DataSheet.es    


PDF IR2E51Y Data sheet ( Hoja de datos )

Número de pieza IR2E51Y
Descripción Auto-Brightness Control LED Driver
Fabricantes Sharp Electrionic 
Logotipo Sharp Electrionic Logotipo



Hay una vista previa y un enlace de descarga de IR2E51Y (archivo pdf) en la parte inferior de esta página.


Total 13 Páginas

No Preview Available ! IR2E51Y Hoja de datos, Descripción, Manual

www.DataSheet4U.com
IR2E51Y
IR2E51Y
Auto-Brightness Control
LED Driver
Description
IR2E51Y incorporates white LED driver with auto
brightness control.
This IC is equipped with charge pump DC/DC converter.
Input voltage is boosted into CPO by a charge pump circuit.
This IC maintains high efficiency since the charge pump
circuit automatically selects 1x or 1.5x charge pump mode
depending on input voltage and load.
It contains 4 white LED drivers to drive the main-LCD
backlight, 2 white LED drivers for sub-LCD backlight and
RGB-LED drivers.
All LED are connected in parallel.
With peripheral ambient light sensor, this IC automatically
adjusts white LED brightness to ambient brightness.
This IC supports I2C-Bus interface.
This product is optimum for use as the backlight white
LED driver IC for cellular phone and PDA applications, etc.
Agency approvals/Compliance
1. Compliant with RoHS directive(2002/95/EC)
Applications
1.Back light and call alert display
(White & RGB LED)
Features
1. Supply Voltage Range: VIN=3.0V to 4.5V, VCC=2.3V to 3.2V
2. Supports I2C-Bus interface
3. SCL pin and SDA pin are installed with noise filters.
4. Sink-type variable constant current driver for LED
(maximum current 27.4mA/ch)
5. Monitoring all LED pins
(Response to VF variation of LED)
6.Auto brightness control circuit for main-LCD embedded.
(16 steps and 128 gradation sequence)
7.PWM LED Brightness Control (0% to 100%) (RGB)
(The PWM signal frequency of 2kHz to 5kHz is recommended.)
8.1x/1.5x Modes Charge Pump: Automatically Selected
9.Voltage reference embedded
10.Stand-by circuit embedded
11.Power-on-reset circuit embedded
12.Soft-Start Limits Inrush Current
13.Effective illuminance range (3lx to 55000lx) (GA1A1S201WP)
Notice The content of data sheet is subject to change without prior notice.
In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP
devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device.
Sheet No.: F1-A00101EN
Date Dec.01.2006
©SHARP Corporation

1 page




IR2E51Y pdf
Pin Assignment
123456
A U1A SW PD VDD SCL U2A
B EN_RGB IREF_PD VCC
SDA
KEY
M2
C G IREF
XRESET M1 PGND1
D
PGND2
B
GND2 GND1 M3
M4
E VIN R C1N S1 S2 CGND
F U1F C1P CPO C2P C2N U2F
Note: Pins are located on the underside.
IR2E51Y
Sheet No.: F1-A00101EN

5 Page





IR2E51Y arduino
Fig.1 I2C-Bus timing diagram (Fs-mode)
SDA
tf
SCL
tLOW
tr
tSU;DAT
tf
tHD;STA
tHD;DAT
tHIGH
Fig.2 I2C-Bus timing diagram (Hs-mode)
tHD;STA
tSU;STA
IR2E51Y
tBUF
tr
tSP
tSU;STO
SDAH
tSU;STA
tHD;STA
tHD;DAT
tSU;DAT
tHIGH
SCLH
tfCL1
tLOW
tfCL
tHIGH
tfCL
tLOW
tSU;STO
trCL1
Sheet No.: F1-A00101EN

11 Page







PáginasTotal 13 Páginas
PDF Descargar[ Datasheet IR2E51Y.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
IR2E51YAuto-Brightness Control LED DriverSharp Electrionic
Sharp Electrionic

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar