|
|
Número de pieza | WJA1005 | |
Descripción | 5V Active-Bias InGaP HBT Gain Block | |
Fabricantes | WJ Communication | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de WJA1005 (archivo pdf) en la parte inferior de esta página. Total 4 Páginas | ||
No Preview Available ! WJA1005www.DataSheet4U.com
+5V Active-Bias InGaP HBT Gain Block
Product Features
• 50 – 4000 MHz
• 18 dB Gain
• +19 dBm P1dB
• +35 dBm OIP3
• +5V Single Voltage Supply
• Internal Active Bias Supply
• Internally matched to 50 Ω
• Lead-free / RoHS-compliant /
Green SOT-89 package
Applications
• GSM, PCS, CDMA, WCDMA
• Repeaters, BTS Transceivers
• UHF
• General Purpose
Product Description
Functional Diagram
The WJA1005 is a high performance amplifier that offers
high linearity in a low-cost surface-mount package. At 900
MHz, the WJA1005 typically provides 18 dB gain, +35
dBm OIP3, and +19 dBm P1dB. The device is housed in a
lead-free/green/RoHS-compliant SOT-89 industry-standard
SMT package using a NiPdAu plating to eliminate the
possibility of tin whiskering.
The WJA1005 consists of Darlington pair amplifiers using
a high reliability InGaP/GaAs HBT process technology.
The MMIC amplifier is internally matched to 50Ω and only
requires DC-blocking capacitors and an inductive RF choke
for operation. An internal active bias is designed to enable
stable performance over temperature. It also eliminates the
need for a dropping bias resistor and allows the device to
be biased directly from a +5V supply voltage.
GND
4
1
RF IN
2
GND
3
RF OUT
Function
Input
Output/Bias
Ground
Pin No.
1
3
2, 4
The amplifier is targeted for high performance RF applications
in existing and next generation wireless technologies. In
addition, the WJA1005 will work for various other
applications within the 50 to 4000 MHz frequency range.
Specifications
Parameter
Operational Bandwidth
Test Frequency
Gain
Input Return Loss
Output Return Loss
Output P1dB
Output IP3 (2)
Noise Figure
Device Voltage
Device Current
Units
MHz
MHz
dB
dB
dB
dBm
dBm
dB
V
mA
Min
50
Typ
900
17.9
14
9.5
+19.1
+35
4.0
5
63
Max
4000
1. Test conditions: 25 ºC, Supply Voltage = +5 V, 50 Ω System.
2. 3OIP measured with two tones at an output power of 0 dBm/tone separated by 1 MHz. The
suppression on the largest IM3 product is used to calculate the 3OIP using a 2:1 rule.
Typical Performance
Parameter
Frequency
S21
S11
S22
Output P1dB
Output IP3 (2)
Noise Figure
Units
MHz
dB
dB
dB
dBm
dBm
dB
500
18.8
-18
-13
+19.8
+37.5
3.9
Typical
900 1900
17.9 15.3
-14 -9.4
-9.5 -6.1
+19.1 +15.8
+35 +25.9
4.0 5.0
2140
14.7
-9
-5.9
+14.9
+24.8
5.0
Absolute Maximum Rating
Ordering Information
Parameter
Operating Case Temperature
Storage Temperature
Rating
-40 to +85 °C
-55 to +150 °C
Part No.
WJA1005
WJA1005-PCB
Description
+5V Active Bias InGaP HBT Gain Block
(lead-free/green/RoHS-compliant SOT-89 Package)
500 – 2400 MHz Fully Assembled Eval. Board
Operation of this device above any of these parameters may cause permanent damage.
Specifications and information are subject to change without notice
WJ Communications, Inc • Phone 1-800-WJ1-4401 • FAX: 408-577-6621 • e-mail: [email protected] • Web site: www.wj.com
Page 1 of 4 May 2007
1 page |
Páginas | Total 4 Páginas | |
PDF Descargar | [ Datasheet WJA1005.PDF ] |
Número de pieza | Descripción | Fabricantes |
WJA1000 | 5V Active-Bias InGaP HBT Gain Block | WJ Communication |
WJA1001 | 5V Active-Bias InGaP HBT Gain Block | WJ Communication |
WJA1001 | Active-Bias InGaP HBT Gain Block | TriQuint Semiconductor |
WJA1005 | 5V Active-Bias InGaP HBT Gain Block | WJ Communication |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |