DataSheet.es    


PDF 60LN5750 Data sheet ( Hoja de datos )

Número de pieza 60LN5750
Descripción LED TV MANUAL
Fabricantes LG 
Logotipo LG Logotipo



Hay una vista previa y un enlace de descarga de 60LN5750 (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! 60LN5750 Hoja de datos, Descripción, Manual

Life's Good
iii __i _(i_
i{iii
LED TV
LG LED TV applies LCD screen with LED backlights.
Please read this manual carefully before
your set and retain it for future reference.
operating
32LN5700
39LN5700
42LN5700
47LN5700
50LN5700
55LN5700
60LN5700
32LN570B
47LN5710
50LN5710
55LN5710
60LN5710
47LN5750
50LN5750
55LN5750
60LN5750
P/NO : MFL67690902
(1303_REV01)
47LN5790
55LN5790
www.lg.com

1 page




60LN5750 pdf
IMPORTANT SAFETY INSTRUCTIONS
.5
Dot Defect
The Plasma or LCD panel is a high technology
product with resolution of two million to six minion
pixets. In a very few cases, you could see fine dots
on the screen while you're viewing the TV. Those
dots are deactivated pixels and do not affect the
performance and reliability of the TV.
Generated Sound
"Cracking" noise: A cracking noise that occurs
when watching or turning off the TV is generated by
plastic thermal contraction due to temperature and
humidity. This noise is common for products where
thermal deformation is required.
Electrical circuit humming/panel buzzing: A low level
noise is generated from a high-speed switching
circuit, which supplies a large amount of current
to operate a product. It varies depending on the
product.
This generated sound does not affect the
performance and reliability of the product.
Take care not to touch the ventilation openings.
When watching the TV for a long period, the
ventilation openings may become hot. This does
not affect the performance of the product or cause
defects in the product.
If the TV feels cold to the touch, there may be a
small "flicker" when it is turned on. This is normal,
there is nothing wrong with TV. Some minute dot
defects may be visible on the screen, appearing as
tiny red, green, or blue spots. However, they have
no adverse effect on the TV's performance. Avoid
touching the LCD screen or holding your finger(s)
against it for long periods of time. Doing so may
produce some temporary distortion effects on the
screen.
For USA and Canada
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment and the receiver.
- Connect the equipment to an outlet on a circuit
different from that to which the receiver is
connected.
- Consult the dealer or an experienced radioFV
technician for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference
and (2) this device must accept any interference
received, including interference that may cause
undesired operation of the device.
Any changes or modifications in construction of
this device which are not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
If a fixed image displays on the TV screen for a long
period of time, it wilt be imprinted and become a
permanent disfigurement on the screen. This is
"image burn" or "burn-in" and not covered by the
warranty.
If the aspect ratio of the TV is set to 4:3 for a
long period of time, image burn may occur on the
letterboxed area of the screen.
Avoid displaying a fixed image on the TV screen for
a long period of time (2 or more hours for LCD, 1
or more hours for the Plasma TV) to prevent image
burn.
This reminder is provided to calt the CATV system
installer's attention to Article 820-40 of the National
Electric Code (U.S.A.). The code provides guidelines
for proper grounding and, in particular, specifies
that the cable ground shall be connected to the
grounding system of the building, as close to the
point of the cable entry as practical.

5 Page





60LN5750 arduino
Parts and Buttons
,-Screen
ASSEMBLING AND PREPARING
11
Speakers
C Power Indicafor
Remote
confrol
Sensor and
Infelligenf
Sensor 1
Buttons
/_
+/_=,
(A /V)
(+ /_)
(OK ®)
S (SETTINGS)
(INPUT-E])
(_ ((b / I)
Scrolls through the saved channels.
Adjusts the volume level.
Description
Selects the highlighted menu option or confirms an input.
Accesses the main menus, or saves your input and exits the menus.
Changes the input source.
Turns the power on or off.
1 Intelligent sensor - Adjusts the image quality and brightness based on the surrounding environment.

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet 60LN5750.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
60LN5750LED TV MANUALLG
LG

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar