|
|
Número de pieza | V420H1-L14 | |
Descripción | TFT LCD Module | |
Fabricantes | CHI MEI | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de V420H1-L14 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
No Preview Available ! Global LCD Panel Exchange Center
www.panelook.com
Issue Date:Oct.30.2008
Model No.: V420H1-L14
Tentative
TFT LCD Tentative Specification
MODEL NO.: V420H1 – L14
Customer: _________________________________
Approved by:_______________________________
Note:
Approved By
Reviewed By
TV Head Division
LY Chen
QA Dept.
Kc_Ko
Product Development Div.
WT Lin
Prepared By
LCD TV Marketing and Product Management Div.
Wang-Yang Li
Trina Lee
1
Version 0.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
1 page Global LCD Panel Exchange Center
www.panelook.com
Issue Date:Oct.30.2008
Model No.: V420H1-L14
Tentative
1. GENERAL DESCRIPTION
1.1 OVERVIEW
V420H1-L14 is a 42” TFT Liquid Crystal Display module with 12-CCFL Backlight unit and 2ch-LVDS interface.
This module supports 1920 x 1080 Full HDTV format and can display 1.07G colors (8-bit+FRC/color). The
inverter module for backlight is built-in.
1.2 FEATURES
Ё High brightness (500 nits)
Ё High contrast ratio (4000:1)
Ё Fast response time (Gray to gray average 6.5 ms)
Ё High color saturation (NTSC 72%)
Ё Full HDTV (1920 x 1080 pixels) resolution, true HDTV format
Ё DE (Data Enable) only mode
Ё LVDS (Low Voltage Differential Signaling) interface
Ё Optimized response time for 60 Hz frame rate
Ё Ultra wide viewing angle : Super MVA technology
Ё RoHS compliance
1.3 APPLICATION
Ё Standard Living Room TVs.
Ё Public Display Application.
Ё Home Theater Application.
Ё MFM Application.
1.4 GENERAL SPECIFICATIONS
Item
Specification
Unit Note
Active Area
Bezel Opening Area
930.24(H) x 523.26 (V) (42.02” diagonal)
mm
(1)
937.24 (H) x 530.26 (V)
mm
Driver Element
a-si TFT active matrix
--
Pixel Number
1920 x R.G.B. x 1080
pixel
-
Pixel Pitch(Sub Pixel)
0.1615 (H) x 0.4845 (V)
mm -
Pixel Arrangement
RGB vertical stripe
--
Display Colors
1.07G
color
-
Display Operation Mode
Transmissive mode / Normally black
--
Surface Treatment
Anti-Glare coating (Haze 11%)
- (2)
Note (1) Please refer to the attached drawings in chapter 9 for more information about the front and back outlines.
Note (2) The spec. of the surface treatment is temporarily for this phase. CMO reserves the rights to change this
feature.
5
Version 0.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
5 Page Global LCD Panel Exchange Center
www.panelook.com
Issue Date:Oct.30.2008
Model No.: V420H1-L14
Tentative
3.2 BACKLIGHT CONNECTOR PIN CONFIGURATION
3.2.1 LAMP SPECIFICATION
(Ta = 25 ± 2 ºC)
Parameter
Symbol
Min.
Value
Typ.
Lamp Input Voltage
VL -
1212
Lamp Current
IL 9.7
10.2
-
Lamp Turn On Voltage
VS
-
-
-
Operating Frequency
FL 35
-
Lamp Life Time
LBL 50,000
60,000
Max.
-
10.7
(1865)
(1510)
70
-
Unit Note
VRMS -
mARMS (1)
VRMS Ta = 0 ºC
VRMS Ta = 25 ºC
KHz
Hrs (2)
3.2.2 ELECTRICAL SPECIFICATION
(Ta = 25 ± 2 ºC)
Parameter
Symbol
Min.
Value
Typ.
Max.
Unit
Note
Power Consumption
PBL -
TBD
- W (5), IL = TBD mA
Power Supply Voltage
VBL 22.8
24.0
25.2 VDC
Power Supply Current IBL - TBD - A Non Dimming
Input Ripple Noise
--
- 912 mVP-P VBL=22.8V
Oscillating Frequency
FW 39.5
42.5
45.5 kHz
Dimming Frequency
FB 150 160 170 Hz
Minimum Duty Ratio
DMIN
10
20
- % (6)
Note (1) Lamp current is measured by utilizing AC current probe and its value is average by measuring master
and slave board.
Note (2) The lamp starting voltage VS should be applied to the lamp for more than 1 second after startup.
Otherwise the lamp may not be turned on.
Note (3) The lamp frequency may produce interference with horizontal synchronous frequency of the display input
signals, and it may result in line flow on the display. In order to avoid interference, the lamp frequency
should be detached from the horizontal synchronous frequency and itó harmonics as far as possible.
Note (4) The life time of a lamp is defined as when the brightness is larger than 50% of its original value and the
effective discharge length is longer than 80% of its original length (Effective discharge length is defined
as an area that has equal to or more than 70% brightness compared to the brightness at the center point
11
Version 0.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
11 Page |
Páginas | Total 30 Páginas | |
PDF Descargar | [ Datasheet V420H1-L14.PDF ] |
Número de pieza | Descripción | Fabricantes |
V420H1-L11 | TFT LCD Module | Chi Mei |
V420H1-L12 | TFT LCD Module | Chi Mei |
V420H1-L13 | TFT LCD Module | Chi Mei |
V420H1-L14 | TFT LCD Module | CHI MEI |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |