|
|
Número de pieza | PC2SD11NWPAF | |
Descripción | Non-zero cross type DIP 6pin Phototriac Coupler | |
Fabricantes | Sharp | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de PC2SD11NWPAF (archivo pdf) en la parte inferior de esta página. Total 15 Páginas | ||
No Preview Available ! PC2SD11NTZ
Series
∗VDRM : 600V type is also available.
(PC3SD11NTZ Series)
PC2SD11NTZ Series
VDRM : 400V
Non-zero cross type
DIP 6pin
Phototriac Coupler for triggering
■ Description
PC2SD11NTZ Series Phototriac Coupler include an
infrared emitting diode (IRED) optically coupled to an
output Phototriac.
These devices feature full wave control and are
ideal isolated drivers for medium to high current Triacs.
DIP package provides 5.0kV isolation from input to
output with superior commutative noise immunity.
■ Features
1. High repetitive peak off-state voltage (VDRM : 400V)
2. Non-zero crossing functionality
3. 6 pin DIP package
4. Superior noise immunity (dV/dt : MIN. 1 000V/µs)
5. Lead-free components are also available (see Model
Line-up section in this datasheet)
6. Double transfer mold construction (Ideal for Flow
Soldering)
7. High isolation voltage between input and output
(Viso(rms) : 5.0kV)
■ Agency approvals/Compliance
1. Recognized by UL1577 (Double protection isolation),
file No. E64380 (as model No. 2SD11)
2. Approved by CSA, file No. CA95323 (as model No.
2SD11)
3. Package resin : UL flammability grade (94V-0)
■ Applications
1. Triggering for Triacs used to switch on and off
devices which require AC Loads.
For example heaters, fans, motors, solenoids, and
valves.
2. Triggering for Triacs used for implementing phase
control in applications such as lighting control and
temperature control (HVAC).
3. AC line control in power supply applications.
Notice The content of data sheet is subject to change without prior notice.
In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP
devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device.
Sheet No.: D2-A07401EN
1 Date Mar. 31. 2004
© SHARP Corporation
1 page PC2SD11NTZ Series
■ Model Line-up (1) (Lead-free components)
Lead Form
Shipping Package
Model No.
Through-Hole
PC2SD11NTZAF
SMT Gullwing
Sleeve
50pcs/sleeve
PC2SD11NXZAF
Wide Through-Hole
PC2SD11NVZAF
Rank mark
A
IFT[mA]
(VD=6V,
RL=100Ω)
MAX.10
Lead Form
Shipping Package
Model No.
Wide SMT Gullwing
Sleeve
50pcs/sleeve
PC2SD11NWZAF
SMT Gullwing
Wide SMT Gullwing
Taping
1 000pcs/reel
PC2SD11NXPAF
PC2SD11NWPAF
Rank mark
A
IFT[mA]
(VD=6V,
RL=100Ω)
MAX.10
■ Model Line-up (2) (Lead solder plating components)
Lead Form
Shipping Package
Model No.
Through-Hole
PC2SD11NTZA
SMT Gullwing
Sleeve
50pcs/sleeve
PC2SD11NXZA
Wide Through-Hole
PC2SD11NVZA
Rank mark
A
IFT[mA]
(VD=6V,
RL=100Ω)
MAX.10
Lead Form
Shipping Package
Model No.
Wide SMT Gullwing
Sleeve
50pcs/sleeve
PC2SD11NWZA
SMT Gullwing
Wide SMT Gullwing
Taping
1 000pcs/reel
PC2SD11NXPA
PC2SD11NWPA
Rank mark
A
IFT[mA]
(VD=6V,
RL=100Ω)
MAX.10
Please contact a local SHARP sales representative to inquire about production status.
Sheet No.: D2-A07401EN
5
5 Page PC2SD11NTZ Series
● Cleaning instructions
Solvent cleaning :
Solvent temperature should be 45˚C or below. Immersion time should be 3minutes or less.
Ultrasonic cleaning :
The impact on the device varies depending on the size of the cleaning bath, ultrasonic output, cleaning time,
size of PCB and mounting method of the device.
Therefore, please make sure the device withstands the ultrasonic cleaning in actual conditions in advance of
mass production.
Recommended solvent materials :
Ethyl alcohol, Methyl alcohol and Isopropyl alcohol.
In case the other type of solvent materials are intended to be used, please make sure they work fine in
actual using conditions since some materials may erode the packaging resin.
● Presence of ODC
This product shall not contain the following materials.
And they are not used in the production process for this device.
Regulation substances : CFCs, Halon, Carbon tetrachloride, 1.1.1-Trichloroethane (Methylchloroform)
Specific brominated flame retardants such as the PBBOs and PBBs are not used in this product at all.
Sheet No.: D2-A07401EN
11
11 Page |
Páginas | Total 15 Páginas | |
PDF Descargar | [ Datasheet PC2SD11NWPAF.PDF ] |
Número de pieza | Descripción | Fabricantes |
PC2SD11NWPA | Non-zero cross type DIP 6pin Phototriac Coupler | Sharp |
PC2SD11NWPAF | Non-zero cross type DIP 6pin Phototriac Coupler | Sharp |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |