy
12.) And more… Of course, the cost can be reduced
CM6800T is pin to pin compatible with CM6800 family.
Beside all the goodies in the CM6800, it is designed to meet
the EPA/85+ regulation. With the proper design, its efficiency
of power supply can easily approach 85%.
To start evaluating CM6800T from the exiting CM6800,
CM6800A, or ML4800 board, 6 things need to be taken care
before doing the fine tune:
1.) Change RAC resistor (on pin 2, IAC) from the old
value to a higher resistor value between 4.7 Mega
ohm to 8 Mega ohm. Start with 6 Mega ohm for RAC
first.
2.) Change RTCT pin (pin 7) from the existing value to
RT=5.88K ohm and CT=1000pF to have fpfc=68Khz,
fpwm=68Khz, frtct=272Khz for CM6800T
3.) Adjust all high voltage resistor around 5 mega ohm or
higher.
4.) VRMS pin(pin 4) needs to be 1.14V at VIN=80VAC for
universal input application from line input from 80VAC
to 270VAC.
5.) At full load, the average Veao needs to around 4.5V
and the ripple on the Veao needs to be less than
250mV when the load triggers the light load
comparator.
6.) Soft Start pin (pin 5), the soft start current has been
reduced from CM6800’s 20uA to CM6800T’s
10uA.Soft Start capacitor can be reduced to 1/2 from
your original CM6800 capacitor.
FEATURES
‹ Patents Pending
‹ Pin to pin compatible with CM6802 family, CM6800
family, and ML4800 family
‹ 23V Bi-CMOS process
‹ Designed for EPA/85+ efficiency
‹ Digitized Exactly 50% Maximum PWM Duty Cycle
‹ All high voltage resistors can be greater than 4.7 Mega
ohm (4.7 Mega to 8 Mega ohm) to improve the no load
consumption
‹ Rail to rail CMOS Drivers with on, 60 ohm and off, 30
ohm for both PFC and PWM with two 17V zeners
‹ Fast Start-UP Circuit without extra bleed resistor to aid
VCC reaches 13V sooner
‹ Low start-up current (55uA typ.)
‹ Low operating current (2.5mA typ.)
‹ 16.5V VCC shunt regulator
‹ Leading Edge Blanking for both PFC and PWM
‹ fRTCT = 4*fpfc =4*fpwm for CM6800T
‹ Dynamic Soft PFC to ease the stress of the Power
Device and Ease the EMI filter design
‹ Clean Digital PFC Brown Out and PWM Brown Out
‹ Adjustable Long Delay Time for Line Sagging
(Up to 2 Second)
‹ Turbo Speed PFC may reduce 420 Bulk Capacitor size
‹ Internally synchronized leading edge PFC and trailing
edge PWM in one IC to Reduces ripple current in the
420V storage capacitor between the PFC and PWM
sections
‹ Better Power Factor and Better THD
‹ Average current, continuous or discontinuous boost
leading edge PFC
‹ PWM configurable for current mode or feed-forward
voltage mode operation
‹ Current fed Gain Modulator for improved noise
immunity
‹ Gain Modulator is a constant maximum power limiter
‹ Precision Current Limit, over-voltage protection, UVLO,
soft start, and Reference OK
2010/08/03 Rev. 1.2
Champion Microelectronic Corporation
1

1 page




CM6800T pdf
http://www.championmicro.com.tw
CM6800T (Turbo-Speed PFC+Green PWM)
EPA/85+ PFC+PWM COMBO CONTROLLER
Design for High Efficient Power Supply
ELECTRICAL CHARACTERISTICS:
Unless otherwise stated, these specifications apply Vcc=+14V, RT = 5.88 k, CT = 1000pF, TA=Operating Temperature
Range (Note 1)
Symbol
Parameter
Test Conditions
Clean Digital PFC Brown Out
VRMS Threshold High
Room Temperature=25℃
VRMS Threshold Low
Room Temperature=25℃
Hysteresis
Voltage Error Amplifier (gmv)
Input Voltage Range
Transconductance
VNONINV = VINV, VEAO = 3.35V @ T=25
Feedback Reference Voltage
Input Bias Current
Note 2
Output High Voltage
Output Low Voltage
Sink Current
Overdrive Voltage = 100mV @ T=25
Source Current
Overdrive Voltage = 100mV @ T=25
Open Loop Gain
Guaranteed by design
Power Supply Rejection Ratio 11V < VCC < 16.5V
CM6800T
Min. Typ.
Max.
Unit
1.70 1.78
1.86
V
0.98 1.03
1.08
V
710 760 mV
0
25 40
2.45 2.52
-1.0 -0.05
5.8 6.0
0.1
-60 -40
0.9 3
30 40
60 75
3V
60 μ mho
2.58 V
μA
V
0.4 V
-28 μ A
7 μA
dB
dB
2010/08/03 Rev. 1.2
Champion Microelectronic Corporation
5

5 Page





CM6800T arduino
http://www.championmicro.com.tw
CM6800T (Turbo-Speed PFC+Green PWM)
EPA/85+ PFC+PWM COMBO CONTROLLER
Design for High Efficient Power Supply
AC power cycling :
90VAC turn on 500ms turn off 100ms at 10%LOAD
Ch2 is AC input voltage which is 100V/div.
Ch3 is PFC stage Mosfet drain current, CH4 is Vo(12V)
Ch3 is PFC stage Mosfet Drain current(zoom In)
90VAC turn on 500ms turn off 100ms at 100%LOAD
Ch2 is AC input voltage which is 100V/div.
Ch3 is PFC stage Mosfet drain current, CH4 is Vo(12V)
Ch3 is PFC stage Mosfet Drain current(zoom In)
90VAC turn on 500ms turn off 10ms at 10%LOAD
Ch2 is AC input voltage which is 100V/div.
Ch3 is PFC stage Mosfet drain current, CH4 is Vo (12V)
Ch3 is PFC stage Mosfet Drain current (zoom In)
2010/08/03 Rev. 1.2
Champion Microelectronic Corporation
11

11 Page







PáginasTotal 27 Páginas
PDF Descargar[ Datasheet CM6800T.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
CM6800LOW START UP CURRENT PFC/PWM CONTROLLER COMBOChampion Microelectronic
Champion Microelectronic
CM6800-32X6Matrix SwitcherPelco
Pelco
CM6800ALOW START-UP CURRENT PFC/PWM CONTROLLER COMBOChampion Microelectronic
Champion Microelectronic
CM6800TEPA/85+ PFC+PWM COMBO CONTROLLERChampion Microelectronic
Champion Microelectronic

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


www.DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar