|
|
PDF ENH104V1-450 Data sheet ( Hoja de datos )
| Número de pieza | ENH104V1-450 | |
| Descripción | (ENH104V1-xxx) Color TFT-LCD Module Features | |
| Fabricantes | WEDC | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de ENH104V1-450 (archivo pdf) en la parte inferior de esta página. Total 15 Páginas | ||
|
No Preview Available !
www.DataSheet4U.com
White Electronic Designs
Display Systems Division
ENH104V1-350/450
ENH104V1-350/450 Color TFT-LCD Module Features
GENERAL DESCRIPTION
White Electronic Designs Display Systems Division
provides optically enhanced solutions to the standard
Sharp LQ104V1DG21 color active matrix LCD module.
The first enhancement is an index matching (IM) film
lamination to the front surface of the display polarizer. The
IM film is available in two surface treatments - IM/Clear and
IM/110 (a 10% diffusion).The second enhancement is the
incorporation of an enhanced light guide (ELG) providing
for up to 30% increase in brightness.
This module is composed of a color TFT-LCD panel,
driver ICs, and a backlight unit. Graphics and text can
be displayed on a 640 X 3 X 480 dot panel with 262, 144
color by supplying 18-bit data signal (6bit/color), four timing
signals, +3.3V/+5V DC supply voltage for TFT-LCD panel
driving and supply voltage for backlight.
The TFT-LCD panel used for this module is a low-reflection
and higher-color-saturation type. Therefore, this module
is also suitable for multimedia use. Optimum viewing
direction is 6 o'clock. Backlight-driving DC/AC inverter is
not built in this module.
White assumes no responsibility for any damage resulting
from the use of the device which does not comply with
the instructions and the precautions specified in these
specification sheets. White does assume the responsibility
for the warranty of the enhanced product.
SPECIFICATIONS
Parameter
Specifications
Display size (cm)
26 (10.4") Diagonal
Active area (mm)
211.2 (H) x 158.4 (V)
Pixel format
640 (H) x 480 (V)
(1 =R+G+B dots)
Pixel pitch (mm)
0.330 (H) x 0.330 (V)
Pixel configuration
R,G,B vertical stripe
Display mode
Normally white
Unit outline dimensions (1) (mm)
265.0 (W) x 195.0 (H) x 11.5max(D)
Mass (g)
700 (max)
Surface treatment
IM/Clear (glossy) or IM/110 and hardcoat 3H
Note:
1. Excluding backlight cables. Outline dimensions shown in Fig.1
Note: This measurement is typical, and see Fig. 3 for details.
White Electronic Designs Corp. reserves the right to change products or specifications without notice.
Original specifications created by Sharp.
September 2003
Rev. 0
1 Display Systems Division • Hillsboro, OR • (503) 690-2460 • www.wedc.com
1 page  
White Electronic Designs
Display Systems Division
ENH104V1-350/450
BACKLIGHT DRIVING SECTION
The backlight system is an edge-lighting type with single CCFT (Cold Cathode Fluorescent Tube).
The characteristics of a single lamp are shown in the folliowing table..
Parameter
Lamp current
Lamp power consumption
Lamp frequency
Kickoff voltage
Lamp life time
Symbol
MIN
TYP
MAX Unit
IL 2.0 6.0 6.5 mArms
PL - 3.0 - W
FL 20 35 60 KHz
VS -
- (950) Vrms
-
-
(1250)
Vrms
-
-
(1500)
Vrms
LL 50000
-
- hour
tA=25°C
Remark
(1)
(2)
(3)
tA=25°C
tA=0°C (4)
tA=-10°C (4)
(5)
Module
1
3
1
~A
3 ~A
Inverter
* 3pin is VLOW
Notes:
1. Lamp current is measured with current meter for high frequency as shown above.
2. At the condition of IL= 6.0mArms
3. Lamp frequency may produce interference with horizontal synchronous frequency,and this may cause horizontal beat on the display. Therefore, lamp frequency shall be
detached as much as possible from the horizontal synchronous frequency and from the harmonics of horizontal synchronous to avoid interference.
4. The open output voltage of the inverter shall be maintained for more than 1 sec; otherwise the lamp may not be turned on.
5. Since lamp is consumables, the life time written above is referential value and it is not guaranteed in this specification sheet by White.
Lamp life time is defined that it applied either (1) or (2) under this condition (Continuous turning on at tA=25°C, IL=6.0mArms)
1. Brightness becomes 50% of the original value under standard condition.
2. Kick-off voltage at tA=10°C exceeds maximum value,1500 Vrms. In case of operating under lower temp environment, the lamp degradation is accelerated and the
brightness becomes lower.
(Continuous operating for a minimum of one month under lower temp condition may reduce the brightness to 50% of the original brightness.)
In case of such usage under lower temp environment, periodical lamp exchange by White is recommended
6. The performance of the backlight, for example life time; or brightness, is extremely infuenced by the characteristics of the DC-AC inverter, make certain that poor lighting caused
by the mismatch of the backlight and the inverter (miss-lighting, flicker, ect.) do not occur. Once this is verified, the module should be operating in the same condition as it is
installed in the instrument.
7. It is required to have the inverter designed to allow the impedance deviation of the two CCFT lamps and the capacity deviation of barast capacitor.
White Electronic Designs Corp. reserves the right to change products or specifications without notice.
Original specifications created by Sharp.
September 2003
Rev. 0
5 Display Systems Division • Hillsboro, OR • (503) 690-2460 • www.wedc.com
5 Page 
White Electronic Designs
Display Systems Division
ENH104V1-350/450
INPUT SIGNALS, BASIC DISPLAY COLORS AND GRAY SCALE OF EACH COLOR
Colors &
Data signal
Grayscale Gray Scale R0 R1 R2 R3 R4 R5 G0 G1 G2 G3 G4 G5 B0 B1 B2 B3 B4 B5
Black
- 000 0 0000 0 0 0 0 0 0 0 0 00
Blue - 0 0 0 0 0 0 0 0 0 0 0 0 1 1 1 1 1 1
Green
- 000 0 0011 1 1 1 1 0 0 0 0 00
Cyan - 0 0 0 0 0 0 1 1 1 1 1 1 1 1 1 1 1 1
Red - 1 1 1 1 1 1 0 0 0 0 0 0 0 0 0 0 0 0
Magenta - 1 1 1 1 1 1 0 0 0 0 0 0 1 1 1 1 1 1
Yellow
- 111 1 1111 1 1 1 1 0 0 0 0 00
White
- 111 1 1111 1 1 1 1 1 1 1 1 11
Black
GS0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Darker
GS1 1 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
GS2 0 1 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Brighter
Red
Black
Darker
GS61
GS62
GS63
GS0
GS1
GS2
101 1 1100000 0 0 0 00 00
011 1 1100000 0 0 0 00 00
111 1 1100000 0 0 0 00 00
000 0 0000000 0 0 0 00 00
000 0 0010000 0 0 0 00 00
000 0 0001000 0 0 0 00 00
Brighter
Green
Black
Darker
GS61
GS62
GS63
GS0
GS1
GS2
000 0 0010111 1 0 0 00 00
000 0 0001111 1 0 0 00 00
000 0 0011111 1 0 0 00 00
000 0 0000000 0 0 0 00 00
000 0 0000000 0 1 0 00 00
000 0 0000000 0 0 1 00 00
Brighter
Blue
GS61
GS62
GS63
000 0 0000000 0 1 0 11 11
000 0 0000000 0 0 1 11 11
000 0 0000000 0 1 1 11 11
Notes:
1. 0: Low level voltage 1: High level voltage.
2. Each basic color can be displayed in 64 gray scales from 6 bit data signals. According to the combination of total 18 bit data signals, the 262, 144-color display can be
achieved on the screen.
White Electronic Designs Corp. reserves the right to change products or specifications without notice.
Original specifications created by Sharp.
September 2003
Rev. 0
11 Display Systems Division • Hillsboro, OR • (503) 690-2460 • www.wedc.com
11 Page | ||
| Páginas | Total 15 Páginas | |
| PDF Descargar | [ Datasheet ENH104V1-450.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| ENH104V1-450 | (ENH104V1-xxx) Color TFT-LCD Module Features | WEDC |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |