|
|
Número de pieza | M34506M4 | |
Descripción | SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER | |
Fabricantes | Renesas | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de M34506M4 (archivo pdf) en la parte inferior de esta página. Total 70 Páginas | ||
No Preview Available ! 4506 Group
SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER
REJ03B0106-0301
Rev.3.01
2005.02.07
DESCRIPTION
The 4506 Group is a 4-bit single-chip microcomputer designed with
CMOS technology. Its CPU is that of the 4500 series using a
simple, high-speed instruction set. The computer is equipped with
two 8-bit timers (each timer has a reload register), interrupts, and
10-bit A/D converter.
The various microcomputers in the 4506 Group include variations
of the built-in memory size as shown in the table below.
FEATURES
qMinimum instruction execution time ................................ 0.68 µs
(at 4.4 MHz oscillation frequency, in high-speed mode)
qSupply voltage .......................................................... 2.0 V to 5.5 V
(It depends on the oscillation frequency and operating mode.)
q Timers
Timer 1 ...................................... 8-bit timer with a reload register
Timer 2 ...................................... 8-bit timer with a reload register
qInterrupt ........................................................................ 4 sources
qKey-on wakeup function pins ................................................... 12
qInput/Output port ...................................................................... 14
qA/D converter .................. 10-bit successive comparison method
qWatchdog timer
qClock generating circuit (ceramic resonator/RC oscillation)
qLED drive directly enabled (port D)
APPLICATION
Electrical household appliance, consumer electronic products, of-
fice automation equipment, etc.
Part number
M34506M2-XXXFP
M34506M4-XXXFP
M34506E4FP (Note)
Note: Shipped in blank.
PIN CONFIGURATION
ROM (PROM) size
(✕ 10 bits)
2048 words
4096 words
4096 words
RAM size
(✕ 4 bits)
128 words
256 words
256 words
Package
PRSP0020DA-A
PRSP0020DA-A
PRSP0020DA-A
ROM type
Mask ROM
Mask ROM
One Time PROM
VDD
VSS
XIN
XOUT
CNVSS
RESET
P21/AIN1
P20/AIN0
D3/K
D2/C
1
2
3
4
5
6
7
8
9
10
20 P00
19 P01
18 P02
17 P03
16 P10
15 P11
14 P12/CNTR
13 P13/INT
12 D0
11 D1
Outline PRSP0020DA-A (20P2N-A)
Pin configuration (top view) (4506 Group)
Rev.3.01 2005.02.07 page 1 of 111
REJ03B0106-0301
1 page 4506 Group
DEFINITION OF CLOCK AND CYCLE
q Operation source clock
The operation source clock is the source clock to operate this
product. In this product, the following clocks are used.
• External ceramic resonator
• External RC oscillation
• Clock (f(XIN)) by the external clock
• Clock (f(RING)) of the on-chip oscillator which is the internal
oscillator.
q System clock
The system clock is the basic clock for controlling this product.
The system clock is selected by the bits 2 and 3 of the clock con-
trol register MR.
q Instruction clock
The instruction clock is a signal derived by dividing the system
clock by 3. The one instruction clock cycle generates the one
machine cycle.
q Machine cycle
The machine cycle is the standard cycle required to execute the
instruction.
Table Selection of system clock
Register MR
System clock
MR3 MR2
(Note 1)
0 0 f(XIN) or f(RING)
0 1 f(XIN)/2 or f(RING)/2
1 0 f(XIN)/4 or f(RING)/4
1 1 f(XIN)/8 or f(RING)/8
Operation mode
High-speed mode
Middle-speed mode
Low-speed mode
Default mode
Notes 1: The on-chip oscillator clock is f(RING), the clock by the
ceramic resonator, RC oscillation or external clock is
f(XIN).
2: The default mode is selected after system is released
from reset and is returned from RAM back-up.
PORT FUNCTION
Port Pin
Port D
D0, D1
D2/C
D3/K
Port P0 P00–P03
Port P1 P10, P11
P12/CNTR,
P13/INT
Port P2 P20/AIN0
P21/AIN1
Input
Output
I/O
(4)
I/O
(4)
I/O
(4)
I/O
(2)
Output structure
I/O Control
Control
unit instructions registers
N-channel open-drain 1 SD, RD
SZD, CLD PU2, K2
SCP, RCP
SNZCP
IAK, OKA
N-channel open-drain 4 OP0A
IAP0
PU0, K0
N-channel open-drain 4 OP1A
IAP1
PU1, K1
W6, I1
N-channel open-drain 2 OP2A
IAP2
PU2, K2
Q1
Remark
Built-in programmable pull-up
functions
Key-on wakeup functions
(programmable)
Built-in programmable pull-up
functions
Key-on wakeup functions
(programmable)
Built-in programmable pull-up
functions
Key-on wakeup functions
(programmable)
Built-in programmable pull-up
functions
Key-on wakeup functions
(programmable)
Rev.3.01 2005.02.07 page 5 of 111
REJ03B0106-0301
5 Page 4506 Group
(Note)
P13/INT
I13
External interrupt circuit structure
I12
Falling
0
1
Rising
K13
SNZI0 instruction
One-sided edge
detection circuit
Both edges
detection circuit
Wakeup
Skip
I11
0
1
EXF0
External 0
interrupt
Timer 1 count start
synchronization
circuit input
• This symbol represents a parasitic diode on the port.
Rev.3.01 2005.02.07 page 11 of 111
REJ03B0106-0301
11 Page |
Páginas | Total 70 Páginas | |
PDF Descargar | [ Datasheet M34506M4.PDF ] |
Número de pieza | Descripción | Fabricantes |
M34506M2 | SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER | Renesas |
M34506M2-XXXFP | SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER | Renesas |
M34506M4 | SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER | Renesas |
M34506M4-XXXFP | SINGLE-CHIP 4-BIT CMOS MICROCOMPUTER | Renesas |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |