DataSheet.es    


PDF SC-604 Data sheet ( Hoja de datos )

Número de pieza SC-604
Descripción Speech And Music Processor
Fabricantes Sensory 
Logotipo Sensory Logotipo



Hay una vista previa y un enlace de descarga de SC-604 (archivo pdf) en la parte inferior de esta página.


Total 13 Páginas

No Preview Available ! SC-604 Hoja de datos, Descripción, Manual

www.DataSheet4U.com
SC-604
Speech And Music Processor
Data sheet
Features
Advanced, Integrated Speech Synthesizer for
High-Quality Sound
Operates up to 12.32 MHz (Performs up to 12
MIPS)
Slave Mode Enables Hours of Speech Using an
External Processor and Memory
Master Mode Allows 6.8 Minutes of Speech
Onboard
Supports High-Quality Synthesis Algorithms
such as MX, CX, Simple CX, LX, ADPCM, and
Polyphonic Music
Simultaneous Speech Plus Music Capabilities
Very Low-Power Operation, Ideal for Hand-Held
Devices
Low-Voltage Operation, Sustainable by Three
(3) Batteries
Reduced Power Standby Modes, Less Than 10
µA in Deep-Sleep Mode
16 General-Purpose I/O Pins (in Master Mode)
or 4 General-Purpose I/O Pins (in Slave Mode)
Resistor-Trimmed Oscillator or 32.768-kHz
Crystal Reference Oscillator
Slave Interface Logic Contains 64K Bytes-
Words Onboard ROM (2K Words Reserved)
640-Word RAM
Direct Speaker Drive, 32 (PDM)
One-Bit Comparator With Edge Detection
Interrupt Service
Serial Scan Port for In-Circuit Emulation,
Monitor, and Test
Available in Die Form or 64-Pin LQFP Package
Description
The SC-604 is a low-cost, mixed-signal
processor that combines a speech synthesizer
with a dedicated slave interface logic, general-
purpose I/O, onboard ROM, and direct speaker-
drive in a single package. The computational
unit uses a powerful new DSP that gives the SC-
604 unprecedented speed and computational
flexibility compared with previous devices of its
type. The SC-604 supports a variety of speech
and audio coding algorithms, providing a range
of options with respect to speech duration and
sound quality.
16-Bit
Microprocessor
640-words
RAM
SLAVE LOGIC
64K-Bytes ROM
SC-691 Block Diagram
10-Bit
DAC
TIMER 1
TIMER 2
COMPARATOR
PLLM
The device consists of a micro-DSP core,
embedded program and data memory, and a self-contained clock generation system. General-purpose
periphery is comprised of 16 bits of partially configurable I/O.
The core processor is a general-purpose 16-bit microcontroller with DSP capability. The basic core block
includes a computational unit (CU), data address unit, program address unit, two timers, eight-level interrupt
processor, and several system and control registers. The core processor gives the SC-604break-point capability
in emulation.
The processor is a Harvard type for efficient DSP algorithm execution, separating program and data memory
blocks to permit simultaneous access. The ROM has a protection scheme to prevent third-party pirating. It is
configured in 32K 17-bit words.
The total ROM space is divided into two areas:
1) The lower 2K words are reserved by Sensory, Inc. for a built-in self-test
2) The upper 30K is for user program and data space.
© 2002 Sensory Inc.
P/N 80-0208-B
1

1 page




SC-604 pdf
Data Sheet
Timing Diagram
SC-604
Write to Slave
1. Slave signals readiness to receive data from host.
2. Slave drops INRDY.
3. Host drops R/W to indicate a write.
4. Host drops STROBE.
5. Host places data on the bus.
6. Host raises STROBE indicating data is valid.
7. Slave raises INRDY, latching the data.
8. INT3 is triggered when INRDY rises.
Read from Slave
1. Slave signals readiness to send data to host.
2. Slave drops OUTRDY.
3. Host raises R/W to indicate a read.
4. Host drops STROBE.
5. Slave places data on the bus.
6. Host raises STROBE after reading the data.
7. Slave raises OUTRDY.
8. INT4 is triggered when OUTRDY rises.
Timing Constrains
Write to Slave
Read from Slave
INRDY low to STROBE low
R/W to STROBE low
STROBE low
STROBE high to R/W
STROBE high to INRDY high
Data setup
Data hold
tIS (min) = 5 ns
tRS (min) = 75 ns
tST (min) = 100 ns
tSR (min) = 25 ns
tSI (max) = 75 ns
tS (min) = 15 ns
tH (min) = 80 ns
OUTRDY low to STROBE low
R/W to STROBE low
STROBE low
STROBE high to R/W
STROBE high to OUTRDY high
STROBE Low to data valid
STROBE High to data high Z
tOS (min) = 5 ns
tRS (min) = 75 ns
tST (min) = 100 ns
tSR (min) = 25 ns
tSO (max) = 75 ns
tDV (max) = 90 ns
tDZ (min) = 90 ns
© 2002 Sensory Inc.
P/N 80-0208-B
5

5 Page





SC-604 arduino
Data Sheet
R2
0.08
-
0.20
0.003
-
0.008
S
0.20
-
-
0.008
-
-
3.5º
3.5º
1
-
-
-
-
2
12º TYP
12º TYP
3
12º TYP
12º TYP
SC-604
© 2002 Sensory Inc.
P/N 80-0208-B
11

11 Page







PáginasTotal 13 Páginas
PDF Descargar[ Datasheet SC-604.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
SC-601Speech And Music ProcessorSensory
Sensory
SC-604Speech And Music ProcessorSensory
Sensory
SC-605Speech And Music ProcessorSensory
Sensory

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar