|
|
PDF M216H1-L07 Data sheet ( Hoja de datos )
| Número de pieza | M216H1-L07 | |
| Descripción | TFT LCD Module | |
| Fabricantes | CHI MEI | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de M216H1-L07 (archivo pdf) en la parte inferior de esta página. Total 26 Páginas | ||
|
No Preview Available !
Global LCD Panel Exchange Center
www.panelook.com
Issued Date: Jul,14,2009
Model No.: M216H1-L07
Preliminary
TFT LCD Preliminary Specification
MODEL NO.: M216H1-L07
Customer :
Approved by :
Note :
1 / 28
Version 1.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
1 page  
Global LCD Panel Exchange Center
www.panelook.com
Issued Date: Jul,14,2009
Model No.: M216H1-L07
Preliminary
1. GENERAL DESCRIPTION
1.1 OVERVIEW
The M216H1-L07 model is a 21.6 inch wide TFT-LCD module with a 2-CCFL Backlight Unit and a
30-pin 2ch-LVDS interface. This module supports 1920 x 1080 Full HD (16:9 wide screen) mode and
displays up to 16.7 millions colors. The inverter module for the Backlight Unit is not built in.
1.2 FEATURES
- Super wide viewing angle
- High contrast ratio
- Fast response time
- High color saturation (EBU Like Specifications)
- FULL HD(1920 x 1080 pixels) resolution
- DE (Data Enable) only mode
- LVDS (Low Voltage Differential Signaling) interface
- RoHS compliance.
1.3 APPLICATION
- Workstation & desktop monitor
- Display terminals for AV application
1.4 GENERAL SPECIFICATI0NS
Item
Diagonal size
Active Area
Bezel Opening Area
Driver Element
Pixel Number
Pixel Pitch
Pixel Arrangement
Display Colors
Transmissive Mode
Surface Treatment
Module Power Consumption
Specification
547.863
477.504 x 268.596
481.5 (H) x 272.6 (V)
a-Si TFT active matrix
1920 x R.G.B. x 1080
0.248(H) x 0.248(V)
RGB vertical stripe
16.7 millions
Normally White
Hard coating (3H), AG (Haze 25%)
19.2
Unit
mm
mm
mm
-
pixel
mm
-
color
-
-
Watt
Note
(1)
-
-
-
-
-
-
-
(2)
1.5 MECHANICAL SPECIFICATIONS
Item
Horizontal(H)
Module Size Vertical(V)
Depth(D)
Weight
I/F connector mounting
position
Min. Typ. Max.
499 499.5 500
292.1
292.6
293.1
12.5 13 13.5
-
1980
2030
The mounting inclination of the connector makes
the screen center within ±0.5 mm as the horizontal.
Unit
mm
mm
mm
g
Note
(1)
Note (1) Please refer to the attached drawings for more information of front and back outline dimensions.
Note (2) Please refer to sec. 3.1 & 3.2 in this document for more information of power consumption.
5 / 28
Version 1.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
5 Page 
Global LCD Panel Exchange Center
www.panelook.com
Issued Date: Jul,14,2009
Model No.: M216H1-L07
Preliminary
for the lamp. All the parameters of an inverter should be carefully designed to avoid producing too
much current leakage from high voltage output of the inverter. When designing or ordering the
inverter please make sure that a poor lighting caused by the mismatch of the Backlight and the
inverter (miss-lighting, flicker, etc.) never occurs. If the above situation is confirmed, the module
should be operated in the same manners when it is installed in your instrument.
The output of the inverter must have symmetrical (negative and positive) voltage waveform and
symmetrical current waveform.(Unsymmetrical ratio is less than 10%) Please do not use the inverter
which has unsymmetrical voltage and unsymmetrical current and spike wave. Lamp frequency may
produce interface with horizontal synchronous frequency and as a result this may cause beat on the
display. Therefore lamp frequency shall be as away possible from the horizontal synchronous
frequency and from its harmonics in order to prevent interference.
Requirements for a system inverter design, which is intended to have a better display performance, a
better power efficiency and a more reliable lamp. It shall help increase the lamp lifetime and reduce its
leakage current.
a. The asymmetry rate of the inverter waveform should be 10% below;
b. The distortion rate of the waveform should be within Ѕ2 ± 10%;
c. The ideal sine wave form shall be symmetric in positive and negative polarities.
* Asymmetry rate:
I p | I p – I –p | / Irms * 100%
I -p * Distortion rate
I p (or I –p) / Irms
11 / 28
Version 1.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com
11 Page | ||
| Páginas | Total 26 Páginas | |
| PDF Descargar | [ Datasheet M216H1-L07.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| M216H1-L01 | TFT LCD Module |  Chi Mei |
| M216H1-L02 | TFT LCD Module | CHI MEI |
| M216H1-L03 | TFT LCD Module | Chi Mei |
| M216H1-L05 | TFT LCD Module | CHI MEI |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |