|
|
PDF EBE11ED8AGFA Data sheet ( Hoja de datos )
| Número de pieza | EBE11ED8AGFA | |
| Descripción | 1GB Unbuffered DDR2 SDRAM DIMM | |
| Fabricantes | Elpida Memory | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de EBE11ED8AGFA (archivo pdf) en la parte inferior de esta página. Total 23 Páginas | ||
|
No Preview Available !
DATA SHEET
www.DataSheet4U.com
1GB Unbuffered DDR2 SDRAM DIMM
EBE11ED8AGFA (128M words × 72 bits, 2 Ranks)
Description
The EBE11ED8AGFA is 128M words × 72 bits, 2 ranks
DDR2 SDRAM unbuffered module, mounting 18 pieces
of 512M bits DDR2 SDRAM sealed in FBGA (µBGA)
package. Read and write operations are performed at
the cross points of the CK and the /CK. This high-
speed data transfer is realized by the 4 bits prefetch-
pipelined architecture. Data strobe (DQS and /DQS)
both for read and write are available for high speed and
reliable data bus design. By setting extended mode
register, the on-chip Delay Locked Loop (DLL) can be
set enable or disable. This module provides high
density mounting without utilizing surface mount
technology. Decoupling capacitors are mounted
beside each FBGA (µBGA) on the module board.
Note: Do not push the components or drop the
modules in order to avoid mechanical defects,
which may result in electrical defects.
Features
• 240-pin socket type dual in line memory module
(DIMM)
PCB height: 30.0mm
Lead pitch: 1.0mm
Lead-free (RoHS compliant)
• Power supply: VDD = 1.8V ± 0.1V
• Data rate: 667Mbps/533Mbps/400Mbps (max.)
• SSTL_18 compatible I/O
• Double-data-rate architecture: two data transfers per
clock cycle
• Bi-directional, differential data strobe (DQS and
/DQS) is transmitted/received with data, to be used in
capturing data at the receiver
• DQS is edge aligned with data for READs: center-
aligned with data for WRITEs
• Differential clock inputs (CK and /CK)
• DLL aligns DQ and DQS transitions with CK
transitions
• Commands entered on each positive CK edge: data
and data mask referenced to both edges of DQS
• Four internal banks for concurrent operation
(components)
• Data mask (DM) for write data
• Burst lengths: 4, 8
• /CAS Latency (CL): 3, 4, 5
• Auto precharge operation for each burst access
• Auto refresh and self refresh modes
• Average refresh period
7.8µs at 0°C ≤ TC ≤ +85°C
3.9µs at +85°C < TC ≤ +95°C
• Posted CAS by programmable additive latency for
better command and data bus efficiency
• Off-Chip-Driver Impedance Adjustment and On-Die-
Termination for better signal quality
• /DQS can be disabled for single-ended Data Strobe
operation
Document No. E0784E20 (Ver. 2.0)
Date Published October 2005 (K) Japan
Printed in Japan
URL: http://www.elpida.com
Elpida Memory, Inc. 2005
1 page  
EBE11ED8AGFA
Serial PD Matrix
www.DataSheet4U.com
Byte No.
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
Function described
Bit7 Bit6 Bit5 Bit4 Bit3 Bit2 Bit1 Bit0 Hex value Comments
Number of bytes utilized by module
manufacturer
1
0
0
0
0
0
0
0
80H
Total number of bytes in serial PD
device
0
0
0
0
1
0
0
0
08H
Memory type
0 0 0 0 1 0 0 0 08H
128 bytes
256 bytes
DDR2 SDRAM
Number of row address
0 0 0 0 1 1 1 0 0EH
14
Number of column address
0 0 0 0 1 0 1 0 0AH
10
Number of DIMM ranks
0 1 1 0 0 0 0 1 61H
2
Module data width
0 1 0 0 1 0 0 0 48H
72
Module data width continuation
Voltage interface level of this
assembly
DDR SDRAM cycle time, CL = 5
-6E
-5C
-4A
SDRAM access from clock (tAC)
-6E
-5C
-4A
0 0 0 0 0 0 0 0 00H
0 0 0 0 0 1 0 1 05H
0 0 1 1 0 0 0 0 30H
0 0 1 1 1 1 0 1 3DH
0 1 0 1 0 0 0 0 50H
0 1 0 0 0 1 0 1 45H
0 1 0 1 0 0 0 0 50H
0 1 1 0 0 0 0 0 60H
0
SSTL 1.8V
3.0ns*1
3.75ns*1
5.0ns*1
0.45ns*1
0.5ns*1
0.6ns*1
DIMM configuration type
0 0 0 0 0 0 1 0 02H
ECC
Refresh rate/type
1 0 0 0 0 0 1 0 82H
7.8µs
Primary SDRAM width
0 0 0 0 1 0 0 0 08H
×8
Error checking SDRAM width
0 0 0 0 1 0 0 0 08H
×8
Reserved
0 0 0 0 0 0 0 0 00H
0
SDRAM device attributes:
Burst length supported
0 0 0 0 1 1 0 0 0CH
SDRAM device attributes: Number of
banks on SDRAM device
0
0
0
0
0
1
0
0
04H
SDRAM device attributes:
/CAS latency
0 0 1 1 1 0 0 0 38H
DIMM Mechanical Characteristics 0 0 0 0 0 0 0 1 01H
4,8
4
3, 4, 5
4.00mm max.
DIMM type information
0 0 0 0 0 0 1 0 02H
Unbuffered
SDRAM module attributes
0 0 0 0 0 0 0 0 00H
SDRAM device attributes: General 0 0 0 0 0 0 1 1 03H
Minimum clock cycle time at CL = 4
-6E, -5C
0
0
1
1
1
1
0
1
3DH
-4A 0 1 0 1 0 0 0 0 50H
Normal
Weak Driver
50Ω ODT Support
3.75ns*1
5.0ns*1
Maximum data access time (tAC)
from clock at CL = 4
-6E, -5C
01
01
00
00
50H
-4A 0 1 1 0 0 0 0 0 60H
Minimum clock cycle time at CL = 3 0 1 0 1 0 0 0 0 50H
0.5ns*1
0.6ns*1
5.0ns*1
Maximum data access time (tAC)
from clock at CL = 3
01
10
00
00
60H
0.6ns*1
Minimum row precharge time (tRP) 0 0 1 1 1 1 0 0 3CH
Minimum row active to row active
delay (tRRD)
00
01
11
10
1EH
15ns
7.5ns
Data Sheet E0784E20 (Ver. 2.0)
5
5 Page 
EBE11ED8AGFA
DC Characteristics 1 (TC = 0°C to +85°C, VDD = 1.8V ± 0.1V, VSS = 0V)
www.DataSheet4U.com
Parameter
Symbol
Operating current
(ACT-PRE)
IDD0
(Another rank is in IDD2P)
Operating current
(ACT-PRE)
IDD0
(Another rank is in IDD3N)
Grade
-6E
-5C
-4A
-6E
-5C
-4A
Operating current
(ACT-READ-PRE)
IDD1
(Another rank is in IDD2P)
-6E
-5C
-4A
Operating current
(ACT-READ-PRE)
IDD1
(Another rank is in IDD3N)
-6E
-5C
-4A
Precharge power-down
standby current
IDD2P
-6E
-5C
-4A
max.
1125
1080
927
1665
1575
1395
1260
1215
1062
1800
1710
1530
180
180
144
Precharge quiet standby
current
IDD2Q
-6E
-5C
-4A
450
450
360
Idle standby current
IDD2N
-6E
-5C
-4A
Active power-down
standby current
-6E
IDD3P-F -5C
-4A
-6E
IDD3P-S -5C
-4A
Active standby current
IDD3N
-6E
-5C
-4A
Operating current
(Burst read operating)
IDD4R
(Another rank is in IDD2P)
Operating current
(Burst read operating)
IDD4R
(Another rank is in IDD3N)
Operating current
(Burst write operating)
IDD4W
(Another rank is in IDD2P)
Operating current
(Burst write operating)
IDD4W
(Another rank is in IDD3N)
Auto-refresh current
(Another rank is in IDD2P)
IDD5
Auto-refresh current
(Another rank is in IDD3N)
IDD5
-6E
-5C
-4A
-6E
-5C
-4A
-6E
-5C
-4A
-6E
-5C
-4A
-6E
-5C
-4A
-6E
-5C
-4A
630
540
450
720
720
630
450
450
360
1260
1170
1080
2160
1800
1422
2700
2295
1890
2070
1800
1422
2610
2295
1890
2520
2340
2142
3060
2835
2610
Unit Test condition
mA
one bank; tCK = tCK (IDD), tRC = tRC (IDD),
tRAS = tRAS min.(IDD);
CKE is H, /CS is H between valid commands;
Address bus inputs are SWITCHING;
mA Data bus inputs are SWITCHING
one bank; IOUT = 0mA;
mA BL = 4, CL = CL(IDD), AL = 0;
tCK = tCK (IDD), tRC = tRC (IDD),
tRAS = tRAS min.(IDD); tRCD = tRCD (IDD);
CKE is H, /CS is H between valid commands;
mA Address bus inputs are SWITCHING;
Data pattern is same as IDD4W
all banks idle;
tCK = tCK (IDD);
mA CKE is L;
Other control and address bus inputs are STABLE;
Data bus inputs are FLOATING
all banks idle;
tCK = tCK (IDD);
mA CKE is H, /CS is H;
Other control and address bus inputs are STABLE;
Data bus inputs are FLOATING
all banks idle;
tCK = tCK (IDD);
mA CKE is H, /CS is H;
Other control and address bus inputs are SWITCHING;
Data bus inputs are SWITCHING
all banks open;
mA tCK = tCK (IDD);
CKE is L;
Fast PDN Exit
MRS(12) = 0
Other control and address bus
mA
inputs are STABLE;
Slow PDN Exit
Data bus inputs are FLOATING MRS(12) = 1
all banks open;
tCK = tCK (IDD), tRAS = tRAS max.(IDD), tRP = tRP (IDD);
mA CKE is H, /CS is H between valid commands;
Other control and address bus inputs are SWITCHING;
Data bus inputs are SWITCHING
all banks open, continuous burst reads, IOUT = 0mA;
mA BL = 4, CL = CL(IDD), AL = 0;
tCK = tCK (IDD), tRAS = tRAS max.(IDD), tRP = tRP (IDD);
CKE is H, /CS is H between valid commands;
mA Address bus inputs are SWITCHING;
Data pattern is same as IDD4W
all banks open, continuous burst writes;
mA BL = 4, CL = CL(IDD), AL = 0;
tCK = tCK (IDD), tRAS = tRAS max.(IDD), tRP = tRP (IDD);
CKE is H, /CS is H between valid commands;
mA Address bus inputs are SWITCHING;
Data bus inputs are SWITCHING
mA tCK = tCK (IDD);
Refresh command at every tRFC (IDD) interval;
CKE is H, /CS is H between valid commands;
Other control and address bus inputs are SWITCHING;
mA Data bus inputs are SWITCHING
Data Sheet E0784E20 (Ver. 2.0)
11
11 Page | ||
| Páginas | Total 23 Páginas | |
| PDF Descargar | [ Datasheet EBE11ED8AGFA.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| EBE11ED8AGFA | 1GB Unbuffered DDR2 SDRAM DIMM | Elpida Memory |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |