DataSheet.es    


PDF ZXXS236-L01 Data sheet ( Hoja de datos )

Número de pieza ZXXS236-L01
Descripción TFT LCD
Fabricantes ZHIXUAN 
Logotipo ZHIXUAN Logotipo



Hay una vista previa y un enlace de descarga de ZXXS236-L01 (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! ZXXS236-L01 Hoja de datos, Descripción, Manual

Global LCD Panel Exchange Center
www.panelook.com
Doc No.: 400028602
Issued Date: 14. Aug, 2009
Model No.: ZXXS236-L01
Approval
TFT LCD Approval Specification
MODEL NO.:ZXXS236-L01
Customer:
Approved by:
Note:
TPV
1 / 30
Version 3.2
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com

1 page




ZXXS236-L01 pdf
Global LCD Panel Exchange Center
www.panelook.com
Doc No.: 400028602
Issued Date: 14. Aug, 2009
Model No.: ZXXS236-L01
Approval
1. GENERAL DESCRIPTION
1.1 OVERVIEW
ZXXS236-L01TFT Liquid Crystal Display module with 4 CCFL Backlight unit and 30 pins
2ch-LVDS interface. This module supports 1920 x 1080 Full HD mode and can display up to 16.7M colors.
The inverter module for Backlight is not built in.
1.2 FEATURES
- Extra-wide viewing angle.
- High contrast ratio.
- Fast response time.
- High color saturation.
- Full HD (1920 x 1080 pixels) resolution.
- DE (Data Enable) only mode.
- LVDS (Low Voltage Differential Signaling) interface.
- RoHS compliance.
- TCO03 compliance
1.3 APPLICATION
- TFT LCD Monitor
1.4 GENERAL SPECIFICATI0NS
Item
Active Area
Bezel Opening Area
Driver Element
Pixel Number
Pixel Pitch
Pixel Arrangement
Display Colors
Transmissive Mode
Surface Treatment
Module Power Consumption
Specification
521.28(H) x 293.22(V) (23.547” real diagonal)
525.22 (H) x 297.22 (V)
a-Si TFT active matrix
1920 x R.G.B. x 1080
0.2715 (H) x 0.2715 (V)
RGB vertical stripe
16.7M
Normally White
AG type, 3H hard coating, Haze 25
45
Unit
mm
mm
-
pixel
mm
-
color
-
-
Watt
Note
(1)
-
-
-
-
-
-
-
(2)
1.5 MECHANICAL SPECIFICATIONS
Item
Horizontal(H)
Module Size Vertical(V)
Depth(D)
Weight
Min.
544.3
320.0
18.2
-
Typ.
544.8
320.5
18.7
2850
Max.
545.3
321.0
19.2
2900
Unit Note
mm
mm (1)
mm
g-
Note (1) Please refer to the attached drawings for more information of front and back outline dimensions.
Note (2) Please refer to sec.3.1 & 3.2 for more information of power consumption
5 / 30
Version 3.2
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com

5 Page





ZXXS236-L01 arduino
Global LCD Panel Exchange Center
www.panelook.com
Doc No.: 400028602
Issued Date: 14. Aug, 2009
Model No.: ZXXS236-L01
Approval
inverter must have specifications for the modularized lamp. The performance of the Backlight,
such as lifetime or brightness, is greatly influenced by the characteristics of the DC-AC inverter for
the lamp. All the parameters of an inverter should be carefully designed to avoid producing too
much current leakage from high voltage output of the inverter. When designing or ordering the
inverter please make sure that a poor lighting caused by the mismatch of the Backlight and the
inverter (miss-lighting, flicker, etc.) never occurs. If the above situation is confirmed, the module
should be operated in the same manners when it is installed in your instrument.
The output of the inverter must have symmetrical (negative and positive) voltage waveform and
symmetrical current waveform.(Unsymmetrical ratio is less than 10%) Please do not use the inverter
which has unsymmetrical voltage and unsymmetrical current and spike wave. Lamp frequency may
produce interface with horizontal synchronous frequency and as a result this may cause beat on the
display. Therefore lamp frequency shall be as away possible from the horizontal synchronous
frequency and from its harmonics in order to prevent interference.
Requirements for a system inverter design, which is intended to have a better display performance, a
better power efficiency and a more reliable lamp. It shall help increase the lamp lifetime and reduce its
leakage current.
a. The asymmetry rate of the inverter waveform should be 10% below;
b. The distortion rate of the waveform should be within Ѕ2 ± 10%;
c. The ideal sine wave form shall be symmetric in positive and negative polarities
Ip
I -p
* Asymmetry rate:
| I p – I –p | / Irms * 100%
* Distortion rate
I p (or I –p) / Irms
11 / 30
Version 3.2
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory! www.panelook.com

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet ZXXS236-L01.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
ZXXS236-L01TFT LCDZHIXUAN
ZHIXUAN

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar