DataSheet.es    


PDF 78F9177 Data sheet ( Hoja de datos )

Número de pieza 78F9177
Descripción UPD78F9177
Fabricantes NEC 
Logotipo NEC Logotipo




1. 78F9177 Microcontroller






Hay una vista previa y un enlace de descarga de 78F9177 (archivo pdf) en la parte inferior de esta página.


Total 56 Páginas

No Preview Available ! 78F9177 Hoja de datos, Descripción, Manual

DATA SHEET
MOS INTEGRATED CIRCUIT
µPD78F9177, 78F9177Y
8-BIT SINGLE-CHIP MICROCONTROLLER
The µPD78F9177 and µPD78F9177Y are µPD789177, 789177Y Subseries (small, general-purpose) in the 78K/0S
Series.
The µPD78F9177 replaces the internal ROM of the µPD789176 and µPD789177 with flash memory, while the
µPD78F9177Y replaces the ROM of the µPD789176Y and µPD789177Y with flash memory.
Because flash memory allows the program to be written and erased electrically with the device mounted on the
board, this product is ideal for the evolution stages of system development, small-scale production and rapid
development of new products.
Detailed function descriptions are provided in the following user’s manuals. Be sure to read them before
designing.
µPD789167, 789177, 789167Y, 789177Y Subseries User’s Manual: U14186E
78K/0S Series User's Manual Instruction: U11047E
FEATURES
• Pin compatible with mask ROM version (except VPP pin)
• Flash memory: 24 Kbytes
• High-speed RAM: 512 bytes
• Minimum instruction execution time can be changed from high-speed (0.4 µs: @5.0-MHz operation with main
system clock) to ultra-low-speed (122 µs: @ 32.768-kHz operation with subsystem clock)
• 10-bit resolution A/D converter: 8 channels
• I/O ports: 31
• Serial interface: 2 channels
3-wire serial I/O mode / UART mode: 1 channel
SMB (µPD78F9177Y only): 1 channel
• Timers: 6 channels
16-bit timer: 1 channel
8-bit timer/event counter: 2 channels
8-bit timer: 1 channel
Watch timer: 1 channel
Watchdog timer: 1 channel
• On-chip 16-bit multiplier
• Power supply voltage: VDD = 1.8 to 5.5 V
The information in this document is subject to change without notice. Before using this document, please
confirm that this is the latest version.
Not all devices/types available in every country. Please check with local NEC representative for
availability and additional information.
Document No. U14022EJ1V0DS00 (1st edition)
Date Published August 2000 NS CP(K)
Printed in Japan
The mark shows major revised
©
2000
Free Datasheet http://www.datasheet4u.net/

1 page




78F9177 pdf
µPD78F9177, 78F9177Y
OVERVIEW OF FUNCTIONS
Item
Internal memory
Flash memory
High-speed RAM
Minimum instruction execution time
General-purpose registers
Instruction set
Multiplier
I/O ports
A/D converters
Serial interfaces
Timers
Timer output
Buzzer output
Vectored interrupt Maskable
sources
Non-maskable
Power supply voltage
Operating ambient temperature
Package
µPD78F9177
µPD78F9177Y
24 Kbytes
512 bytes
• 0.4/1.6 µs (@5.0-MHz operation with main system clock)
• 122 µs (@ 32.768-kHz operation with subsystem clock)
8 bits × 8 registers
• 16-bit operations
• Bit manipulations (set, reset, test)
8 bits × 8 bits = 16 bits
Total:
31
• CMOS input:
• CMOS I/O:
• N-ch open drain:
8
17
6
10-bit resolution × 8 channels
3-wire serial I/O/UART : 1 channel
• 16-bit timer:1 channel
• 8-bit timer/event counter:2 channels
• 8-bit timer:1 channel
• Watch timer:1 channel
• Watchdog timer:1 channel
3-wire serial I/O / UART: 1 channel
SMB: 1 channel
4 output
1
Internal: 10, External: 4 (µPD78F9177)
Internal: 12, External: 4 (µPD78F9177Y)
Internal: 1
VDD = 1.8 to 5.5 V
TA = 40°C to +85°C
44-pin plastic LQFP (10 × 10)
44-pin plastic LQFP (10 X10)
48-pin plastic TQFP (fine pitch) (7 x 7)
Data Sheet U14022EJ1V0DS00
5
Free Datasheet http://www.datasheet4u.net/

5 Page





78F9177 arduino
µPD78F9177, 78F9177Y
3. PIN FUNCTIONS
3.1 Port Pins
Pin Name
I/O
Function
After Reset Alternate Function
P00 to P05
P10, P11
I/O Port 0
6-bit input/output port
Input/output mode can be specified in 1-bit units
When used as an input port, an on-chip pull-up resistor can be
specified by software.
I/O Port 1
2-bit input/output port
Input/output mode can be specified in 1-bit units
When used as an input port, an on-chip pull-up resistor can be
specified by software.
Input
Input
P20 I/O Port 2
Input
SCK20/ASCK20
P21 7-bit input/output port
Input/output mode can be specified in 1-bit units
SO20/TxD20
P22
For P20 to P22, P25, and P26, an on-chip pull-up resistor can be
SI20/RxD20
P23 specified by software.
Only P23 and P24 can be used as N-ch open-drain
P24 input/output port pins.
SCL0 Note
SDA0 Note
P25 TI80/SS20
P26 TO80
P30 I/O Port 3
P31 4-bit input/output port
Input/output mode can be specified in 1-bit units
P32 On-chip pull-up resistor can be specified by software.
P33
Input
INTP0/TI81/CPT90
INTP1/TO81
INTP2/TO90
INTP3/TO82/BZO90
P50 to P53
I/O Port 5
4-bit N-ch open-drain input/output port
Input/output mode can be specified in 1-bit units
Input
P60 to P67
Input
Port 6
8-bit input-only port
Input
ANI0 to ANI7
Note µPD78F9177Y only
Data Sheet U14022EJ1V0DS00
11
Free Datasheet http://www.datasheet4u.net/

11 Page







PáginasTotal 56 Páginas
PDF Descargar[ Datasheet 78F9177.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
78F9177UPD78F9177NEC
NEC

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar