DataSheet.es    


PDF NL6448BC26-09 Data sheet ( Hoja de datos )

Número de pieza NL6448BC26-09
Descripción TFT COLOR LCD MODULE
Fabricantes NEC 
Logotipo NEC Logotipo



Hay una vista previa y un enlace de descarga de NL6448BC26-09 (archivo pdf) en la parte inferior de esta página.


Total 29 Páginas

No Preview Available ! NL6448BC26-09 Hoja de datos, Descripción, Manual

TFT COLOR LCD MODULE
NL6448BC26-09
21 cm (8.4 Type)
VGA
DATA SHEET
DOD-PP-0199 (4th edition)
This DATA SHEET is updated document from
DOD-PP-0141(3).
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.
Document Number: DOD-PP-0199 (4th edition)
Published date: March 2007 CP(N)
1 © NEC LCD Technologies, Ltd.
2006-2007, All rights reserved.

1 page




NL6448BC26-09 pdf
NL6448BC26-09
2. GENERAL SPECIFICATIONS
Display area
170.88 (H) × 128.16 (V) mm
Diagonal size of display 21cm (8.4inches)
Drive system
a-Si TFT active matrix
Display color
262,144 colors
Pixel
640 (H) × 480 (V) pixels
Pixel arrangement
RGB (Red dot, Green dot, Blue dot) vertical stripe
Dot pitch
0.089 (H) × 0.267 (V) mm
Pixel pitch
0.267 (H) × 0.267 (V) mm
Module size
200.0 (W) × 152.0 (H) × 10.5 (D) mm (typ.)
Weight
330g (typ.)
Contrast ratio
Viewing angle
Designed viewing direction
Polarizer surface
600:1 (typ.)
At the contrast ratio 10:1
Horizontal: Right side 80° (typ.), Left side 80° (typ.)
Vertical: Up side 80° (typ.), Down side 60° (typ.)
At DPS= Low or open: Normal scan
Viewing direction without image reversal: up side (12 o'clock)
Viewing direction with contrast peak: down side (6 o'clock)
Viewing angle with optimum grayscale (γ=2.2): normal axis
(perpendicular)
Clear
Polarizer pencil-hardness
Color gamut
Response time
Luminance
Signal system
Power supply voltage
3H (min.) [by JIS K5400]
At LCD panel center
40% (typ.) [against NTSC color space]
Ton+Toff (10% ←→ 90%)
25ms (typ.)
At IBL= 5.0mArms / lamp
450cd/m2 (typ.)
6-bit digital signals for data of RGB colors,
Dot clock (CLK), Data enable (DE),
Horizontal synchronous signal (Hsync),
Vertical synchronous signal (Vsync)
LCD panel signal processing board: 3.3V or 5.0V
Edge light type: 2 cold cathode fluorescent lamps
Backlight
Replaceable part
Lamp holder set: Type No. 84LHS06
Power consumption
Recommended inverter (Option)
Inverter: Type No. 84PW031, 84PW041
At IBL= 5.0mArms / lamp, Checkered flag pattern
5.3 W (typ., Power dissipation of the inverter is not included.)
DATA SHEET DOD-PP-0199 (4th edition)
5

5 Page





NL6448BC26-09 arduino
4.4 POWER SUPPLY VOLTAGE SEQUENCE
4.4.1 LCD panel signal processing board
VCC
Note1
3.0V or 4.75V
0V
ON
10μs Tr < 30ms
Display signals
Function signal
Note2
0V
0ms < t < 35ms
VALID period
NL6448BC26-09
OFF ON
Toff > 50ms
0ms < t < 35ms
Note1: In terms of voltage variation (voltage drop) while VCC rising edge is below 3.0V in "VCC
= 3.3V" or 4.75V in "VCC = 5.0V", a protection circuit may work, and then this product
may not work.
Note2: Display signals (CLK, Hsync, Vsync, DE, DATA (R0 to R5, G0 to G5, B0 to B5)) and
function signal (DPS) must be Low or High-impedance, exclude the VALID period (See
above sequence diagram), in order to avoid that internal circuits is damaged.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. VCC should be cut
when the display and function signals are stopped.
4.4.2 Inverter (Option)
Display signals
Function signals
Note1
VDDB
Note2
VALID period
Note1: These are the display and function signals for LCD panel signal processing board.
Note2: The backlight should be turned on within the valid period of display and function signals,
in order to avoid unstable data display.
DATA SHEET DOD-PP-0199 (4th edition)
11

11 Page







PáginasTotal 29 Páginas
PDF Descargar[ Datasheet NL6448BC26-09.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
NL6448BC26-01LCD ModuleNEC
NEC
NL6448BC26-03LCD ModuleNEC
NEC
NL6448BC26-08DDisplay ModuleNEC
NEC
NL6448BC26-09TFT COLOR LCD MODULENEC
NEC

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar