|
|
PDF S2EB Data sheet ( Hoja de datos )
| Número de pieza | S2EB | |
| Descripción | 4 AMP POLARIZED HIGH DENSITY RELAY | |
| Fabricantes | Nais | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de S2EB (archivo pdf) en la parte inferior de esta página. Total 4 Páginas | ||
|
No Preview Available !
www.DataSheet4U.com
4 AMP POLARIZED HIGH
S-RELAYSDENSITY RELAY WITH HIGH
SENSITIVITY
FEATURES
28.0
1.102
12.0
.472
• A variety of contact arrangements 2
Form A 2 Form B, 3 Form A 1 Form B,
• Wide switching range From 100µA
100 mV DC to 4 A 250 V AC
10.4 4 Form A
.409
• Latching types available
• Low thermal electromotive force Ap-
prox. 3 µV
• High sensitivity in small size 100 mW
pick-up and 200 mW nominal operating
power
• Dual-In-Line packaging arrangement
• Amber types available
mm inch
• High shock and vibration resistance
Shock: 50 G Vibration: 10 to 55 Hz at
double amplitude of 3 mm .118 inch
SPECIFICATIONS
Contacts
Arrangement
2 Form A 2 Form B,
3 Form A 1 Form B,
4 Form A
Initial contact resistance, max.
(By voltage drop 6 V DC 1 A)
50 mΩ
Initial contact pressure
Approx. 12 g .42 oz
Contact material
Gold clad silver alloy
Electrostatic capacitance
Approx. 3pF
Thermal electromotive force
(at nominal coil voltage)
Approx. 3µV
Nominal switching capacity 4 A 250 V AC, 3 A 30 V DC
Maximum switching power
1,000 VA, 90 W
Rating
(resistive)
Maximum switching voltage
250 V AC, 30 V DC
(48 VDC at less than 0.5 A)
Max. switching current
4 A (AC), 3 A (DC)
Min. switching capacity**1
100µA 100 m V DC
Expected Mechanical (at 50 cps)
life (min. Electrical 4 A 250 V AC
operations) (at 20 cpm) 3 A 30 V DC
108
105
2 × 105
Coil (polarized) (at 20°C 68°F)
Single side Minimum operating power
stable
Nominal operating power
Approx. 100 mW
Approx. 200 mW
Latching
Minimum set and reset
Nominal set and reset
Approx. 100 mW
Approx. 200 mW
Notes:
**1 This value can change due to the switching frequency, environmental conditions,
and desired reliability level, therefore it is recommended to check this with the ac-
tual load.
Remarks
* Specifications will vary with foreign standards certification ratings.
*1 Measurement at same location as "Initial breakdown voltage "section
*2 Detection current: 10mA
*3 Excluding contact bounce time
*4 Half-wave pulse of sine wave: 11ms; detection time: 10µs
*5 Half-wave pulse of sine wave: 6ms
*6 Detection time: 10µs
*7 Refer to 5. Conditions for operation, transport and storage mentioned in
AMBIENT ENVIRONMENT (Page 61).
Characteristics (at 25°C 77°F 50% Relative humidity)
Max. operating speed
20 cpm for maximum load,
50 cps for low-level load
(1 mA 1 V DC)
Initial insulation resistance*1
10,000 MΩ at 500 V DC
Initial
breakdown
voltage*2
Between open contacts
Between contact sets
Between contacts and
coil
750 Vrms
1,000 Vrms
1,500 Vrms
Operate time*3
(at nominal voltage)(at 20°C)
Max. 15 ms (Approx. 8 ms)
Release time (without diode)*3
(at nominal voltage)(at 20°C)
Max. 10 ms (Approx. 5 ms)
Set time*3 (latching)
(at nominal voltage)(at 20°C)
Max. 15 ms (Approx. 8 ms)
Reset time*3 (latching)
(at nominal voltage)(at 20°C)
Max. 15 ms (Approx. 8 ms)
Initial contact bounce, max.
1 ms
Temperature rise
(at nominal voltage)(at 20°C)
Max. 35°C with nominal coil
voltage and at maximum
switching current
Shock resistance
Functional*4
Destructive*5
Min. 490 m/s2 {50 G}
Min. 980 m/s2 {100 G}
Vibration resistance
Functional*6
Destructive
176.4 m/s2 {18 G}, 10 to 55 Hz
at double amplitude of 3 mm
235.2 m/s2 {24 G}, 10 to 55 Hz
at double amplitude of 4 mm
Conditions for operation, Ambient
transport and storage*7 temp.
(Not freezing and condens-
ing at low temperature)
Humidity
–40°C to +65°C
–40°F to +149°F
5 to 85% R.H.
Unit weight
Approx. 8 g .28 oz
TYPICAL APPLICATIONS
Telecommunications equipment, data processing equipment,
facsimiles, alarm equipment, measuring equipment.
219
1 page | ||
| Páginas | Total 4 Páginas | |
| PDF Descargar | [ Datasheet S2EB.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| S2E00 | Single & Dual Output DC/DC Converters |  Minmax Technology |
| S2E01 | Single & Dual Output DC/DC Converters | Minmax Technology |
| S2E02 | Single & Dual Output DC/DC Converters | Minmax Technology |
| S2E03 | Single & Dual Output DC/DC Converters | Minmax Technology |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |