DataSheet.es    


PDF 97G104V1N0F-2 Data sheet ( Hoja de datos )

Número de pieza 97G104V1N0F-2
Descripción TFT-LCD Panel
Fabricantes Promate 
Logotipo Promate Logotipo



Hay una vista previa y un enlace de descarga de 97G104V1N0F-2 (archivo pdf) en la parte inferior de esta página.


Total 26 Páginas

No Preview Available ! 97G104V1N0F-2 Hoja de datos, Descripción, Manual

Gleichmann & Co. Electronics GmbH
Product Marketing Displays & Systems
Schraderstr. 44, D- 67227 Frankenthal
Tel : +49 7249-910-0, Fax: +49 7249-910-559
[email protected] http://www.msc-ge.com
Product Specification
Model No.:
Description:
Document No.:
Version:
Total Pages:
Date:
97G104V1N0F-2
10.4” TFT-LCD Panel
+ 4 wires touch
DOC-50-100182
0.1
25
April.8th,2010
Name
Prepared By Perry Chen
Checked By Pamela Lin
Approved By Davis Weng
Date
2010/04/08
Department
PM …R&D
2010/04/08 PM …R&D
2010/04/08 …PM R&D
ALL RIGHTS STRICTLY RESERVED. ANY PORTION OF THIS PAPER SHALL NOT BE REPRODUCED, COPIED, OR
TRANSFORMED TO ANY OTHER FORMS WITHOUT PREMISSION FROM PROMATE ELECTRONIC CO., LTD.
Promate Electronic Co., Ltd.| TEL: +886 (2) 2659 0303 | FAX: +886 (2) 2658 0954 | www.promate.com
4F, No. 32, Section 1, Huan Shan Road., Nei Hu District, Taipei 11442, Taiwan
www.DataSheet.in

1 page




97G104V1N0F-2 pdf
1. Operating Precautions
1) Since front polarizer is easily damaged, please be cautious and not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or soft cloth.
5) Since the panel is made of glass, it may be broken or cracked if dropped or bumped on
hard surface.
6) To avoid ESD (Electro Static Discharge) damage, be sure to ground yourself before handling
TFT-LCD Module.
7) Do not open nor modify the module assembly.
8) Do not press the reflector sheet at the back of the module to any direction.
9) In case if a module has to be put back into the packing container slot after it was taken
out from the container, do not press the center of the LED light bar edge. Instead,
press at the far ends of the LED light bar edge softly. Otherwise the TFT Module may
be damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor
tilt the Interface Connector of the TFT Module.
11) TFT-LCD Module is not allowed to be twisted & bent even force is added on module in a very
short time. Please design your display product well to avoid external force applying to module
by end-user directly.
12) Small amount of materials without flammability grade are used in the TFT-LCD module. The
TFT-LCD module should be supplied by power complied with requirements of Limited Power
Source (IEC60950 or UL1950), or be applied exemption.
13) Severe temperature condition may result in different luminance, response time and lamp
ignition voltage.
14) Continuous operating TFT-LCD display under low temperature environment may accelerate
lamp exhaustion and reduce luminance dramatically.
15) The data on this specification sheet is applicable when LCD module is placed in landscape
position.
16) Continuous displaying fixed pattern may induce image sticking. It’s recommended to use
screen saver or shuffle content periodically if fixed pattern is displayed on the screen.
ALL RIGHTS STRICTLY RESERVED. ANY PORTION OF THIS PAPER SHALL NOT BE REPRODUCED, COPIED, OR 4
TRANSFORMED TO ANY OTHER FORMS WITHOUT PREMISSION FROM PROMATE ELECTRONIC CO., LTD.
Promate Electronic Co., Ltd.| TEL: +886 (2) 2659 0303 | FAX: +886 (2) 2658 0954 | www.promate.com
4F, No. 32, Section 1, Huan Shan Road., Nei Hu District, Taipei 11442, Taiwan
www.DataSheet.in

5 Page





97G104V1N0F-2 arduino
5. Electrical Characteristics
5.1 TFT LCD Module
5.1.1 Power Specification
Symbol
Parameter
VDD Logic/LCD Input Voltage
IVDD LCD Input Current
PVDD LCD Power consumption
Irush LCD LCD Inrush Current
VDDrp
Allowable Logic/LCD Drive
Ripple Voltage
Note 1Measurement condition:
Min Typ Max
3.0 3.3 3.6
- 280 -
- 0.924 -
- - 1.5
- - 100
Units
Remark
[Volt]
[mA]
[Watt]
[A]
[mV]
p-p
All black pattern
(VDD=3.3V, at 60Hz)
All black pattern
(VDD=3.3V, at 60Hz)
Note 1; VDD=3.3v
Black Pattern, Rising
time=470us
All black pattern
(VDD=3.3v, at 60Hz)
ALL RIGHTS STRICTLY RESERVED. ANY PORTION OF THIS PAPER SHALL NOT BE REPRODUCED, COPIED, OR 10
TRANSFORMED TO ANY OTHER FORMS WITHOUT PREMISSION FROM PROMATE ELECTRONIC CO., LTD.
Promate Electronic Co., Ltd.| TEL: +886 (2) 2659 0303 | FAX: +886 (2) 2658 0954 | www.promate.com
4F, No. 32, Section 1, Huan Shan Road., Nei Hu District, Taipei 11442, Taiwan
www.DataSheet.in

11 Page







PáginasTotal 26 Páginas
PDF Descargar[ Datasheet 97G104V1N0F-2.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
97G104V1N0F-2TFT-LCD PanelPromate
Promate

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar