G104SN03V2 Hoja de datos PDF

PDF G104SN03V2 Datasheet ( Hoja de datos )

Número de pieza G104SN03V2
Descripción TFT LCD Module
Fabricantes Data Modul 
Logotipo Data Modul Logotipo
Vista previa
Total 29 Páginas
G104SN03V2 datasheet

1 Page

G104SN03V2 pdf
1.0 Handing Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnection from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human earth when
7) Do not open nor modify the module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a module has to be put back into the packing container slot after once it was taken out
from the container, do not press the center of the CCFL Reflector edge. Instead, press at the far
ends of the CFL Reflector edge softly. Otherwise the TFT module may be damaged.
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the
interface Connector of the TFT module.
11) After installation of the TFT module into an enclosure, do not twist nor bend the TFT module even
momentary. At designing the enclosure, it should be taken into consideration that no
bending/twisting forces are applied to the TFT module from outside. Otherwise the TFT module
may be damaged.
12) Cold cathode fluorescent lamp in LCD contains a small amount of mercury. Please follow local
ordinances or regulations for disposal.
13) Small amount of materials having no flammability grade is used in the LCD module should be
supplied by power complied with requirements of Limited Power Source, or be applied exemption.
14) The LCD module is designed so that the CFL in it is supplied by Limited Current Circuit. Do not
connect the CFL in Hazardous Voltage Circuit.
(C) Copyright AU Optronics, Inc.
2004 All Right Reserved.
No Reproduction and Redistribution Allowed.
DataSheet4 U .com
G104SN03 V.2

5 Page

G104SN03V2 arduino
4.0 Optical Characteristics (Note 1, Note 2)
Symbol Condition
Min. Typ. Max.
Response time
Rising time
Falling time
Contrast ratio
Viewing angle
Tr θ=0° - 10
Tf - 25
CR θ=0° 400 500
30 35
60 60
20 ms
Note 4
- Note 3,5
- deg. Note 3,6
White Luminance (ICFL=4.5 mA) [cd/m2] θ=0° 160 180 - nit Note 3,7,8,9
Color chromaticity(CIE)
Wx 0.280 0.320 0.340
Wy 0.300 0.330 0.360
Note 3,8,9
Rx 0.540 0.570 0.600
Ry 0.290 0.320 0.350
Gx 0.270 0.300 0.330
Gy 0.530 0.560 0.590
Bx 0.115 0.145 0.175
By 0.100 0.130 0.160
White uniformity
δW 13 Points -
- 1.33
Note 3,9,10
Note 1: Ambient temperature = 25.
Note 2: To be measured in dark room after backlight warm up 30 minutes.
Note 3: To be measured with a viewing cone of 1°by Topcon luminance meter BM-5A.
Note 4: Definition of response time:
The output signals of BM-7 are measured when the input signals are changed from
Blackto White(falling time) and from Whiteto Black(rising time), respectively. The
response time means the interval between the 10% and 90% of amplitudes. Refer to
figure as below.
Sig 90%
tiv 10%
Note 5. Definition of contrast ratio:
Contrast ratio is calculated with the following formula.
Luminance on the white raster
Contrast ratio (CR)=
Luminance on the black raster
(C) Copyright AU Optronics, Inc.
2004 All Right Reserved.
G104SN03 V.2
No Reproduction and Redistribution Allowed.
DataSheet4 U .com

10 Page

PáginasTotal 29 Páginas
PDF Descargar[ G104SN03V2.PDF ]

Enlace url

Hoja de datos destacado

Número de piezaDescripciónFabricantes
G104SN03V0TFT LCD ModuleData Modul
Data Modul
G104SN03V2TFT LCD ModuleData Modul
Data Modul

Número de piezaDescripciónFabricantes

Low Power Audio Codec.

Analog Devices
Analog Devices

32.768 kHz and MHz GreenCLK.


High Voltage 3 phase Motor Driver IC.


12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.

Index : 0  1  2  3  4  5  6  7  8  9  A  B  C  D  E  F  G  H  I  J  K  L  M  N  O  P  Q  R  S  T  U  V  W  X  Y  Z    |   2018   |  Contacto  |  Buscar