DataSheet.es    


PDF CLAA220FA01 Data sheet ( Hoja de datos )

Número de pieza CLAA220FA01
Descripción Display Module
Fabricantes CHUNGHWA PICTURE TUBES 
Logotipo CHUNGHWA PICTURE TUBES Logotipo



Hay una vista previa y un enlace de descarga de CLAA220FA01 (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! CLAA220FA01 Hoja de datos, Descripción, Manual

Global LCD Panel Exchange Center
www.panelook.com
Chunghwa Picture Tubes, Ltd.
Technical Specification
To : HUI YING TUNG ELECTRONIC CO., LTD
Date : 2008/08/14
CPT TFT-LCD
CLAA 220FA01
ACCEPTED BY:
APPROVED BY
JOE CHOU
CHECKED BY
Tristan Wang
PREPARED BY
Product Planning
Management
General Division
Prepared by: Design General Division
CHUNGHWA PICTUER TUBES, LTD.
No. 1, Huaying Rd., Sanho Tsun, Lungtan Shiang, Taoyuan, Taiwan, 325, R.O.C.
TEL: +886-3-4805678 FAX: +886-3-4800589
Doc. No: SPEC-CLAA220FA01-HUI YING -Ver1 Issue Date: 2008/08/14
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com

1 page




CLAA220FA01 pdf
Global LCD Panel Exchange Center
www.panelook.com
TitleCLAA220FA01
CHUNGHWA PICTUER TUBES, LTD.
TECHNICAL SPECIFICATION
Technical Specification
Doc. No
Version
Issue Date
B
2008/08/14
2. ABSOLUTE MAXIMUM RATINGS
ITEM
SYMBOL
Power Supply Voltage for LCD VCC
Lamp Voltage
VL
MIN.
0
760
MAX.
6
950
UNIT
V
Vrms
REMARK
Lamp Current
ILO 3.0 8.0 mArms
Lamp Frequency
static electricity
Operation Temperature
Storage Temperature
FL
VESDt
VESDc
Top
Tstg
40
-200
-8000
0
-20
80
200
8000
50
60
kHz
V
V
*5)
*1). 2). 3). 6)
*1). 2). 3)
Delayed Discharge Time
TD
--
1
sec *8)
[Note]
1).The relative temperature and humidity range are as below sketch, 90%RHMax.(Ta40).
2).The maximum wet bulb temperature 39(Ta40) and without dewing.
3).If you use the product in an environment which over the definition of temperature and humidity too
long to effect the result of eye-etching.
4).The life time of the lamp is related to the current of the lamp, so please according to the description
of the “(b) backlight” on page 7.
5).Test Condition: IEC 1000-4-2 VESDt: Contact discharge to input connector; VESDC: Contact
discharge to module
6).If you operate the product in normal temperature range, the center surface of panel should be under
60.
7).When lamp current is out of the absolute maximum range, the life will fall rapidly or shown
unusual sign.
IL min 2mA only for test only, but we can’t guarantee the lifetime and performance.
8).Delay lighting testing needs the volt above start voltage Vrms. Before the procedure tube needs
typical lighting for 1 minute and stay in the temperature 25±2for 24 hours and then testing in the
same condition in dark room.
ISO Datasheet No: T-3010004-008-F
Datasheet Version.: 01
CHUNGHWA PICTUER TUBES, LTD.
Page: 5/30
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com

5 Page





CLAA220FA01 arduino
Global LCD Panel Exchange Center
www.panelook.com
TitleCLAA220FA01
CHUNGHWA PICTUER TUBES, LTD.
TECHNICAL SPECIFICATION
Technical Specification
Doc. No
Version
Issue Date
B
2008/08/14
4. INTERFACE PIN CONNECTION
(1) CN1
Outlet connector: FI-XB30SSRL-HF16 (JAE) (or equivalent)
PIN NO. REMARK
FUNCTION
1 RXO0- minus signal of odd channel 0(LVDS)
2 RXO0+ plus signal of odd channel 0(LVDS)
3 RXO1- minus signal of odd channel 1(LVDS)
4 RXO1+ plus signal of odd channel 1(LVDS)
5 RXO2- minus signal of odd channel 2(LVDS)
6 RXO2+ plus signal of odd channel 2(LVDS)
7 GND GND
8 RXOC- minus signal of odd clock channel (LVDS)
9 RXOC+ plus signal of odd clock channel (LVDS)
10 RXO3- minus signal of odd channel 3(LVDS)
11 RXO3+ plus signal of odd channel 3(LVDS)
12 RXE0- minus signal of even channel 0(LVDS)
13 RXE0+ plus signal of even channel 0(LVDS)
14 GND GND
15 RXE1- minus signal of even channel 1(LVDS)
16 RXE1+ plus signal of even channel 1(LVDS)
17 GND GND
18 RXE2- minus signal of even channel 2(LVDS)
19 RXE2+ plus signal of even channel 2(LVDS)
20 RXEC- minus signal of even clock channel (LVDS)
21 RXEC+ plus signal of even clock channel (LVDS)
22 RXE3- minus signal of even channel 3(LVDS)
23 RXE3+ plus signal of even channel 3(LVDS)
24 GND GND
25 NC NC
26 NC Test pin (Can’t connect to GND)
27 NC NC
28 VCC Power supply input voltage(5.0 V)
29 VCC Power supply input voltage(5.0 V)
30 VCC Power supply input voltage(5.0 V)
1) Keep the NC Pin and don’t connect it to GND or other signals.
2) GND Pin must connect to the ground, don’t let it be a vacant pin.
(2) CN2, 3, 4, 5 (BACKLIGHT)
CN2CN3CN4CN5BHSR-02VS-1 (JST)
<Mating connector: SM02B-BHSS-1-TB (JST)>
ISO Datasheet No: T-3010004-008-F
Datasheet Version.: 01
CHUNGHWA PICTUER TUBES, LTD.
Page: 11/30
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet CLAA220FA01.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
CLAA220FA01Display ModuleCHUNGHWA PICTURE TUBES
CHUNGHWA PICTURE TUBES

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar