DataSheet.es    


PDF PCM4204 Data sheet ( Hoja de datos )

Número de pieza PCM4204
Descripción HIGH PERFORMANCE 24 BIT 216KHZ SAMPLING FOUR CHANNEL AUDIO ANALOG TO DIGITAL CONVERTER
Fabricantes Burr-Brown Corporation 
Logotipo Burr-Brown Corporation Logotipo



Hay una vista previa y un enlace de descarga de PCM4204 (archivo pdf) en la parte inferior de esta página.


Total 30 Páginas

No Preview Available ! PCM4204 Hoja de datos, Descripción, Manual

PCM4204
www.DataSheet4U.com
SBAS327A − JUNE 2004 − REVISED SEPTEMBER 2004
HighĆPerformance 24ĆBit, 216kHz Sampling
FourĆChannel Audio AnalogĆtoĆDigital Converter
FEATURES
D Four High-Performance Delta-Sigma
Analog-to-Digital Converters
− 24-Bit Linear PCM or 1-Bit Direct Stream
Digital (DSD) Output Data
− Supports PCM Output Sampling Rates up
to 216kHz
− Supports 64fS and 128fS DSD Output Data
Rates
D Dynamic Performance: PCM Output
− Dynamic Range: 118dB
− THD+N: −105dB
D Dynamic Performance: DSD Output
− Dynamic Range: 115dB
− THD+N: −103dB
D Audio Serial Port
− 24-Bit Linear PCM Output Data
− Master or Slave Mode Operation
− Supports Left-Justified, Right-Justified,
I2S, and TDM Data Formats
D DSD Data Port
− Supports DSD Output or Input for All Four
Channels Simultaneously
− Input Mode Provides 1-Bit DSD to 24-Bit
PCM Data Format Conversion
D Additional PCM Output Features
− Linear-Phase Digital Decimation Filter
− Digital High-Pass Filter for DC Removal
− Clipping Flag Output for Each Channel
D Power Supplies: +5V Analog and +3.3V Digital
D Power Dissipation:
− fS = 48kHz: 600mW typical
− fS = 96kHz: 640mW typical
− fS = 192kHz: 615mW typical
D Power-Down Mode
D Available in a Thermally-Enhanced HTQFP-64
Package
APPLICATIONS
D Digital Recorders and Mixing Desks
D Digital Audio Effects Processors
D Broadcast Studio Equipment
D Surround Sound Encoders
D High-End A/V Receivers
DESCRIPTION
The PCM4204 is a high-performance, four-channel
analog-to-digital (A/D) converter designed for professional
and broadcast audio applications. The PCM4204
architecture utilizes a 1-bit delta-sigma modulator per
channel incorporating a novel density modulated dither
scheme for improved dynamic performance.
The PCM4204 supports 24-bit linear PCM output data,
with sampling frequencies up to 216kHz. The PCM4204
can also be configured to output either 64x or 128x
oversampled, 1-bit direct stream digital (DSD) data for
each channel. In addition, the PCM4204 supports a DSD
input mode, allowing 1-bit DSD to 24-bit PCM data format
conversion utilizing the on-chip digital decimation filter.
These features make the PCM4204 suitable for a variety
of digital audio recording and processing applications.
The PCM4204 includes a flexible audio serial port inter-
face, which supports standard PCM audio data formats, as
well as time division multiplexed (TDM) PCM data formats.
Multiple format support allows the system designer to
choose the interface format that best suits the end applica-
tion. Audio data format selection, sampling mode configu-
ration, and high-pass filter functions are all programmed
using dedicated control pins.
The PCM4204 operates from a +5V analog power
supply and a +3.3V digital power supply. The digital I/O
pins are compatible with +3.3V logic families. The
PCM4204 is available in a thermally-enhanced HTQFP-64
PowerPADpackage.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas Instruments
semiconductor products and disclaimers thereto appears at the end of this data sheet.
PowerPAD is a registered trademark of Texas Instruments. All other trademarks are the property of their respective owners.
PRODUCTION DATA information is current as of publication date. Products
conform to specifications per the terms of Texas Instruments standard warranty.
Production processing does not necessarily include testing of all parameters.
Copyright 2004, Texas Instruments Incorporated
www.ti.com

1 page




PCM4204 pdf
PCM4204
www.ti.com
SBAS327A − JUNE 200w4 w− RwE.DVIaStEaDSShEePeTtE4MUB.cEoRm2004
ELECTRICAL CHARACTERISTICS (continued)
Unless otherwise noted, all characteristics specified with TA = +25°C, VCC = +5V, VDD = +3.3V, system clock (SCKI) is 512fS for Single Rate
Sampling, 256fS for Dual Rate Sampling, or 128fS for Quad Rate Sampling. The device is operated in Master mode for all dynamic performance
measurements.
PCM4204
PARAMETER
TEST CONDITIONS
MIN TYP MAX UNIT
DIGITAL DECIMATION FILTER (continued)
Quad Rate Sampling Mode
Passband Edge
Passband Ripple
Stop Band Edge
Stop Band Attenuation
Group Delay
DIGITAL HIGH PASS FILTER
−0.005dB
−3dB
0.770fS
−135
9.5/fS
0.375fS
0.490fS
±0.005
Hz
Hz
dB
Hz
dB
sec
Frequency Response (−3dB)
POWER SUPPLY
fS/48000
Hz
Voltage Range
VCC1, VCC2
VDD1, VDD2, VDD3
+4.75 +5.0 +5.25 VDC
+3.0 +3.3 +3.6 VDC
Power Down Supply Current
ICC1 + ICC2
IDD1 + IDD2 + IDD3
VCC = +5V, VDD = +3.3V, RST = Low
10 mA
2 mA
Quiescent Current
ICC1 + ICC2
VCC = +5.0V
fS = 48kHz(4)
fS = 96kHz
fS = 192kHz
108 130 mA
108 130 mA
108 130 mA
IDD1 + IDD2 + IDD3
VDD = +3.3V
fS = 48kHz(4)
fS = 96kHz
fS = 192kHz
18 23 mA
30 44 mA
23 26 mA
Total Power Dissipation
VCC = +5V, VDD = +3.3V
fS = 48kHz(4)
fS = 96kHz
fS = 192kHz
600 726 mW
640 795 mW
615 736 mW
(1) Applies to the FMT0, FMT1, FMT2, S/M, FS0, FS1, FS2, HPFD, BCK, LRCK, SUB, DSDCLK, DSD1, DSD2, DSD3, DSD4, and SCKI pins.
(2) Applies to the TEST and RST pins.
(3) Typical performance is measured using an Audio Precision System Two Cascade or Cascade Plus test system. The measurement bandwidth
is limited using the Audio Precision 22Hz high-pass filter in combination with either a 20kHz low-pass filter for fS = 48kHz or a 40kHz low-pass
filter for fS = 96kHz and 192kHz. All A-weighted measurements are performed using the A-weighting filter in combination with the band limiting
filters already mentioned. The measurements are made with the RMS detector selected.
(4) A 256fS system clock is used at final production test for fS = 48kHz measurements.
(5) Typical DSD performance is measured using an Audio Precision System Two Cascade or Cascade Plus test system. The measurement
bandwidth is limited using the Audio Precision 22Hz high-pass filter in combination with a 20kHz low-pass filter. All A-weighted measurements
are performed using the A-weighting filter in combination with the band limiting filter already mentioned. The measurements are made with the
RMS detector selected. The 1-bit DSD data is converted to 24-bit linear PCM data for measurement using a PCM4204 configured for DSD input
mode.
5

5 Page





PCM4204 arduino
PCM4204
www.ti.com
SBAS327A − JUNE 200w4 w− RwE.DVIaSEtaDSShEePeTtE4MUB.cEoRm2004
TYPICAL CHARACTERISTICS (continued)
At TA = +25°C with VCC = +5V, VDD = +3.3V, and a measurement bandwidth from 20Hz to 20kHz, unless otherwise noted.
5
20
40
60
80
100
0
HIGH PASS FILTER
STOP BAND CHARACTERISTICS
0.1 0.2 0.3
Normalized Frequency (fS/1000)
0.4
0.02
HIGH PASS FILTER
PASSBAND CHARACTERISTICS
0
0.02
0.04
0.06
0.08
0.1
0 0.5 1 1.5 2 2.5 3 3.5 4
Normalized Frequency (fS/1000)
0
20
40
60
80
100
120
140
160
180
20
FFT PLOT
(fS = 48kHz, fIN = 997Hz at 20dB)
100 1k
Frequency (Hz)
10k 20k
0
20
40
60
80
100
120
140
160
180
20
FFT PLOT
(fS = 48kHz, fIN = 997Hz at 60dB)
100 1k
Frequency (Hz)
10k 20k
0
20
40
60
80
100
120
140
160
180
20
FFT PLOT
(fS = 48kHz, No Input [Idle])
100 1k
Frequency (Hz)
10k 20k
0
20
40
60
80
100
120
140
160
180
20
FFT PLOT
(fS = 96kHz, fIN = 997Hz at 20dB)
100 1k
Frequency (Hz)
10k 40k
11

11 Page







PáginasTotal 30 Páginas
PDF Descargar[ Datasheet PCM4204.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
PCM4201Low Power 24-Bit Single Channel Audio Analog-to-Digital Converter (Rev. B)Texas Instruments
Texas Instruments
PCM4201Low Power 24-Bit Single Channel Audio Analog-to-Digital ConverterBurr-Brown Corporation
Burr-Brown Corporation
PCM4202High-Performance 24-Bit/ 216kHz Sampling Stereo Audio Analog-to-Digital ConverterBurr-Brown Corporation
Burr-Brown Corporation
PCM4202PCM4202: High Performance 24-Bit 216kHz Sampling Stereo Audio A/D Converter (Rev. B)Texas Instruments
Texas Instruments

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar