DataSheet.es    


PDF DVP3898 Data sheet ( Hoja de datos )

Número de pieza DVP3898
Descripción DVD Player Service Manual
Fabricantes Philips 
Logotipo Philips Logotipo



Hay una vista previa y un enlace de descarga de DVP3898 (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! DVP3898 Hoja de datos, Descripción, Manual

DVD Player
DVP3800/55/93/96/98/79
Service
Service Manual
TABLE OF CONTENTS
Page
. Technical Specifications…………....………………………..............1-2
. Safety Instruction, Warning & Notes….……………………....….....1-3
. PCB Location,Version variations..............................................1-10
. Mechanical and Dismantling Instructions…………........................2
. Software Upgrades .............................................................3
. Trouble Shooting Chart………………………………………………. 4
. Wiring Diagram………………………………………..………..….….5
. Electrical Diagrams and Print-layouts........................................................6
. Set Mechanical Exploded view ........................................................6
. Revision List.................................................................................. 7
© Copyright 2011 Philips Consumer Electronics B.V. Eindhoven, The Netherlands
All rights reserved. No part of this publication may be reproduced, stored in aretrieval system or
transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise
without the prior permission of Philips.
Published by WL - 1108 BU AVM Printed in The Netherlands Subject to modification
Version 1.2
CLASS 1
LASER PRODUCT
GB 3142 785 35862
PHILIPS

1 page




DVP3898 pdf
1-5
Specifications For DVP3800/96
Note
Speccations are subject to change without
notice
DVD region code Countries
• User Manual
/DVHUVSHFLÀFDWLRQ
• Type: Semiconductor laser InGaAIP
(DVD), AIGaAs (CD)
Asia PaciÀc, Taiwan, Korea
• Wave length: 658 nm (DVD), 790 nm (CD)
• Output Power: 7.0 mW (DVD),
10.0 mW (VCD/CD)
Playable media
Disc
• DVD, DVD-Video, VCD, SVCD, Audio CD
• DVD+R/+RW, DVD-R/-RW, DVD+R/-R DL
(Dual Layer), CD-R/-RW (Maximum number
Beam divergence: 60 degrees
of Àles: 648)
File
• Video: .avi, .divx, .mp4, .xvid
• Audio: .mp3, .wma
• Picture: .jpg, .jpeg
Video
• Signal system: PAL, NTSC
• Composite video output: 1 Vp-p (75 ohm)
• Component video output: 0.7 Vp-p (75 ohm)
Audio
• 2-channel analog output
• Audio Front L&R : 2 Vrms (47k Ohm)
• Digital output: 0.5 Vp-p (75 ohm)
• Coaxial
• Sampling frequency:
• MP3: 8 kHz, 11 kHz, 12 kHz, 16 kHz, 22 kHz,
24 kHz, 32 kHz, 44.1 kHz, 48 kHz
• WMA: 44.1 kHz, 48 kHz
• Constant bit rate:
• MP3: 8 kbps - 320 kbps
• WMA: 64 kbps - 192 kbps
Main unit
• Dimensions (W x H x D): 360 x 42 x 209 (mm)
• Net Weight: 1.31 kg
Power
• Power supply rating: 110–240 V~, 50/60 Hz
• Power consumption: < 8 W
• Power consumption in standby mode: < 0.3 W
Accessories supplied
• Remote control and one battery

5 Page





DVP3898 arduino
1-11
Notes
Lead-Free requirement for service
INDENTIFICATION:
Regardless of special logo (not always indicated)
One must treat all sets from 1.1.2005 onwards, according
next rules.
Important note: In fact also products a little older can also
be treated in this way as long as you avoid mixing
solder-alloys (leaded/ lead-free). So best to always use
SAC305 and the higher temperatures belong to this.
Due to lead-free technology some rules have to be
respected by the workshop during a repair:
x Use only lead-free solder alloy Philips SAC305 with
order code 0622 149 00106. If lead-free solder-paste is
required, please contact the manufacturer of your
solder-equipment. In general use of solder-paste within
workshops should be avoided because paste is not easy
to store and to handle.
x Use only adequate solder tools applicable for lead-free
solder alloy. The solder tool must be able
o To reach at least a solder-temperature of 400°C,
o To stabilize the adjusted temperature at the
solder-tip
o To exchange solder-tips for different applications.
x Adjust your solder tool so that a temperature around
360°C – 380°C is reached and stabilized at the solder
joint. Heating-time of the solder-joint should not exceed
~ 4 sec. Avoid temperatures above 400°C otherwise
wear-out of tips will rise drastically and flux-fluid will be
destroyed. To avoid wear-out of tips switch off un-used
equipment, or reduce heat.
x Mix of lead-free solder alloy / parts with leaded solder
alloy / parts is possible but PHILIPS recommends
strongly to avoid mixed
solder alloy types (leaded and lead-free). If one cannot
avoid, clean carefully the
solder-joint from old solder alloy and re-solder with new
solder alloy (SAC305).
x Use only original spare-parts listed in the
Service-Manuals. Not listed standard-material
(commodities) has to be purchased at external
companies.
x Special information for BGA-ICs:
- always use the 12nc-recognizable soldering
temperature profile of the specific BGA (for
de-soldering always use highest lead-free
temperature profile, in case of doubt)
- lead free BGA-ICs will be delivered in so-called
‘dry-packaging’ (sealed pack including a silica gel
pack) to protect the IC against moisture. After
opening, dependent of MSL-level seen on
indicator-label in the bag, the BGA-IC possibly
still has to be baked dry. This will be
communicated via AYS-website.
Do not re-use BGAs at all.
x For sets produced before 1.1.2005, containing
leaded soldering-tin and components, all needed
spare-parts will be available till the end of the
service-period. For repair of such sets nothing
changes.
x On our website:
www.atyourservice.ce.Philips.com
You find more information to:
BGA-de-/soldering (+ baking instructions)
Heating-profiles of BGAs and other ICs used in
Philips-sets
You will find this and more technical information
within the “magazine”, chapter “workshop news”.
For additional questions please contact your local
repair-helpdesk.

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet DVP3898.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
DVP3893DVD Player Service ManualPhilips
Philips
DVP3896DVD Player Service ManualPhilips
Philips
DVP3898DVD Player Service ManualPhilips
Philips

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar