DataSheet.es    


PDF G104VN01-V1 Data sheet ( Hoja de datos )

Número de pieza G104VN01-V1
Descripción LCD Module
Fabricantes AUO 
Logotipo AUO Logotipo



Hay una vista previa y un enlace de descarga de G104VN01-V1 (archivo pdf) en la parte inferior de esta página.


Total 26 Páginas

No Preview Available ! G104VN01-V1 Hoja de datos, Descripción, Manual

www.DataSheet4U.net
Avnet Embedded.
Support Around The Board
Avnet Embedded
Specification.
Datasheet
AUO G104VN01-V1
www.avnet-embedded.eu

1 page




G104VN01-V1 pdf
www.DataSheet4U.net
G104VN01 V1
1. Operating Precautions
1) Since front polarizer is easily damaged, please be cautious and not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or
spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or soft cloth.
5) Since the panel is made of glass, it may be broken or cracked if dropped or bumped on
hard surface.
6) To avoid ESD (Electro Static Discharde) damage, be sure to ground yourself before handling
TFT-LCD Module.
7) Do not open nor modify the module assembly.
8) Do not press the reflector sheet at the back of the module to any direction.
9) In case if a module has to be put back into the packing container slot after it was taken
out from the container, do not press the center of the LED light bar edge. Instead, press
at the far ends of the LED light bar edge softly. Otherwise the TFT Module may be
damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor
tilt the Interface Connector of the TFT Module.
11) TFT-LCD Module is not allowed to be twisted & bent even force is added on module in a very
short time. Please design your display product well to avoid external force applying to module
by end-user directly.
12) Small amount of materials without flammability grade are used in the TFT-LCD module. The
TFT-LCD module should be supplied by power complied with requirements of Limited Power
Source (IEC60950 or UL1950), or be applied exemption.
13) Severe temperature condition may result in different luminance, response time and lamp
ignition voltage.
14) Continuous operating TFT-LCD display under low temperature environment may accelerate
lamp exhaustion and reduce luminance dramatically.
15) The data on this specification sheet is applicable when LCD module is placed in landscape
position.
16) Continuous displaying fixed pattern may induce image sticking. It’s recommended to use
screen saver or shuffle content periodically if fixed pattern is displayed on the screen.
G104VN01 V1 rev. 1.1
Page 4/24

5 Page





G104VN01-V1 arduino
www.DataSheet4U.net
4. Absolute Maximum Ratings
4.1 Absolute Ratings of TFT LCD Module
Item
Logic/LCD Drive Voltage
Symbol
Vin
Min
-0.3
4.2 Absolute Ratings of Environment
Item
Bulbshode39dOperatingTemperature
Symbol
TOP
Min
-30
Max
+4.0
Max
+85
G104VN01 V1
Unit
[Volt]
Unit
[oC]
Operation Humidity
HOP
5
95 [%RH]
Storage Temperature
TST
-30
+85
[oC]
Storage Humidity
HST
5
95 [%RH]
Note: Maximum Wet-
and no condensation.
G104VN01 V1 rev. 1.1
Page 10/24

11 Page







PáginasTotal 26 Páginas
PDF Descargar[ Datasheet G104VN01-V1.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
G104VN01-V0LCD ModuleAUO
AUO
G104VN01-V1LCD ModuleAUO
AUO

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar