DataSheet.es    


PDF ENH057Q1-350 Data sheet ( Hoja de datos )

Número de pieza ENH057Q1-350
Descripción (ENH057Q1-xxx) Color TFT-LCD Module Features GENERAL DESCRIPTION
Fabricantes WEDC 
Logotipo WEDC Logotipo



Hay una vista previa y un enlace de descarga de ENH057Q1-350 (archivo pdf) en la parte inferior de esta página.


Total 16 Páginas

No Preview Available ! ENH057Q1-350 Hoja de datos, Descripción, Manual

www.DataSheet4U.com
White Electronic Designs
Display Systems Division
ENH057Q1-350/450/600
ENH057Q1-350/450/600 Color TFT-LCD Module Features
GENERAL DESCRIPTION
Panelview provides optically enhanced solutions to the
standard Sharp LQ057Q3DC02 color active matrix LCD
module. The first enhancement is an index matching (IM)
film lamination to the front surface of the display polarizer.
The IM film is available in two surface treatments - IM/Clear
and IM/110 (a 10% diffusion).The second enhancement is
the incorporation of a reflective polarizer (RP) to improve
brightness by up to 40%. The third enhancement is
the addition of prism films (RPp) further increasing the
brightness of the display. The module is composed of a
color TFT-LCD panel, driver ICs, control circuit, power
supply circuit and a backlight unit. Graphics and text can
be displayed on a 320 X 3 X 240 dot panel with 262,
144 color by supplying 18 bit data signal (6bit/color), four
timing signals.
The TFT-LCD panel used for this module is a low-reflection
and higher-color-saturation type. Therefore, this module
is also suitable for multimedia use. Viewing angle is 12
o'clock direction. This module is the type of wide viewing
angle and high brightness 350cd/m2. It has horizontal
display mode and vertical display mode.
Backlight-driving DC/AC inverter is not built in this
module.
Panelview assumes no responsibility for any damage
resulting from the use of the device which does not
comply with the instructions and the precautions specified
in these specification sheets. Panelview does assume the
responsibility for the warranty of the enhanced product.
Parameter
Display size
Active area
Pixel format
Pixel pitch
Pixel configuration
Display mode
Unit outline dimensions (1)
Mass
Surface treatment
Note:
1. Excluding backlight cables.
MECHANICAL SPECIFICATIONS
Specifications
14.4 (5.7") Diagonal
115.2 (H) x 86.4 (V)
320 (H) x 240 (V)
(1 pixel=R+G+B dots)
0.360 (H) x 0.360 (V)
R,G,B vertical stripe
Normally white
144.0 (W) x 104.6 (H) x 13.0(D)
220 ± 20
IM/Clear (glossy) or IM/110 and hardcoat 3H
Units
cm
mm
pixel
-
mm
-
-
mm
g
-
Note: This measurement is typical, and see Fig. 3 for details.
White Electronic Designs Corp. reserves the right to change products or specifications without notice.
Original specifications created by Sharp.
September 2003
Rev. 0
1 Display Systems Division • Hillsboro, OR • (503) 690-2460 • www.wedc.com

1 page




ENH057Q1-350 pdf
White Electronic Designs
Display Systems Division
ENH057Q1-350/450/600
2. VCC=3.3V V/Q= "H"
Typical current situation
Maximum current situation
:64-gray bar pattern
Timing: Typical signal
:Vertical stripe pattern by GS0 and GS42 signal on every other pixel.
(This pattern is used temporarily)
Timing: Typical signal
GSO GS1 GS2
GS62 GS63
GS42
GS0
Typical Current Situation
Maximum current situation
3. CK, RO~R5, GO~G5, BO~B5, HSYNC, VSYNC, ENAB, R/L, U/D, V/D
4. CK, RO~R5, GO~G5, BO~B5, HSYNC, VSYNC, R/L, U/D
5. ENAB, V/D
BACKLIGHT DRIVING SECTION
The backlight system is an edge-lighting type with single CCFT (Cold Cathode Fluorescent Tube).
The characteristics of a single lamp are shown below.
tA=25°C
Parameter
Lamp Voltage
Lamp current
Lamp power consumption
Lamp frequency
Kickoff voltage tA=25°C
tA=30°C
Symbol
VL7
IL
WL
FL
VS
MIN
620
4.5
-
30
-
-
TYP
690
5.0
3.5
-
-
-
(Inverter: HIU-288 [Output Condenser 22pF] Harison Electric Co., LTD.)
MAX
760
5.5
-
60
1350
1470
Unit
Vrms
mArms
W
KHz
Vrms
Vrms
Remark
IL=6.5mArms
normal operation
-
(6)
Sealed is connected to
GND
6. Lamp frequency may produce interference with horizontal synchronous frequency, and this may cause horizontal beat on the display. Therefore, lamp frequency shall be
detached as much as possible from the horizontal synchronous frequency and from the harmonics of horizontal synchronous to avoid interference. In case of such usage under
lower temperature environments, periodic lamp exchange by Panelview is recommended.
White Electronic Designs Corp. reserves the right to change products or specifications without notice.
Original specifications created by Sharp.
September 2003
Rev. 0
5 Display Systems Division • Hillsboro, OR • (503) 690-2460 • www.wedc.com

5 Page





ENH057Q1-350 arduino
White Electronic Designs
Display Systems Division
ENH057Q1-350/450/600
Notes:
1. Definition of viewing angle range:
q 11 Normal line q 11
q 21 q 21
12 o'clock direction
2. Definition of contrast ratio
The contrast ratio is defined as follows:
Contrast
Ratio
(CR)=
Luminance
Luminance
(brightness)
(brightness)
with
with
all
all
pixels
pixels
white
black
3. Definition of response time
The response time is defined as the following figure and shall be measured by
switching the input signal for "black" and "white".
white
100%
90%
black
white
4. This shall be measured at the center of the screen. The measurement was done
30 mins later after switching on the backlight. (characteristic of the first stage)
Inverter drive frequency: 49 kHz
5. Continuous operation time which doesn't deteriorate the brightness under 50% of
the brightness at the beginning.
(Condition) IL=5.0 mArms (adjusting the brightness by current)
10%
0%
τr
τd
time
White Electronic Designs Corp. reserves the right to change products or specifications without notice.
Original specifications created by Sharp.
September 2003
Rev. 0
11 Display Systems Division • Hillsboro, OR • (503) 690-2460 • www.wedc.com

11 Page







PáginasTotal 16 Páginas
PDF Descargar[ Datasheet ENH057Q1-350.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
ENH057Q1-350(ENH057Q1-xxx) Color TFT-LCD Module Features GENERAL DESCRIPTIONWEDC
WEDC

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar