DataSheet.es    


PDF MAPS-010143 Data sheet ( Hoja de datos )

Número de pieza MAPS-010143
Descripción Digital Phase Shifter
Fabricantes MA-COM Technology 
Logotipo MA-COM Technology Logotipo



Hay una vista previa y un enlace de descarga de MAPS-010143 (archivo pdf) en la parte inferior de esta página.


Total 6 Páginas

No Preview Available ! MAPS-010143 Hoja de datos, Descripción, Manual

MAPS-010143
Digital Phase Shifter
4-Bit, 1.4 - 2.4 GHz
Features
 4 Bit Digital Phase Shifter
 360° Coverage with LSB = 22.5°
 Integral CMOS Driver
 Serial or Parallel Control
 Low DC Power Consumption
 Minimal Attenuation Variation over Phase Shift
Range
 50 Impedance
 EAR99
 Lead-Free 4 mm 24-Lead PQFN Package
 RoHS* Compliant
Functional Schematic
P/S
Rev. V4
Description
The MAPS-010143 is a GaAs pHEMT 4-bit digital
phase shifter with an integral CMOS driver in a
4 mm PQFN plastic surface mount package. Step
size is 22.5° providing phase shift from 0° to 360° in
22.5° steps. This design has been optimized to
minimize variation in attenuation over the phase shift
range.
The MAPS-010143 is ideally suited for use where
high phase accuracy with minimum loss variation
over the phase shift range are required. The 4 mm
PQFN package provides a smaller footprint than is
typically available for a digital phase shifter with an
internal driver. Typical applications include
communications antennas and phased array radars.
Ordering Information 1
Part Number
MAPS-010143-TR0500
Package
500 piece reel
MAPS-010143-001SMB
Sample Test Board
1. Reference Application Note M513 for reel size information.
Pin Configuration 2
Pin No.
Function
Pin No.
Function
1 VEE 13 GND
2 P/S 14 RF OUT
3 GND 15 GND
4 GND 16 GND
5
RF IN
17 SER OUT
6 GND 18 VCC
7
GND
19
D6
8
GND
20
D5
9
GND
21
D4
10 GND 22 D3 or LE
11 GND 23 D2 or CLK
12 GND 24 D1 or SER IN
2. The exposed pad centered on the package bottom must be
connected to RF and DC ground.
* Restrictions on Hazardous Substances, European Union Directive 2002/95/EC.
1
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
India Tel: +91.80.43537383
China Tel: +86.21.2407.1588
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.

1 page




MAPS-010143 pdf
MAPS-010143
Digital Phase Shifter
4-Bit, 1.4 - 2.4 GHz
Rev. V4
Modes of Operation:
Serial and Direct Parallel
Serial Mode
The serial control interface (SERIN, CLK, LE,
SEROUT) is compatible with the SPI protocol. SPI
mode is activated when P/S is kept high. The 6-bit
serial word must be loaded with the MSB first. After
shifting in the 6 bit word, a rising edge on LE will set
the phase shifter to the desired state. While LE is
high the CLK is masked to protect the data while
implementing the change. SEROUT is SERIN
delayed by 6 clock cycles.
When P/S is low, the serial control interface is
disabled. When P/S is set high, Pins 22, 23, and 24
have the LE, CLK, and SER IN function.
In serial mode operation, the outputs will stay
constant while LE is kept low.
Direct Parallel Mode
The parallel mode is enabled when P/S is set low. In
the direct parallel mode, the phase shifter is
controlled by the parallel control inputs directly.
When P/S is set low, Pins 22, 23, and 24 have the
D3, D2, and D1 function.
Mode Truth Table 8,9
P/S LE
1X
0 N/A
Mode
Serial
Direct Parallel
8. There are two dummy bits (D1 & D2), that must be sent in the
serial mode. This is because the 4 bit phase shifter uses the
same driver as the 6 bit phase shifter.
9. In the parallel mode, D1 and D2 should be tied to ground or to
VCC.
Truth Table (Digital Phase Shifter) 10
D6 D5 D4 D3 D2 D1
Phase Shift
0 0 0 0 X X Reference Phase
0 0 01XX
22.5 deg
0 0 10XX
45 deg
0 1 00XX
90 deg
1 0 00XX
180 deg
1 1 11XX
337.5 deg
10. 0 = CMOS Low; 1 = CMOS High, X is CMOS Low or High
Symbol
tSCK
tCS
tCH
tLS
tLEW
tLH
tLES
Serial Interface Timing Characteristics
Parameter
Typical Performance
-40°C
25°C
+85°C
Min. Serial Clock Period
100 100 100
Min. Control Set-up Time
20 20 20
Min. Control Hold Time
20 20 20
Min. LE Set-up Time
10 10 10
Min. LE Pulse Width
10 10 10
Min. Serial Clock Hold Time from LE
10
10
10
Min. LE Pulse Spacing
630 630 630
Units
ns
ns
ns
ns
ns
ns
ns
5
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
India Tel: +91.80.43537383
China Tel: +86.21.2407.1588
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.

5 Page










PáginasTotal 6 Páginas
PDF Descargar[ Datasheet MAPS-010143.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
MAPS-010143Digital Phase ShifterMA-COM Technology
MA-COM Technology
MAPS-010144Digital Phase ShifterMA-COM Technology
MA-COM Technology
MAPS-010145Digital Phase ShifterMA-COM Technology
MA-COM Technology
MAPS-010146Digital Phase ShifterMA-COM Technology
MA-COM Technology

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar