DataSheet.es    


PDF V470H1-L03 Data sheet ( Hoja de datos )

Número de pieza V470H1-L03
Descripción TFT LCD
Fabricantes CHI MEI 
Logotipo CHI MEI Logotipo



Hay una vista previa y un enlace de descarga de V470H1-L03 (archivo pdf) en la parte inferior de esta página.


Total 32 Páginas

No Preview Available ! V470H1-L03 Hoja de datos, Descripción, Manual

Issue Date: Nov.14.2006
Model No.: V470H1-L03
Tentative
TFT LCD Tentative Specification
MODEL NO.: V470H1 – L03
AVP
QRA Dept.
Approval
陳永一
LCD TV Head Division
郭振隆
PDDI
Approval
蔡永裕
TVHD/PDD
PDDII
Approval
PDDIII
Approval
藍文錦
姚正宏
PDDIV
Approval
陳建宏
LCD TV Marketing and Project Management Dept.
Product Manager
吳盈潔
1
The information described in this technical specification is tentative and it is possible to be changed without prior
notice. Please contact CMO ’s representative while your product design is based on this specification. Version 0.0

1 page




V470H1-L03 pdf
Issue Date: Nov.14.2006
Model No.: V470H1-L03
Tentative
2. ABSOLUTE MAXIMUM RATINGS
2.1 ABSOLUTE RATINGS OF ENVIRONMENT
Item
Storage Temperature
Operating Ambient Temperature
Shock (Non-Operating)
Vibration (Non-Operating)
Symbol
TST
TOP
SNOP
X, Y axis
Z axis
VNOP
Value
Min. Max.
-20 +60
0 45
- 50
- 35
- 1.0
Note (1) Temperature and relative humidity range is shown in the figure below.
Unit Note
ºC (1)
ºC (1), (2)
G (3), (5)
G (3), (5)
G (4), (5)
(a) 90 %RH Max. (Ta 40 ºC).
(b) Wet-bulb temperature should be 39 ºC Max. (Ta > 40 ºC).
(c) No condensation.
Note (2) The maximum operating temperature is based on the test condition that the surface temperature of
display area is less than or equal to 65 ºC with LCD module alone in a temperature controlled chamber.
Thermal management should be considered in your product design to prevent the surface temperature
of display area from being over 65 ºC. The range of operating temperature may degrade in case of
improper thermal management in your product design.
Note (3) 11 ms, half sine wave, 1 time for ± X, ± Y, and ± Z.
Note (4) 10 ~ 200 Hz, 10 min, 1 time each X, Y, Z.
Note (5) At testing Vibration and Shock, the fixture in holding the module has to be hard and rigid enough so that
the module would not be twisted or bent by the fixture. The module would not be twisted or bent by the
fixture.
10
5
The information described in this technical specification is tentative and it is possible to be changed without prior
notice. Please contact CMO ’s representative while your product design is based on this specification. Version 0.0

5 Page





V470H1-L03 arduino
Issue Date: Nov.14.2006
Model No.: V470H1-L03
Tentative
3.2.3 INVERTER INTERTFACE CHARACTERISTICS
Parameter
Symbol
Test
Condition
Min.
Value
Typ. Max.
Unit
Note
On/Off Control Voltage
ON
OFF
VBLON
Status Signal
ERR
2.0 5.0 V
0 0.8 V
----
Normal: Open
collector
Abnormal: GND
(Note 4)
Internal PWM Control
Voltage
External PWM Control
Voltage
MAX
MIN
VIPWM
VSEL = L
2.85
3.0
0
3.15
HI
LO
VEPWM VSEL = H
2.0
0
5.0
0.8
V maximum duty ratio
V minimum duty ratio
V duty on
V duty off
Control Signal Rising Time
Tr - - - 100 ms
Control Signal Falling Time
Tf - - - 100 ms
PWM Signal Rising Time
TPW MR
- - 50 us
PWM Signal Falling Time
TPW MF
- - 50 us
Input impedance
RIN
1 - - MΩ
BLON Delay Time
Ton
1 - - ms
BLON Off Time
Toff
1 - - ms
Note (2) The power sequence and control signal timing are shown in the following figure.
Note (3) The power sequence and control signal timing must follow the figure below. For a certain reason,
the inverter has a possibility to be damaged with wrong power sequence and control signal
timing.
Note (4) When inverter protective function is triggered, ERR will pull low
11
The information described in this technical specification is tentative and it is possible to be changed without prior
notice. Please contact CMO ’s representative while your product design is based on this specification. Version 0.0

11 Page







PáginasTotal 32 Páginas
PDF Descargar[ Datasheet V470H1-L03.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
V470H1-L01TFT LCD ModuleCMI MEI
CMI MEI
V470H1-L02TFT LCD ModuleCMI MEI
CMI MEI
V470H1-L03TFT LCDCHI MEI
CHI MEI
V470H1-L05TFT LCD ModuleCMI MEI
CMI MEI

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar