DataSheet.es    


PDF TDA16847 Data sheet ( Hoja de datos )

Número de pieza TDA16847
Descripción (TDA1684x-x) Controller
Fabricantes Infineon Technologies 
Logotipo Infineon Technologies Logotipo



Hay una vista previa y un enlace de descarga de TDA16847 (archivo pdf) en la parte inferior de esta página.


Total 29 Páginas

No Preview Available ! TDA16847 Hoja de datos, Descripción, Manual

www.DataSheet4U.com
Datasheet, V2.0, 31 July 2003
PWM-QR IC
TDA 16846/16846-2
TDA 16847/16847-2
Controller for Switch Mode Power
Supplies Supporting Low Power
Standby and Power Factor
Power Management & Supply
Never stop thinking.

1 page




TDA16847 pdf
www.DataSheet4U.com
TDA 16846/16846-2
TDA 16847/16847-2
1.4 Short Description of the Pin Functions
Pin Function
1 A parallel RC-circuit between this pin and ground determines the ringing
suppression time and the standby-frequency.
2 A capacitor between this pin and ground and a resistor between this pin and
the positive terminal of the primary electrolytic capacitor quantifies the max.
possible output power of the SMPS.
3 This is the input of the error amplifier and the zero crossing input. The output
of a voltage divider between the control winding and ground is connected to
this input. If the pulses at pin 3 exceed a 5 V threshold, the control voltage at
pin 4 is lowered.
4 This is the pin for the control voltage. A capacitor has to be connected
between this pin and ground. The value of this capacitor determines the
duration of the softstart and the speed of the control (primary regulation).
5 If an opto coupler for the control is used, its output has to be connected
between this pin and ground. The voltage divider at pin 3 has then to be
changed, so that the pulses at pin 3 are below 5 V.
6 Fault comparator 2: A voltage > 1.2 V at this pin stops the SMPS (v.also pin 9).
7 If fixed frequency mode is wanted, a parallel RC circuit has to be connected
between this pin and ground. The RC-value determines the frequency. If
synchronized mode is wanted, sync pulses have to be fed into this pin.
8 TDA 16846-2: Not connected. TDA 16847-2: This is the power measurement
output of the Temporary High Power Circuit. A capacitor and a RC-circuit has
to be connected between this pin and ground.
9 Output for the reference voltage (5 V). With a resistor between this pin and
ground the fault comparator 2 (pin 6) is enabled.
10 Fault comparator 1: If a voltage > 1 V is applied to this pin, the SMPS stops.
11 This is the input of the primary voltage check. The voltage at the anode of the
primary electrolytic capacitor has to be fed to this pin via a voltage divider. If
the voltage of this pin falls below 1 V, the SMPS is switched off. A second
function of this pin is the primary voltage dependent fold back point correction
(only active in free running mode).
12 Common ground.
13 Output signal. This pin has to be connected via a series resistor to the gate of
the power transistor.
14 Connection for supply voltage and startup capacitor. After startup, the supply
voltage is produced by the control winding of the transformer and rectified by
an external diode.
Version 2.0
5 31 Jul 2003

5 Page





TDA16847 arduino
www.DataSheet4U.com
TDA 16846/16846-2
TDA 16847/16847-2
If the control voltage is below 2 V (at low output power) the “off-time” is maximum and
constant
TD1max 0, 56 × R1 × C1
During the discharge time tD1, V1 must not fall below the limit V1L, otherwise the function
is not guaranteed.
Figure 6 Off-Time-Circuit
Version 2.0
11
31 Jul 2003

11 Page







PáginasTotal 29 Páginas
PDF Descargar[ Datasheet TDA16847.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
TDA16846(TDA1684x-x) ControllerInfineon Technologies
Infineon Technologies
TDA16846-2(TDA1684x-x) ControllerInfineon Technologies
Infineon Technologies
TDA16846GICs for Consumer ElectronicsInfineon Technologies
Infineon Technologies
TDA16847(TDA1684x-x) ControllerInfineon Technologies
Infineon Technologies

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar