|
|
PDF K9LAG08U1M Data sheet ( Hoja de datos )
| Número de pieza | K9LAG08U1M | |
| Descripción | (K9XXG08UXM) Flash Memory | |
| Fabricantes | Samsung Electronics | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de K9LAG08U1M (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
www.DataSheet4U.com
K9LAG08U1M
K9G8G08U0M
Preliminary
FLASH MEMORY
K9XXG08UXM
INFORMATION IN THIS DOCUMENT IS PROVIDED IN RELATION TO SAMSUNG PRODUCTS,
AND IS SUBJECT TO CHANGE WITHOUT NOTICE.
NOTHING IN THIS DOCUMENT SHALL BE CONSTRUED AS GRANTING ANY LICENSE,
EXPRESS OR IMPLIED, BY ESTOPPEL OR OTHERWISE,
TO ANY INTELLECTUAL PROPERTY RIGHTS IN SAMSUNG PRODUCTS OR TECHNOLOGY. ALL
INFORMATION IN THIS DOCUMENT IS PROVIDED
ON AS "AS IS" BASIS WITHOUT GUARANTEE OR WARRANTY OF ANY KIND.
1. For updates or additional information about Samsung products, contact your nearest Samsung office.
2. Samsung products are not intended for use in life support, critical care, medical, safety equipment, or similar
applications where Product failure could result in loss of life or personal or physical harm, or any military or
defense application, or any governmental procurement to which special terms or provisions may apply.
* Samsung Electronics reserves the right to change products or specification without notice.
1
1 page  
www.DataSheet4U.com
K9LAG08U1M
K9G8G08U0M
PIN CONFIGURATION (ULGA)
K9G8G08U0M-ICB0/IIB0
A B C DE FG HJ K L M N
NC NC
NC
NC NC NC
7
NC /RE
NC
NC NC
NC
NC
6
Vcc NC Vss IO7 IO5
Vcc
5
4
/CE NC R/B
NC IO6
IO4
NC
3 CLE NC /WE IO0 IO2 Vss NC
2
Vss NC /WP IO1 IO3
Vss
1
NC ALE NC
NC NC
NC NC
NC NC NC
NC NC NC
Preliminary
FLASH MEMORY
PACKAGE DIMENSIONS
52-ULGA (measured in millimeters)
Top View
12.00±0.10
#A1
(Datum A)
(Datum B)
A
B
C
D
E
F
G
H
J
K
L
M
N
Bottom View
2.00
7
12.00±0.10
1.00 10.00 1.00
6 54 3 2
1
1.00
1.00
A
B
0.10 C
12-∅1.00±0.05
∅0.1 M C AB
Side View
17.00±0.10
41-∅0.70±0.05
∅0.1 M C AB
5
5 Page 
www.DataSheet4U.com
K9LAG08U1M
K9G8G08U0M
Preliminary
FLASH MEMORY
VALID BLOCK
Parameter
K9G8G08U0M
K9LAG08U1M
Symbol
NVB
NVB
Min
3,996
7,992
Typ.
-
Max
4,096
8,192
Unit
Blocks
Blocks
NOTE :
1. The device may include initial invalid blocks when first shipped. Additional invalid blocks may develop while being used. The number of valid blocks is
presented with both cases of invalid blocks considered. Invalid blocks are defined as blocks that contain one or more bad bits. Do not erase or pro-
gram factory-marked bad blocks. Refer to the attached technical notes for appropriate management of initial invalid blocks.
2. The 1st block, which is placed on 00h block address, is guaranteed to be a valid block at the time of shipment.
3. The number of valid block is on the basis of single plane operations, and this may be decreased with two plane operations.
* : Each K9G8G08U0M chip in the K9LAG08U1M has Maximun 100 invalid blocks.
AC TEST CONDITION
(K9XXG08UXM-XCB0 :TA=0 to 70°C, K9XXG08UXM-XIB0:TA=-40 to 85°C)
Parameter
K9XXG08UXM
Input Pulse Levels
0V to Vcc
Input Rise and Fall Times
5ns
Input and Output Timing Levels
Vcc/2
Output Load
1 TTL GATE and CL=50pF
CAPACITANCE(TA=25°C, VCC=3.3V, f=1.0MHz)
Item
Symbol
Test Condition
Min
Max
Unit
Input/Output Capacitance
CI/O
VIL=0V
-
10 pF
Input Capacitance
CIN VIN=0V
-
10 pF
NOTE : Capacitance is periodically sampled and not 100% tested.
MODE SELECTION
CLE
ALE
CE
WE
RE
HL L
H
LHL
H
HL L
H
LHL
H
LLL
H
L L LH
XXXXH
XXXXX
XXXXX
X X(1) X X X
XXHXX
NOTE : 1. X can be VIL or VIH.
2. WP should be biased to CMOS high or CMOS low for standby.
Program / Erase Characteristics
WP
X
X
H
H
H
X
X
H
H
L
0V/VCC(2)
Mode
Read Mode
Command Input
Address Input(5clock)
Write Mode
Command Input
Address Input(5clock)
Data Input
Data Output
During Read(Busy)
During Program(Busy)
During Erase(Busy)
Write Protect
Stand-by
Parameter
Symbol
Min
Typ
Max
Unit
Program Time
tPROG
-
0.8 3
ms
Dummy Busy Time for Multi Plane Program
tDBSY
0.5 1
µs
Number of Partial Program Cycles in the Same Page
Nop
-
-
1 cycle
Block Erase Time
tBERS
-
1.5 10
ms
NOTE
1. Typical value is measured at Vcc=3.3V, TA=25°C. Not 100% tested.
2. Typical Program time is defined as the time within which more than 50% of the whole pages are programed at 3.3V Vcc and 25°C temperature.
3. Within a same block, program time(tPROG) of page group A is faster than that of page group B. Typical tPROG is the average program time of the
page group A and B(Table 2).
Page Group A: Page 0, 1, 2, 3, 6, 7, 10, 11, ... , 110, 111, 114, 115, 118, 119, 122, 123
Page Group B: Page 4, 5, 8, 9, 12, 13, 16, 17, ... , 116, 117, 120, 121, 124, 125, 126, 127
11
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet K9LAG08U1M.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| K9LAG08U1A | FLASH MEMORY |  Samsung |
| K9LAG08U1M | (K9XXG08UXM) Flash Memory | Samsung Electronics |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |