DataSheet.es    


PDF LC75878E Data sheet ( Hoja de datos )

Número de pieza LC75878E
Descripción 1/8 to 1/10 Duty General-Purpose LCD Display Drivers
Fabricantes Sanyo Semicon Device 
Logotipo Sanyo Semicon Device Logotipo



Hay una vista previa y un enlace de descarga de LC75878E (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! LC75878E Hoja de datos, Descripción, Manual

Ordering number : ENN*6473
CMOS IC
LC75878E, 75878W
1/8 to 1/10 Duty General-Purpose LCD Display Drivers
Preliminary
Overview
The LC75878E and LC75878W are 1/8 to 1/10 duty
general-purpose LCD display drivers used for character
and graphics display. These products operate under the
control of a microcontroller and can directly drive an LCD
with up to 730 segments. They can also control up to 4
general-purpose output ports.
Features
• 1/8duty–1/4bias, 1/9duty–1/4bias, and 1/10duty–1/4bias
drive schemes can be controlled from serial data.
1/8duty–1/4bias: up to 600 segments
1/9duty–1/4bias: up to 666 segments
1/10duty–1/4bias: up to 730 segments
• Serial data input supports CCB format communication
with the system controller.
• Serial data control of the power-saving mode based
backup function and all the segments forced off
function.
• Direct display of display data without the use of a
decoder provides high generality.
• Built-in display contrast adjustment circuit.
• Up to 4 general-purpose output ports are included.
• Independent LCD driver block power supply VLCD.
• The INH pin is provided. This pin turns off the display
and forces the general-purpose output ports to the low
level.
• RC oscillator circuit
Package Dimensions
unit: mm
3151-QFP100E
[LC75878E]
0.575
80
81
0.65
23.2
20.0
0.3
1.6
0.575
51
50
0.15
100
1
31
30
0.1
2.7
21.6 0.8
SANYO: QFP100E
unit: mm
3181B-SQFP100
[LC75878W]
1.0 0.5
75
16.0
14.0
1.0
51
76
50
0.145
100
1
0.2
26
25 0.1
1.4
• CCB is a trademark of SANYO ELECTRIC CO., LTD.
• CCB is SANYO’s original bus format and all the bus
addresses are controlled by SANYO.
0.5 0.5
SANYO: SQFP100
Any and all SANYO products described or contained herein do not have specifications that can handle
applications that require extremely high levels of reliability, such as life-support systems, aircraft’s
control systems, or other applications whose failure can be reasonably expected to result in serious
physical and/or material damage. Consult with your SANYO representative nearest you before using
any SANYO products described or contained herein in such applications.
SANYO assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other
parameters) listed in products specifications of any and all SANYO products described or contained
herein.
SANYO Electric Co.,Ltd. Semiconductor Company
TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110-8534 JAPAN
41000RM (OT) No. 6473 -1/33

1 page




LC75878E pdf
LC75878E, 75878W
CONTRAST
ADJUSTER
• When CL is stopped at the low level
To the common and segment drivers
Figure 1
Excluding these resistors
• When CL is stopped at the high level
Figure 2
No. 6473-5/33

5 Page





LC75878E arduino
y When CL is stopped at the high level
• When the display data is transferred.
LC75878E, 75878W
CCB
address
8 bits
CCB
address
8 bits
CCB
address
8 bits
Display
data
135 bits
Display
data
135 bits
Display
data
135 bits
CCB
address
8 bits
Display
data
135 bits
CCB
address
8 bits
• When the control data is transferred.
Display
data
126 bits
CCB
address
8 bits
Control
data
13 bits
Note: B0 to B3, A0 to A3 ...... CCB address
DD ................................ Direction data
• CCB address: ...... 4BH
• D1 to D666: ........ Display data
• PC1 to PC4: ........ General-purpose output port state setting data
• CT0 to CT3, CTC: Display contrast setting data
• SC: ...................... Segment on/off control data
• BU: ...................... Normal mode/power saving mode control data
• DT1, DT2: ............ Display technique setting data
DD
3 bits
Fixed
data
6 bits
DD
3 bits
Fixed
data
6 bits
DD
3 bits
Fixed
data
6 bits
DD
3 bits
Fixed
data
6 bits
DD
3 bits
Fixed
data
15 bits
DD
3 bits
No. 6473-11/33

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet LC75878E.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
LC75878E1/8 to 1/10 Duty General-Purpose LCD Display DriversSanyo Semicon Device
Sanyo Semicon Device
LC75878W1/8 to 1/10 Duty General-Purpose LCD Display DriversSanyo Semicon Device
Sanyo Semicon Device
LC75878W1/8 to 1/10 Duty General-Purpose LCD Display DriverON Semiconductor
ON Semiconductor

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar