|
|
Número de pieza | SC7422 | |
Descripción | 2CH AUDIO POWER AMPLIFIER | |
Fabricantes | Silan Microelectronics | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de SC7422 (archivo pdf) en la parte inferior de esta página. Total 8 Páginas | ||
No Preview Available ! SC7422
2-CH AUDIO POWER AMPLIFIER 2W x 2
DESCRIPTION
The SC7422 is a class AB power amplifier which designed for dual
audio purpose. It can deliver 2W × 2 power output to the 4 load in the
5V operation voltage. Total harmonic distortion is lower than 0.03%. The
output mode can be switched between the SE and BTL mode. The
volume also can be changed by a 32 steps volume controller. Moreover,
the SC7422 requires a few extra components in the application. It is
suitable for small or portable products.
SOP-16-375-1.27
FEATURES
* Operation voltage : 5V
* Output power : 2W×2(RL=4 )
* Low harmonics distortion (THD=0.03%)
* 32 steps volume control with 1.5dB per step from -45dB to 0dB
* Two output modes (SE and BTL) switched
* Low quiescent operation current
* No POPO noise when turn on/off
* Standby function, Low standby current(Is<0.7 A)
* Thermally protected
DIP-16-300-2.54
ORDERING INFORMATION
Device
SC7422
SC7422S
Package
DIP-16-300-2.54
SOP-16-375-1.27
APPLICATIONS
* LCD Monitors for TV
* Portable audio
* Multimedia audio
* Other audio applications
www.DataSheet4U.com
BLOCK DIAGRAM
HANGZHOU SILAN MICROELECTRONICS CO.,LTD
Http: www.silan.com.cn
REV:1.0 2006.11.13
Page 1 of 8
1 page SC7422
(Continued)
Step
Volume
(dB)
6 -7.5
7 -9
8 -10.5
9 -12
10 -13.5
11 -15
12 -16.5
13 -18
14 -19.5
15 -21
16 -22.5
DC Vol
VH(%)
57.9
56.1
54.1
52.1
49.4
47.5
45.5
44.0
41.8
39.8
38.3
DC Vol
VL(%)
56.0
54.0
51.8
48.8
47.4
45.4
43.6
41.6
39.8
37.6
36.6
Step
22
23
24
25
26
27
28
29
30
31
32
Volume
(dB)
31.5
-33
-34.5
-36
-37.5
-39
-40.5
-42
-43.5
-45
MUTE
DC Vol
VH(%)
26.2
24.0
22.5
20.4
18.0
15.1
13.1
10.6
8.8
6.7
4.3
DC Vol
VL(%)
21.8
20.0
18.0
14.4
13.0
11.0
9.0
7.2
5.4
3.0
GND
Output Mode Control
The output mode of the SC7422 can be switched between the SE (Single-Ended) and BTL (Bridge-Tied Load)
mode. It is recommended to apply BTL mode to obtain more output power while driving the loud speaker. SE
mode can be set to shutdown some parts of amplifiers while driving the stereo headphone. Therefore, the
quiescent operation current is reduced.
POPO Noise Suppress
When an audio power amplifier with a single supply turns on, the POPO Noise can be heard. The reason is that
the output voltage of amplifier would take hundreds of milliseconds to increase from 0V to 1/2 Vcc.
This time is controlled by CB, the external capacitor of Bypass pin. As the CB was increasing, the time is longer,
www.DataShseoeti4t Uis.cmomuch better to suppress POPO noise. However, the charging and discharging time for the input or output
capacitors should be less than this time. Therefore, CB is related with the input or output capacitors. The values
of these capacitors are recommended in the typical application circuit.
Thermally protected
There is a thermally protected protection circuit in the SC7422. If the chip temperature is over 120°C, the
protection circuit will start up to shutdown the output stages of audio power amplifier. The chip will return to the
normal operation, until the chip temperature falls to 80°C.
Power Dissipation and Heat Sinking
When the load is a resistor, the maximum of average power dissipation for the SC7422 is calculated as follows:
PDISS(MAX) = 2(2Vcc)2 / (2π2RL) + PQ
Where Vcc is the operation voltage, RL is the load resistor, PQ is the static power consumption.
PQ=VCC×Is
Where Is is the operation current. For example, if the SC7422 drives the 4 load in 5V supply, the power
dissipation is 2.6W.
HANGZHOU SILAN MICROELECTRONICS CO.,LTD
Http: www.silan.com.cn
REV:1.0 2006.11.13
Page 5 of 8
5 Page |
Páginas | Total 8 Páginas | |
PDF Descargar | [ Datasheet SC7422.PDF ] |
Número de pieza | Descripción | Fabricantes |
SC742110 | Power Solid State Relay | celduc-relais |
SC7422 | 2CH AUDIO POWER AMPLIFIER | Silan Microelectronics |
SC7422S | 2CH AUDIO POWER AMPLIFIER | Silan Microelectronics |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |