DataSheet.es    


PDF R5220x Data sheet ( Hoja de datos )

Número de pieza R5220x
Descripción PWM Step-down DC/DC Converter
Fabricantes RICOH electronics devices division 
Logotipo RICOH electronics devices division Logotipo



Hay una vista previa y un enlace de descarga de R5220x (archivo pdf) en la parte inferior de esta página.


Total 25 Páginas

No Preview Available ! R5220x Hoja de datos, Descripción, Manual

www.DataSheet4U.com
R5220x SERIES
PWM Step-down DC/DC Converter with switch function
NO.EA-121-070824
OUTLINE
The R5220x Series are CMOS-based PWM step-down DC/DC Converters with synchronous rectifier, low
supply current and LDO mode.
DC/DC converter of the R5220x consists of an oscillator, a PWM control circuit, a reference voltage unit, an
error amplifier, a soft-start circuit, protection circuits, a protection against miss operation under low voltage
(UVLO), PWM-DC to DC converter / LDO alternative circuit, a chip enable circuit, and a driver transistor. A high
efficiency step-down DC/DC converter can be easily composed of this IC with only a few kinds of external
components, or an inductor and capacitors.
LDO of the R5220x consists of a vortage reference unit, an error amplifier, resistors for voltage setting, output
current limit circuit, a driver transistor, and so on. The output voltage is fixed internally in the R5220x. The output
voltage of the DC/DC converter and the LDO can be set independently.
PWM step-down DC/DC converter / LDO alternative circuit is active with Mode Pin of the R5220x Series. Thus,
when the load current is small, the operation can be switching into the LDO operation from PWM operation by
the logic of MODE pin and the consumption current of the IC itself will be small at light load current. As protection
circuits, the current limit circuit which limits peak current of Lx at each clock cycle, and the latch type protection
circuit which works if the term of the over-current condition keeps on a certain time in PWM mode. Latch-type
protection circuit works to latch an internal driver with keeping it disable. To release the protection, after disable
this IC with a chip enable circuit, enable it again, or restart this IC with power-on or make the supply voltage at
UVLO detector threshold level or lower than UVLO.
FEATURES
Supply Current ................................................................ Typ. 350µA (DC/DC), Typ. 5µA (VR)
Standby Current .............................................................. Typ. 0.1µA
Built-in Driver ON Resistance ......................................... P-channel 0.5, N-channel 0.5(at VIN=3.6V)
Output Current ................................................................ Min. 400mA (DC/DC), Min. 50mA (VR)
Input Voltage ................................................................... 2.8V to 5.5V (Absolute Input Maximum: 6.5V)
Output Voltage ................................................................ 1.0V to 3.3V
Output Voltage Accuracy................................................. ±2.0% (VOUT >= 1.5), ±30mV (VOUT <1.5V)
Oscillator Frequency (DC/DC) ........................................ Typ. 1.2MHz
Package .......................................................................... SON-6, PLP2514-6
Built-in Soft-start Function............................................... Typ. 0.2ms
Latch-type Protection Function (Delay Time).................. Typ. 3.0ms
Built-in fold-back protection circuit (DC/DC, VR)
Ceramic Capacitor is recommended.
APPLICATIONS
Power source for portable equipment such as DSC, DVC, and communication equipment.
1

1 page




R5220x pdf
www.DataSheet4U.com
R5220x
R5220xxxxB
Symbol
Item
Conditions
VIN Operating Input Voltage
ISS1
Supply Current 1
(Standby mode)
VIN=VOUT1+1.0V, VCE=GND, VMODE=GND or VIN
VOUT1:DC/DC Set VOUT
ISS2
Supply Current 2
(Power Save mode)
VIN=VCE=VMODE=VOUT2+1.0V,
VOUT2:VR Set VOUT, IOUT=0mA
ISS3 Supply Current 3
VIN=VCE=3.6V, VMODE=GND
Min.
2.8
Typ.
0.1
5
350
Topt=25°C
Max. Unit
5.5 V
1.0 µA
10 µA
450 µA
DC/DC Part
Symbol
Item
VOUT1 Output Voltage
fosc Oscillator Frequency
TSTART Soft-start Time
RONP ON Resistance of Pch Transistor
RONN ON Resistance of Nch Transistor
ILXLEAK Lx Leakage Current
VOUT/ Output Voltage
Topt Temperature Coefficient
Maxduty Oscillator Maximum Duty Cycle
ILXlim Lx Current Limit
Tprot Protection Delay Circuit
VUVLO1 UVLO Threshold Voltage
VUVLO2 UVLO Released Voltage
VMODEH MODE "H" Input Voltage
VMODEL MODE "L" Input Voltage
Conditions
VIN=3.6V
VOUT1 >= 1.5
IOUT=50mA
VOUT1<1.5
VIN=VSET1+1.5V
VIN=3.6V
VOUT1<1.5
VOUT1 >= 1.5
VIN=3.6V, ILX=−100mA
VIN=3.6V, ILX=−100mA
VIN=5.5V, VCE=0V, LX=5.5V/0V
40°C <= Topt <= 85°C
VOUT=0V
VIN=3.6V
VIN=3.6V
VCE=VIN, VMODE=GND, VOUT=0V
VCE=VIN, VMODE=GND, VOUT=0V
Min.
×0.98
0.03
0.96
1.0
100
500
1.0
2.00
2.05
1.0
0
Typ.
1.20
0.15
0.20
0.5
0.5
±150
800
3.0
2.35
2.45
Topt=25°C
Max. Unit
×1.02
+0.03
V
1.44 MHz
0.30
0.35
ms
1.0 µA
ppm/°C
%
mA
7.0 ms
2.75 V
2.80 V
V
0.3 V
VR Part
Symbol
Item
Conditions
VOUT2 Output Voltage
VIN=VOUT2+1.0V
IOUT=10mA
VOUT2 >= 1.5
VOUT2<1.5
IOUT Output Current
VIN=VOUT2+1.0V
VOUT2/
IOUT
Load Regulation
VIN=VOUT2+1.0V
10µA <= IOUT <= 25mA
VOUT2<2.3
2.3 <= VOUT2<3.0
VOUT2 >= 3.0
VDIF Dropout Voltage
VOUT2/
VIN
Line Regulation
IOUT=50mA
2.8V <= VIN <= 5.5V
IOUT=25mA
VOUT2<1.8V
VOUT2 >= 1.8V
VOUT2<2.3V
VOUT2+0.5V <= VIN <= 5.5V
IOUT=25mA
VOUT2 >= 2.3V
RR Ripple Rejection
Refer to Typical Characteristics
VOUT/ Output Voltage
IOUT=30mA,
Topt Temperature Coefficient 40°C <= Topt <= 85°C
Ilim Short Current Limit
VOUT=0V
IPDC CE pull-down current
VCEH CE "H" Input Voltage
VCEL CE "L" Input Voltage
Min.
×0.98
0.03
50
0.12
1.0
0
Typ.
15
25
35
0.7
0.3
±100
60
0.40
Topt=25°C
Max. Unit
×1.02
+0.03
V
mA
40
50 mV
65
V
0.2 %/V
dB
ppm/°C
0.70
0.3
mA
µA
V
V
5

5 Page





R5220x arduino
TEST CIRCUITS
Lx VVIN
GGNNDD VVOUT
MMOODDEE CE
A
Supply Current 1,2,3
OSCILLOSCOPE
Lx
VVIN
GNNDD VVOUT
MOODDEE CE
Oscillator Frequency
Lx VVIN
GNNDD VVOUT
A
MOODDEE CE
Lx Leakage Current
www.DataSheet4U.com
R5220x
OSCILLOSCOPE
Lx
VVIN
GNNDD VVOUT
MOODDEE CE
Output Voltage(DC/DC)
OSCILLOSCOPE
Lx
VVIN
GNNDD VVOUT
MOODDEE CE
Soft-start Time
OSCILLOSCOPE
Lx
VVIN
GNNDD VVOUT
MOODDEE CE
Lx Current Limit, Output Delay for Protection
Lx Pch transistor ON resistance
Nch transistor ON resistance
11

11 Page







PáginasTotal 25 Páginas
PDF Descargar[ Datasheet R5220x.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
R5220xPWM Step-down DC/DC ConverterRICOH electronics devices division
RICOH electronics devices division

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar