DataSheet.es    

PDF G084SN05-V1 Datasheet ( Hoja de datos )

Número de pieza G084SN05-V1
Descripción LCD Module
Fabricantes AUO 
Logotipo AUO Logotipo

Total 27 Páginas
		
G084SN05-V1 Hoja de datos, Descripción, Manual
www.speclcd.comwww.DataSheet4U.net
Spec. No.: MDGD084-SN05-2
Version:
0.2
Total pages:
27
Date:
2004-August-30
AU OPTRONICS CORPORATION
Product Functional Specifications
8.4SVGA Color TFT-LCD Module with Touch Panel
Model Name: G084SN05 V.1
Approved by
Martin Sun
Prepared by
Cynthia Lin
GD- MDBU Marketing Division / AU Optronics Croporation
Customer
Checked & Approved by
(C) Copyright AU Optroncis, Inc.
2004 All Right Reserved.
No Reproduction and Redistribution Allowed.
G084SN05 V.1 ver.0.2
www.speclcd.com
1/1

1 page

G084SN05-V1 pdf
www.speclcd.comwww.DataSheet4U.net
1.0 Handing Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnection from input
connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration
or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on
hard surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure
human earth when handling.
7) Do not open nor modify the module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a module has to be put back into the packing container slot after once it
was taken out from the container, do not press the center of the CCFL Reflector
edge. Instead, press at the far ends of the CFL Reflector edge softly. Otherwise
the TFT module may be damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate
nor tilt the interface Connector of the TFT module.
11) After installation of the TFT module into an enclosure, do not twist nor bend the
TFT module even momentary. At designing the enclosure, it should be taken into
consideration that no bending/twisting forces are applied to the TFT module from
outside. Otherwise the TFT module may be damaged.
12) Cold cathode fluorescent lamp in LCD contains a small amount of mercury. Please
follow local ordinances or regulations for disposal.
13) Small amount of materials having no flammability grade is used in the LCD
module should be supplied by power complied with requirements of Limited Power
Source, or be applied exemption.
14) The LCD module is designed so that the CFL in it is supplied by Limited Current
Circuit. Do not connect the CFL in Hazardous Voltage Circuit.
(C) Copyright AU Optroncis, Inc.
2004 All Right Reserved.
No Reproduction and Redistribution Allowed.
G084SN05 V.1 ver.0.2
www.speclcd.com
5/5

5 Page

G084SN05-V1 arduino
www.speclcd.comwww.DataSheet4U.net
5.0 Signal Interface
5.1 Connectors
Physical interface is described as for the connector on module.
These connectors are capable of accommodating the following signals and will be
following components.
Connector Name / Designation
Manufacturer
Type / Part Number
Mating Connector / Part Number
Mating Connector / Part Number
For Signal Connector
HIROSE
HRS DF 19K-20P-1H or compatible
HRS DF19G-20S-1C (WIRE TYPE)
HRS DF19-20S-1F (FPC TYPE)
Connector Name / Designation
Manufacturer
Type / Part Number
Mating Connector / Part Number
For Lamp Connector
JST
JST BHR-03VS-1 or compatible
JST SM03(4.0)B-BHS-1-TB
5.2 Signal Pin
Pin No.
1
3
5
7
9
11
13
15
17
19
Signal Name
VDD
GND
RxIN0-
GND
RxIN1+
RxIN2-
GND
CKIN+
NC
GND
Pin No.
2
4
6
8
10
12
14
16
18
20
Signal Name
VDD
GND
RxIN0+
RxIN1-
GND
RxIN2+
CKIN-
GND
NC
GND
(C) Copyright AU Optroncis, Inc.
2004 All Right Reserved.
No Reproduction and Redistribution Allowed.
G084SN05 V.1 ver.0.2
www.speclcd.com
11/11

11 Page


PáginasTotal 27 Páginas
PDF Descargar[ G084SN05-V1.PDF ]

Enlace url


Hoja de datos destacado

Número de piezaDescripciónFabricantes
G084SN05-V0LCD ModuleAUO
AUO
G084SN05-V1LCD ModuleAUO
AUO
G084SN05-V2Color TFT-LCD ModuleAUO
AUO
G084SN05-V3Color TFT-LCD ModuleAUO
AUO

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


www.DataSheet.es    |   2018   |  Privacy Policy  |  Contacto  |  Buscar