DataSheet.es    


PDF TGS2602-A00 Data sheet ( Hoja de datos )

Número de pieza TGS2602-A00
Descripción Gas Sense
Fabricantes Figaro 
Logotipo Figaro Logotipo



Hay una vista previa y un enlace de descarga de TGS2602-A00 (archivo pdf) en la parte inferior de esta página.


Total 2 Páginas

No Preview Available ! TGS2602-A00 Hoja de datos, Descripción, Manual

FIGARO
PRODUCT INFORMATION
TGS 2602 - for the detection of Air Contaminants
Features:
Applications:
* High sensitivity to VOCs and odorous gases * Air cleaners
* Low power consumption
* Ventilation control
* High sensitivity to gaseous air
* Air quality monitors
contaminants
* VOC monitors
* Long life
* Odor monitors
* Small size
www.DataSheet4U.com
The sensing element is comprised of a metal oxide semiconductor layer formed
on the alumina substrate of a sensing chip together with an integrated heater.
In the presence of detectable gas, sensor conductivity increases depending on
gas concentration in the air. A simple electrical circuit can convert the change
in conductivity to an output signal which corresponds to the gas concentration.
The TGS 2602 has high sensitivity not only to air contaminants which are
emitted by cigarette smoke, but also to low concentrations of odorous gases
such as ammonia and H2S generated from waste materials in office and home
environments. The sensor also has high sensitivity to low concentrations of
VOCs such as toluene emitted from wood finishing and construction products.
Figaro also offers a microprocessor (FIC02667) which contains special soft-
ware for handling the sensor's signal for appliance control applications.
Due to miniaturization of the sensing chip, TGS 2602 requires a heater current
of only 56mA and the device is housed in a standard TO-5 package.
The figure below represents typical sensitivity characteristics,
all data having been gathered at standard test conditions (see
reverse side of this sheet). The Y-axis is indicated as sensor
resistance ratio (Rs/Ro) which is defined as follows:
Rs = Sensor resistance in displayed gases at
various concentrations
Ro = Sensor resistance in fresh air
The figure below represents typical temperature and humidity
dependency characteristics. Again, the Y-axis is indicated as
sensor resistance ratio (Rs/Ro), defined as follows:
Rs = Sensor resistance in fresh air
at various temperatures/humidities
Ro = Sensor resistance in fresh air
at 20°C and 65% R.H.
Sensitivity Characteristics:
Temperature/Humidity Dependency:
10 10
1 Air
Hydrogen
100% R.H.
Hydrogen
sulfide
Ammonia
Ethanol
1
0.1
Toluene
40% R.H.
65% R.H.
85% R.H.
0.01
0.1
1 10
Gas concentration (ppm)
0.1
100 -10 0 10 20 30 40 50 60
Ambient temperature (˚C)
IMPORTANT NOTE: OPERATING CONDITIONS IN WHICH FIGARO SENSORS ARE USED WILL VARY WITH EACH CUSTOMER’S SPECIFIC APPLICATIONS. FIGARO STRONGLY
RECOMMENDS CONSULTING OUR TECHNICAL STAFF BEFORE DEPLOYING FIGARO SENSORS IN YOUR APPLICATION AND, IN PARTICULAR, WHEN CUSTOMER’S TARGET GASES
ARE NOT LISTED HEREIN. FIGARO CANNOT ASSUME ANY RESPONSIBILITY FOR ANY USE OF ITS SENSORS IN A PRODUCT OR APPLICATION FOR WHICH SENSOR HAS NOT BEEN
SPECIFICALLY TESTED BY FIGARO.

1 page





PáginasTotal 2 Páginas
PDF Descargar[ Datasheet TGS2602-A00.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
TGS2602-A00Gas SenseFigaro
Figaro

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar