DataSheet.es    


PDF INX104-01 Data sheet ( Hoja de datos )

Número de pieza INX104-01
Descripción Display Module
Fabricantes Inelmatic Electronics 
Logotipo Inelmatic Electronics Logotipo



Hay una vista previa y un enlace de descarga de INX104-01 (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! INX104-01 Hoja de datos, Descripción, Manual

www.DataSheet.co.kr
This Datasheet has been downloaded from:
DisplayAlliance.com
Please call +1 (978) 465-6190 or email [email protected] for a quote.
ISO 9001 : 2008
Datasheet pdf - http://www.DataSheet4U.net/

1 page




INX104-01 pdf
www.DataSheet.co.kr
PRODUCT GROUP
TFT-LCD PRODUCT
REV
O
ISSUE DATE
2010.11.13
1.0 GENERAL DESCRIPTION
1.1 Introduction
10.4” AFFS+ TFT-LCD is a color active matrix TFT LCD module using amorphous silicon
TFT's (Thin Film Transistors) as active switching devices. This module has a 10.4 inch
diagonally measured active area with XGA resolutions (1024 horizontal by 768 vertical
pixel array). Each pixel is divided into RED, GREEN, BLUE dots which are arranged in
vertical stripe and this module can display 262,144 colors. The TFT-LCD panel used for
this module is a low reflection and higher color type.
SMD LED Array
Gate Driver IC
(COF)
VDD
(3.3V)
Power
Block
10.4”XGA
LVDS 1CH
(6bit)
T/CON
Source Driver IC
(COF)
1.2 Features
• 1Ch LVDS Interface with 1 pixel / clock
• 6-bit color depth, Display 262,144 colors
• High luminance and contrast ratio, low reflection and wide viewing angle
• Front Mounting Frame
• DE (Data Enable) mode only
• SLG (Single Level Gate) function use
• RoHS Product
• SMD LED Array
• On board EDID
1.3 Application
• Pen type & Tablet PC (only normal brightness version).
SPEC. NUMBER
101112-01-EN
SPEC. TITLE
INX104-01 Product Specification
PAGE
4 / 31
A4(210 X 297)
Datasheet pdf - http://www.DataSheet4U.net/

5 Page





INX104-01 arduino
www.DataSheet.co.kr
PRODUCT GROUP
TFT-LCD PRODUCT
REV
O
ISSUE DATE
2010.11.13
Note : 1. Viewing angle is the angle at which the contrast ratio is greater than 10. The viewing are
determined for the horizontal or 3, 9 o’clock direction and the vertical or 6, 12 o’clock
direction with respect to the optical axis which is normal to the LCD surface .
(see FIGURE 1)
2. Contrast measurements shall be made at viewing angle of = 0° and at the center of the
LCD surface. Luminance shall be measured with all pixels in the view field set first to white,
then to the dark (black) state. (See FIGURE 1)
Luminance Contrast Ratio (CR) is defined mathematically.
Luminance when displaying a white raster
CR=
Luminance when displaying a black raster
3. Luminance of white is defined as a luminance value of a point across the LCD surface.
Luminance shall be measured with all pixels in the view field set first to white.
This measurement shall be taken at the locations shown in FIGURE 2 for a total of the
measurements per display.
4. The White luminance uniformity on LCD surface is then expressed. (See FIGURE 2)
Uniformity Y =
Minimum Luminance of 5(or 13) points
Maximum Luminance of 5(or 13) points
X 100 (%)
5. The color chromaticity coordinates specified in Table 4 shall be calculated from the
spectral data measured with all pixels first in red, green, blue and white. Measurements
shall be made at the center of the panel.
6. The electro-optical response time measurements shall be made as FIGURE 3 by switching
the data input signal OFF and ON. The times needed for the luminance to change from
10% to 90% is Tr, and 90% to 10% is Td.
7. Cross-Talk of one area of the LCD surface by another shall be measured by comparing the
luminance (YA) of a 25mm diameter area, with all display pixels set to a gray level, to the
luminance (YB) of that same area when any adjacent area is driven dark. (See FIGURE 4 ).
SPEC. NUMBER
101112-01-EN
SPEC. TITLE
INX104-01 Product Specification
PAGE
10 / 31
A4(210 X 297)
Datasheet pdf - http://www.DataSheet4U.net/

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet INX104-01.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
INX104-01Display ModuleInelmatic Electronics
Inelmatic Electronics

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar