DataSheet.es    

PDF MR-E-200A-QW003 Data sheet ( Hoja de datos )

Número de pieza MR-E-200A-QW003
Descripción General Purpose AC Servo
Fabricantes MITSUBISHI 
Logotipo MITSUBISHI Logotipo



Total 70 Páginas
		
MR-E-200A-QW003 Hoja de datos, Descripción, Manual
General-Purpose AC Servo
EZMOTION MR-E Super
General-Purpose Interface
MODEL
MR-E-
www.DataSheet4U.com
MR-E-
A-QW003
AG-QW003
INSTRUCTION MANUAL

1 page

MR-E-200A-QW003 pdf
(2) Wiring
CAUTION
Wire the equipment correctly and securely. Otherwise, the servo motor may operate unexpectedly.
Do not install a power capacitor, surge absorber or radio noise filter (FR-BIF option) between the servo
motor and servo amplifier.
Connect the wires to the correct phase terminals (U, V, W) of the servo amplifier and servo motor.
Otherwise, the servo motor does not operate properly.
www.DataSheet4U.cCoomnnect the servo motor power terminal (U, V, W) to the servo motor power input terminal (U, V, W)
directly. Do not let a magnetic contactor, etc. intervene.
Servo amplifier
U
V
W
Servo motor
U
V
M
W
Servo amplifier
U
V
W
Servo motor
U
V
M
W
Do not connect AC power directly to the servo motor. Otherwise, a fault may occur.
The surge absorbing diode installed on the DC output signal relay of the servo amplifier must be wired in
the specified direction. Otherwise, the emergency stop and other protective circuits may not operate.
Servo amplifier
SG
Servo amplifier
SG
Control output
signal
RA
Control output
signal
RA
When the cable is not tightened enough to the terminal block (connector), the cable or terminal block
(connector) may generate heat because of the poor contact. Be sure to tighten the cable with specified
torque.
(3) Test run adjustment
CAUTION
Before operation, check the parameter settings. Improper settings may cause some machines to perform
unexpected operation.
The parameter settings must not be changed excessively. Operation will be insatiable.
A- 4

5 Page

MR-E-200A-QW003 arduino
CONFORMANCE WITH UL/C-UL STANDARD
(1) Servo amplifiers and servo motors used
Use the servo amplifiers and servo motors which comply with the standard model.
Servo amplifier :MR-E-10A-QW003 to MR-E-200A-QW003
MR-E-10AG-QW003 to MR-E-200AG-QW003
Servo motor :HF-KE W1-S100
HF-SE JW1-S100
www.DataSheet(42U).cInomstallation
Install a cooling fan of 100CFM (2.8 m3/min) air flow 4 in (10.16 cm) above the servo amplifier or provide
cooling of at least equivalent capability.
(3) Short circuit rating: SCCR (Short Circuit Current Rating)
This servo amplifier conforms to the circuit whose peak current is limited to 100kA or less. Having been
subjected to the short-circuit tests of the UL in the alternating-current circuit, the servo amplifier conforms to
the above circuit.
(4) Capacitor discharge time
The capacitor discharge time is as listed below. To ensure safety, do not touch the charging section for 15
minutes after power-off.
Servo amplifier
MR-E-10A-QW003
MR-E-10AG-QW003
MR-E-20A-QW003
MR-E-20AG-QW003
MR-E-40A-QW003
MR-E-40AG-QW003
MR-E-70A-QW003 to MR-E-200AG-QW003
MR-E-70AG-QW003 to MR-E-200AG-QW003
Discharge time
[min]
1
2
3
(5) Options and auxiliary equipment
Use UL/C-UL standard-compliant products.
(6) About wiring protection
For installation in United States, branch circuit protection must be provided, in accordance with the National
Electrical Code and any applicable local codes.
For installation in Canada, branch circuit protection must be provided, in accordance with the Canada
Electrical Code and any applicable provincial codes.
<<About the manuals>>
Relevant manuals
Manual name
MR-E Series Instructions and Cautions for Safe Use of AC Servos
EMC Installation Guidelines
Manual No.
IB(NA)0300057
IB(NA)67310
A - 10

11 Page


PáginasTotal 70 Páginas
PDF Descargar[ Datasheet MR-E-200A-QW003.PDF ]

Enlace url


Hoja de datos destacado

Número de piezaDescripciónFabricantes
MR-E-200A-QW003General Purpose AC ServoMITSUBISHI
MITSUBISHI
MR-E-200A-QW003EZ Motion E SerialMITSUBISHI
MITSUBISHI

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


www.DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar