|
|
PDF M190EG02-V4 Data sheet ( Hoja de datos )
| Número de pieza | M190EG02-V4 | |
| Descripción | LCD MODULE | |
| Fabricantes | AUO | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de M190EG02-V4 (archivo pdf) en la parte inferior de esta página. Total 29 Páginas | ||
|
No Preview Available !
Product Specification
AU OPTRONICS CORPORATION
M190EG02 V4
( V ) Preliminary Specification
( ) Final Specification
Module
Model Name
19.0” SXGA Color TFT-LCD
M190EG02 V4
Customer
Date
Checked &
www.DataSheet.co.kr
Approved by
Date
Approved by
Prepared by
Note: This Specification is subject to change
without notice.
document version 0.3
Desktop Display Business Group /
AU Optronics corporation
1/14
Datasheet pdf - http://www.DataSheet4U.net/
1 page  
Product Specification
AU OPTRONICS CORPORATION
M190EG02 V4
1. Handling Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human earth
when handling.
7) Do not open or modify the Module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a Module has to be put back into the packing container slot after once it was taken out
from the container, do not press the center of the Cold Cathode Fluorescent Lamp (CCFL)
reflector edge. Instead, press at the far ends of the CCFL reflector edge softly. Otherwise the
TFT Module may be damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the
Interface Connector of the TFT Module.
11) After installation of the TFT Module into an enclosure, do not twist nor bend the TFT Module
even momentary. At designing the enclosure, it should be taken into consideration that no
bending/twisting forces are applied to the TFT Module from outside. Otherwise the TFT Module
www.DataSheet.co.kr
may be damaged.
12) Cold Cathode Fluorescent Lamp (CCFL) in LCD contains a small amount of mercury. Please follow
local ordinances or regulations for disposal.
13) Small amount of materials having no flammability grade is used in the LCD module. The LCD module
should be supplied by power complied with requirements of Limited Power Source (IEC60950 or
UL1950), or be applied exemption.
14) The LCD module is designed so that the CCFL in it is supplied by Limited Current Circuit (IEC60950 or
UL1950). Do not connect the CCFL in Hazardous Voltage Circuit.
document version 0.3
5/14
Datasheet pdf - http://www.DataSheet4U.net/
5 Page 
Product Specification
AU OPTRONICS CORPORATION
M190EG02 V4
Note 6: Definition of response time:
The output signals of photo detector are measured when the input signals are changed from “Full Black” to
“Full White” (rising time), and from “Full White” to “Full Black” (falling time), respectively. The response
time is interval between the 10% and 90% of amplitudes. Please refer to the figure as below.
% TrF
Optical
response
100
90
10
0
W hite
Black
TrR
W hite
Note 7: Subchecker Pattern
RGB RGB
RGB RGB
RGB RGB
Gray Level = L127www.DataSheet.co.kr
Gray Level = L0
Method: Record dBV & DC value with (WESTAR)TRD-100
Amplitude
AC
DC
Flicker (dB) = 20 log AC Level(at 30 Hz)
DC Level
Time
document version 0.3
11/14
Datasheet pdf - http://www.DataSheet4U.net/
11 Page | ||
| Páginas | Total 29 Páginas | |
| PDF Descargar | [ Datasheet M190EG02-V4.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| M190EG02-V0 | LCD MODULE | AUO |
| M190EG02-V3 | SXGA Color TFT-LCD | AUO |
| M190EG02-V4 | LCD MODULE | AUO |
| M190EG02-V7 | LCD MODULE | AUO |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |