|
|
PDF OB2263 Data sheet ( Hoja de datos )
| Número de pieza | OB2263 | |
| Descripción | Current Mode PWM Controller | |
| Fabricantes | On-Bright | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de OB2263 (archivo pdf) en la parte inferior de esta página. Total 13 Páginas | ||
|
No Preview Available !
OB2263
www.DataSheet4U.com
Current Mode PWM ControllerFrequency Shuffling
GENERAL DESCRIPTION
OB2263 is a highly integrated current mode PWM
control IC optimized for high performance, low
standby power and cost effective offline flyback
converter applications in sub 30W range.
PWM switching frequency at normal operation is
externally programmable and trimmed to tight range.
At no load or light load condition, the IC operates in
extended ‘burst mode’ to minimize switching loss.
Lower standby power and higher conversion
efficiency is thus achieved.
VDD low startup current and low operating current
contribute to a reliable power on startup design with
OB2263. A large value resistor could thus be used in
the startup circuit to minimize the standby power.
The internal slope compensation improves system
large signal stability and reduces the possible sub-
harmonic oscillation at high PWM duty cycle output.
Leading-edge blanking on current sense(CS) input
removes the signal glitch due to snubber circuit diode
reverse recovery and thus greatly reduces the external
component count and system cost in the design.
OB2263 offers complete protection coverage with
automatic self-recovery feature including Cycle-by-
Cycle current limiting (OCP), over load protection
(OLP), VDD over voltage clamp and under voltage
lockout (UVLO). The Gate-drive output is clamped
to maximum 18V to protect the power MOSFET.
Excellent EMI performance is achieved with On-
Bright proprietary frequency shuffling technique
together with soft switching control at the totem pole
gate drive output.
Tone energy at below 20KHZ is minimized in the
design and audio noise is eliminated during operation.
OB2263 is offered in SOT23-6, SOP-8 and DIP-8
packages.
FEATURES
■ On-Bright Proprietary Frequency Shuffling
Technology for Improved EMI Performance.
■ Extended Burst Mode Control For Improved
Efficiency and Minimum Standby Power Design
■ Audio Noise Free Operation
■ External Programmable PWM Switching
Frequency
■ Internal Synchronized Slope Compensation
■ Low VDD Startup Current and Low Operating
Current (1.4mA)
■ Leading Edge Blanking on Current Sense Input
■ Good Protection Coverage With Auto Self-
Recovery
o VDD Over Voltage Clamp and Under Voltage
Lockout with Hysteresis (UVLO)
o Gate Output Maximum Voltage Clamp (18V)
o On-Bright Proprietary Line Input Compensated
Cycle-by-Cycle Over-current Threshold Setting
For Constant Output Power Limiting Over
Universal Input Voltage Range.
o Overload Protection (OLP)
APPLICATIONS
Offline AC/DC flyback converter for
■ Battery Charger
■ Power Adaptor
■ Set-Top Box Power Supplies
■ Open-frame SMPS
TYPICAL APPLICATION
©On-Bright Electronics
Confidential to Micro Bridge
-1-
OB_DOC_DS_63B5
1 page  
OB2263
www.DataSheet4U.com
Current Mode PWM ControllerFrequency Shuffling
ELECTRICAL CHARACTERISTICS
(TA = 25OC if not otherwise noted)
Symbol
Parameter
Test Conditions
Min Typ Max Unit
Supply Voltage (VDD)
I_VDD_Startup VDD Start up
VDD =12.5V, RI=100K
3 20 uA
Current
Measure Leakage current
into VDD
I_VDD_Ops
Operation Current
VDD=16V,
1.4 mA
UVLO(ON)
RI=100Kohm, VFB=3V
VDD Under Voltage
7.8 8.8 9.8 V
Lockout Enter
UVLO(OFF)
VDD Under Voltage
13 14 15 V
Lockout Exit
(Recovery)
VDD_Clamp
VDD Zener Clamp
Voltage
IVDD = 5 mA
34 V
Feedback Input Section(FB Pin)
AVCS
PWM Input Gain
VFB_Open
VFB Open Loop
Voltage
IFB_Short
FB pin short circuit
current
VTH_0D
Zero Duty Cycle FB
Threshold Voltage
VTH_PL
Power Limiting FB
Threshold Voltage
TD_PL
Power limiting
Debounce Time
ZFB_IN
Input Impedance
DC_MAX
Maximum Duty
Cycle
ΔVFB /ΔVcs
Short FB pin to GND and
measure current
VDD = 16V,
RI=100Kohm
VDD=18V,
RI=100Kohm, FB=3V,
CS=0
2.0 V/V
4.8 V
1.2 mA
0.75 V
3.7 V
35 mSec
6 Kohm
75 %
Current Sense Input(Sense Pin)
T_blanking
Leading edge
RI = 100 Kohm
300 ns
blanking time
ZSENSE_IN
TD_OC
Input Impedance
Over Current
Detection and
Control Delay
VDD = 16V,
CS>VTH_OC, FB=3.3V
40
75
Kohm
nSec
VTH_OC
Over Current
FB=3.3V, RI=100 Kohm 0.70 0.75 0.80 V
Threshold Voltage at
zero Duty Cycle
Oscillator
FOSC
Normal Oscillation
Frequency
RI = 100 Kohm
60 65 70 KHZ
∆f_Temp
∆f_VDD
RI_range
V_RI_open
Frequency
Temperature Stability
Frequency Voltage
Stability
Operating RI Range
RI open load voltage
VDD = 16V,
RI=100Kohm, TA -20oC
to 100 oC
VDD = 12-25V,
RI=100Kohm
50
5%
5%
100 150 Kohm
2V
©On-Bright Electronics
Confidential to Micro Bridge
- 5 - OB_DOC_DS_63B5
5 Page 
www.DataSheet4U.com
PACKAGE MECHANICAL DATA
SOT23-6
OB2263
Current Mode PWM ControllerFrequency Shuffling
©On-Bright Electronics
- 11 -
Confidential to Micro Bridge
OB_DOC_DS_63B5
11 Page | ||
| Páginas | Total 13 Páginas | |
| PDF Descargar | [ Datasheet OB2263.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| OB2262 | Current Mode PWM Controller | On-Bright |
| OB2262 | 15W Adapter Module Design | On-Bright |
| OB2263 | Current Mode PWM Controller | On-Bright |
| OB2268 | (OB2268 / OB2269) Current Mode PWM Controller |  Liteon |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |