|
|
Número de pieza | 3010KM | |
Descripción | SI-3010KM | |
Fabricantes | Allegro MicroSystems | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de 3010KM (archivo pdf) en la parte inferior de esta página. Total 9 Páginas | ||
No Preview Available ! LRinegeuarlators
ABSOLUTE MAXIMUM RATINGS
Input Voltage, VI . . . . . . . . . . . . . 35 V
Output Current, IO . . . . . . . . . . . . . 1 A*
Enable Input Voltage, VE . . . . . . . . . VI
Junction Temperature, TJ . . . . +125°C
Storage Temperature Range,
TS . . . . . . . . . . . . -30°C to +125°C
* Output current rating is limited by input
voltage, duty cycle, and ambient tempera-
ture. Under any set of conditions, do not
exceed a junction temperature of +125°C.
SI-3010KM
1 A, Low-Dropout, 1.0~16 V Regulator
Designed to meet the high-current requirements in industrial and
consumer applications; embedded core, memory, or logic supplies; TVs,
VCRs, and office equipment, the SI-3010KM voltage regulator offers
the reduced dropout voltage and low quiescent current essential for
improved efficiency. This device delivers a regulated output at up to
1 A. Integrated thermal and overcurrent protection enhance overall
system reliability. Devices with fixed output voltages are also available.
Quiescent current does not increase significantly as the dropout
voltage is approached, an ideal feature in standby/resume power systems
where data integrity is crucial. Regulator accuracy and excellent
temperature characteristics are provided by a bandgap reference. An
LS-TTL/CMOS-compatible input gives the designer complete control
over power up, standby, or power down. A pnp pass element provides a
dropout voltage of less than 600 mV at 1 A of load current. Low output
voltages eliminate the need for expensive PWM buck converters. The
low dropout voltage permits more efficient regulation before output
regulation is lost.
This device is supplied in a 5-lead TO-252 style surface-mount
plastic package with ground tab to provide a low-resistance path for
maximum heat dissipation.
FEATURES
■ 1 A Output Current
■ 0.6 V Maximum Dropout Voltage at IO = 1 A
■ Fast Transient Response
■ 1 µA Maximum Standby Current
■ Adjustable 1.0 ~ 16 V Output Voltage
■ Remote Voltage Sensing
■ Foldback Current Limiting
■ Overvoltage Protection
■ Ground Tab for Superior Heat Dissipation
■ Thermal Protection
APPLICATIONS
■ TVs, VCRs, Electronic Games
■ Embedded Core, Memory, or Logic Supplies
■ Printers and Other Office Equipment
■ Industrial Machinery
■ Secondary-Side Stabilization of Multi-Output SMPS
Always order by complete part number, e.g., SI-3010KM-TL ,
where “-TL” indicates tape and reel.
Sanken Power Devices
from Allegro MicroSystems
Free Datasheet http://www.datasheet-pdf.com/
1 page LRinegeuarlators
SI-3010KM
1 A, Low-Dropout,
1.0~16 V Regulator
TYPICAL CHARACTERISTICS (cont.)
(VI = 7 V, VO = 5.0 V adjusted, TA = 25°C)
Overvoltage Protection
GND Pin Current
APPLICATIONS INFORMATION
Input Capacitor (CI, ≥22 µF). This is necessary either
when the input line includes inductance or when the wiring
is long.
Output Capacitor (CO, ≥47 µF). This device is not
designed for a use with a very low ESR output capacitor
such as a ceramic capacitor. Output oscillation may occur
with that kind of capacitor. The recommended ESR is
0.2~2 Ω at TA = 25°C.
Reverse-Bias Protection Diode (D1). Diode D1
provides reverse-bias protection between the input and
output. Sanken type SFPL-52 is recommended.
ENABLE Input. The ENABLE (control) input features
an internal pull-down resistor. Leaving this input open
causes the output to turn off.
Parallel Operation. Parallel operation to increase load
current is not permitted.
Output Voltage Adjustable Resistors (R1 and R2).
The output voltage is adjusted by R1 and R2. 10 kΩ for
R2 is recommended.
R1 = (VO – Vref)/(Vref/R2)
For an output voltage of 1.5 V or less, diode D1 can be
eliminated and add a 10 kΩ resistor between ADJ and the
junction of R1 and R2.
www.allegromicro.com
5
Free Datasheet http://www.datasheet-pdf.com/
5 Page |
Páginas | Total 9 Páginas | |
PDF Descargar | [ Datasheet 3010KM.PDF ] |
Número de pieza | Descripción | Fabricantes |
3010KM | SI-3010KM | Allegro MicroSystems |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |