DataSheet.es G104SN03-V2 Hoja de datos PDF


PDF G104SN03-V2 Datasheet ( Hoja de datos )

Número de pieza G104SN03-V2
Descripción LCD Module
Fabricantes AUO 
Logotipo AUO Logotipo
Vista previa
Total 29 Páginas
		
G104SN03-V2 datasheet

1 Page

G104SN03-V2 pdf
www.DataSheet4U.com
et4U.com
1.0 Handing Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnection from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human earth when
handling.
7) Do not open nor modify the module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a module has to be put back into the packing container slot after once it was taken out
from the container, do not press the center of the CCFL Reflector edge. Instead, press at the far
ends of the CFL Reflector edge softly. Otherwise the TFT module may be damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the
interface Connector of the TFT module.
11) After installation of the TFT module into an enclosure, do not twist nor bend the TFT module even
momentary. At designing the enclosure, it should be taken into consideration that no
bending/twisting forces are applied to the TFT module from outside. Otherwise the TFT module
may be damaged.
DataSheet4U.com
12) Cold cathode fluorescent lamp in LCD contains a small amount of mercury. Please follow local
ordinances or regulations for disposal.
13) Small amount of materials having no flammability grade is used in the LCD module should be
supplied by power complied with requirements of Limited Power Source, or be applied exemption.
14) The LCD module is designed so that the CFL in it is supplied by Limited Current Circuit. Do not
connect the CFL in Hazardous Voltage Circuit.
DataShee
DataSheet4U.com
(C) Copyright AU Optronics, Inc.
2004 All Right Reserved.
No Reproduction and Redistribution Allowed.
DataSheet4 U .com
G104SN03 V.2
5/28

5 Page

G104SN03-V2 arduino
www.DataSheet4U.com
et4U.com
4.0 Optical Characteristics (Note 1, Note 2)
Item
Specification
Symbol Condition
Unit
Min. Typ. Max.
Remark
Response time
Rising time
Falling time
Contrast ratio
Viewing angle
Top
Bottom
Left
Right
Tr θ=0° - 10
Tf - 25
CR θ=0° 400 500
30 35
CR10
60
60
65
60
60 60
20 ms
30
Note 4
- Note 3,5
-
- deg. Note 3,6
-
White Luminance (ICFL=4.5 mA) [cd/m2] θ=0° 160 180 - nit Note 3,7,8,9
Color chromaticity(CIE)
Wx 0.280 0.320 0.340
θ=0°
Wy 0.300 0.330 0.360
Note 3,8,9
Rx 0.540 0.570 0.600
Ry 0.290 0.320 0.350
Gx 0.270 0.300 0.330
Gy 0.530 0.560 0.590
Bx 0.115 0.145 0.175
By 0.100 0.130 0.160
White uniformity
δW 13 Points -
- 1.33
Note 3,9,10
Note 1: Ambient temperature = 25. DataSheet4U.com
Note 2: To be measured in dark room after backlight warm up 30 minutes.
Note 3: To be measured with a viewing cone of 1°by Topcon luminance meter BM-5A.
Note 4: Definition of response time:
The output signals of BM-7 are measured when the input signals are changed from
Blackto White(falling time) and from Whiteto Black(rising time), respectively. The
response time means the interval between the 10% and 90% of amplitudes. Refer to
figure as below.
DataShee
"White"
100%
Sig 90%
nal
(R
ela
tiv 10%
0%
e
Tr
Black
Note 5. Definition of contrast ratio:
Contrast ratio is calculated with the following formula.
DataSheet4U.com
Luminance on the white raster
Contrast ratio (CR)=
Luminance on the black raster
(C) Copyright AU Optronics, Inc.
2004 All Right Reserved.
G104SN03 V.2
No Reproduction and Redistribution Allowed.
DataSheet4 U .com
"White"
Tf
10/28

10 Page





PáginasTotal 29 Páginas
PDF Descargar[ G104SN03-V2.PDF ]

Enlace url


Hoja de datos destacado

Número de piezaDescripciónFabricantes
G104SN03-V0LCD ModuleAUO
AUO
G104SN03-V1LCD ModuleAUO
AUO
G104SN03-V2LCD ModuleAUO
AUO
G104SN03-V5LCD ModuleAUO
AUO

Número de piezaDescripciónFabricantes
SSM2604

Low Power Audio Codec.

Analog Devices
Analog Devices
SLG3NB3331

32.768 kHz and MHz GreenCLK.

Silego
Silego
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices
SDC1741

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


Index : 0  1  2  3  4  5  6  7  8  9  A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z


www.DataSheet.es    |   2018   |  Contacto  |  Buscar