DataSheet.es    


PDF 3B44 Data sheet ( Hoja de datos )

Número de pieza 3B44
Descripción (3B42 - 3B44) Isolated AC Sine Wave Input
Fabricantes Analog Devices 
Logotipo Analog Devices Logotipo



Hay una vista previa y un enlace de descarga de 3B44 (archivo pdf) en la parte inferior de esta página.


Total 8 Páginas

No Preview Available ! 3B44 Hoja de datos, Descripción, Manual

www.DataSheet4U.com
Isolated AC Sine Wave Input
3B42 / 3B43 / 3B44
FEATURES
AC averaging technique used to rectify, amplify, and filter 50
Hz to 400 Hz sine-wave signals.
Accepts inputs of between 20 mV to 550 V rms to give an rms
output reading.
Module provides simultaneous precision voltage and
current outputs.
Module circuitry can withstand 130v rms at the input screw-
terminals.
All 3B42, 3B43, & 3B44 series modules are mix-and-match
and Hot Swappable.
APPLICATIONS
Industrial signal conditioning
Industrial signal isolation
Industrial signal filtering
FUNCTIONAL BLOCK DIAGRAM
Figure 1. 3B42, 3B43, & 3B44 Functional Block Diagram
Output modules accept 0 to +10V (or +10V) single-ended
signals and provide an isolated 4-20 mA (or 0-20 mA) process
signal. All modules feature a universal pin-out and may be
readily hot-swapped under full power and interchanged without
disrupting field wiring.
The Analog Devices 3B Series Signal Conditioning Subsystem is
PRODUCT OVERVIEW
The 3B Series of Signal Conditioning I/o Subsystems provide a
designed to easily
measurement and
handle signal conditioning
control applications. Some
problems in
typical uses are
inDataShee
low-cost, versatile method of transferring analog transduDcaertaSheet4U.cmomicrocomputer-based data acquisition systems, programmable
signals to a data acquisition, monitoring or control system
controllers, analog recorders, dedicated control systems, and any
without the inherent noise, non-linearity, drift and extraneous
other applications where monitoring of temperature, pressure,
voltages. The modules are designed to directly accept analog
flow and analog signals are required. Since each input module
signals from Thermocouples, RTD’s, AC and DC Strain Gages,
features two simultaneous outputs, the voltage output can be
Torque Transducers, Frequency Transducers, LVDTs, millivolt
used to provide an input to a microprocessor-based data
or process current signals. The modules amplify, isolate,
acquisition or control system while the current output can be
linearize and convert the transducer output signals to
used for analog transmission, operator interface, or an analog
standardized analog inputs for high-level analog I/O
backup system.
subsystems. The 3B Series Subsystem consists of a 10” relay
rack with universal mounting backplane and a family of plug-in
(up to 16 per rack) input and output signal conditioning
modules.
Each input module is a single-channel signal conditioner which
plugs into a socket on the backplane and accepts its signal from
the input screw terminals. All input modules provide input
protection, amplification and filtering of the input signal,
Eight and four channel backplanes are also available. Each
backplane incorporates screw terminals for sensor inputs and
current outputs and a 26-pin connector for high-level single-
ended voltage outputs to the user’s equipment.
accuracy of +0.1%, low drift of +1 uV/ oC (low-level input
modules), and feature two high-level analog outputs that are
compatible with most process instrumentation. The isolated
input modules also provide +1500 V peak isolation.
The input modules feature complete signal conditioning
circuitry optimized for specific sensors or analog signals and
provide two simultaneous high-level analog outputs: 0 to +10V
(or +10V) and 4-20 mA (or 0-20 mA).
The choice of a specific 3B module depends upon the type of
input signal. Input modules are available to accept millivolt, volt,
process current, thermocouple, RTD, AC and DC strain gage,
frequency and LVDT inputs. The voltage output of each module
is available from the system I/O connector while the current
output is available on the output screw terminals.
Rev. 0
Information furnished by Analog Devices is believed to be accurate and reliable.
However, no responsibility is assumed by Analog Devices for its use, nor for any
DataSheet4Uinf.rcinogemments of patents or other rights of third parties that may result from its use.
Specifications subject to change without notice. No license is granted by implication
or otherwise under any patent or patent rights of Analog Devices. Trademarks and
registered trademarks are the property of their respective companies.
DataSheet4 U .com
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
www.analog.com
Fax: 781.326.8703 © 2004 Analog Devices, Inc. All rights reserved.
DataSheet4U.com

1 page




3B44 pdf
www.DataSheet4U.com
PIN CONFIGURATIONS AND FUNCTIONAL DESCRIPTIONS
3B42 / 3B43 / 3B44
Figure 3 3B42, 3B43, & 3B44 Input Field Connections
Table 1. Pin Function Descriptions—
Pin No. Description
1 N/C
2 HI
3 LO
4 N/C
Figure 4 . Model 3B Series Module, with pin-out assignments.
et4U.com
ESD CAUTION
DataSheet4U.com
ESD (electrostatic discharge) sensitive device. Electrostatic charges as high as 4000 V readily accumulate on the human
body and test equipment and can discharge without detection. Although this product features proprietary ESD
protection circuitry, permanent damage may occur on devices subjected to high energy electrostatic discharges.
Therefore, proper ESD precautions are recommended to avoid performance degradation or loss of functionality.
DataShee
DataSheet4U.com
DataSheet4 U .com
Rev. 0 | Page 5 of 8
DataSheet4U.com

5 Page










PáginasTotal 8 Páginas
PDF Descargar[ Datasheet 3B44.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
3B42(3B42 - 3B44) Isolated AC Sine Wave InputAnalog Devices
Analog Devices
3B43(3B42 - 3B44) Isolated AC Sine Wave InputAnalog Devices
Analog Devices
3B44(3B42 - 3B44) Isolated AC Sine Wave InputAnalog Devices
Analog Devices
3B45(3B45 / 3B46) Isolated Frequency InputAnalog Devices
Analog Devices

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar