DataSheet.es    


PDF 7026TX Data sheet ( Hoja de datos )

Número de pieza 7026TX
Descripción Fully-Managed Switches User Manual
Fabricantes N-TRON 
Logotipo N-TRON Logotipo



Hay una vista previa y un enlace de descarga de 7026TX (archivo pdf) en la parte inferior de esta página.


Total 70 Páginas

No Preview Available ! 7026TX Hoja de datos, Descripción, Manual

7026 Series
Managed Industrial
Ethernet Switch
User Manual &
Installation
Guide
(Revised 2011-11-15)
Free Datasheet http://www.datasheetlist.com/

1 page




7026TX pdf
7026TX Industrial Ethernet Switch Accessories
The SD and USB connectors are for temporary connection only. Do not use, connect, or disconnect unless
area is known to be non-hazardous. Connection or disconnection in an explosive atmosphere could result in
an explosion.
Configuration Device
Ideal for saving, or restoring switch configuration
parameters quickly without the need for a computer or
software. One configuration device per switch is
recommended.
NTCD-128
The configuration device is inserted in the back of the 7026TX.
(Revised 2011-11-15)
Page 5 of 169
Free Datasheet http://www.datasheetlist.com/

5 Page





7026TX arduino
NOTE: The RJ45 data port has two LEDs located on each connector. The left LED indicates LINK status,
and the right LED indicates ACTIVITY.
LEDs: The table below describes the operating modes:
LED
Color
GREEN
Description
Power is ON
RED
Power is ON and a fault condition exists
OFF Power is OFF
LNK
GREEN
OFF
10/100/1000Mb Link between ports
No Link between ports
ACT
GREEN
OFF
Data is active between ports
Data is inactive between ports
APPLYING POWER AND FAULT CONNECTIONS (Back View)
7026TX with DC Power Supply Installed
Unscrew & Remove the DC Voltage Input
Plug from the Power Input Header
Install the DC Power Cables into the Plug
(observing polarity).
Plug the Voltage Input Plug back into the
Power Input Header.
Tightening torque for the terminal block
power plug is 0.5 Nm/0.368 Pound Foot.
Verify the Power LED stays ON.
Notes:
When a DC Power supply is installed, only one power supply must be connected to power for
minimal operation. For redundant power operation, V1 and V2 inputs must be connected to separate
DC Voltage sources. This device will draw current from both sources simultaneously. Use 16-28
gauge wire when connecting to the power supply.
Recommended 24V DC Power Supplies, similar to: N-Tron‘s P/N NTPS-24-1.3
(Revised 2011-11-15)
Page 11 of 169
Free Datasheet http://www.datasheetlist.com/

11 Page







PáginasTotal 70 Páginas
PDF Descargar[ Datasheet 7026TX.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
7026TXFully-Managed Switches User ManualN-TRON
N-TRON

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar