DataSheet.es    


PDF S6707 Data sheet ( Hoja de datos )

Número de pieza S6707
Descripción STRS6707 / STR-S6707
Fabricantes Allegro MicroSystems 
Logotipo Allegro MicroSystems Logotipo



Hay una vista previa y un enlace de descarga de S6707 (archivo pdf) en la parte inferior de esta página.


Total 8 Páginas

No Preview Available ! S6707 Hoja de datos, Descripción, Manual

www.DataSheet4U.com
STR-S6707 THRU
STR-S6709
OFF-LINE SWITCHING REGULATORS
– WITH BIPOLAR SWITCHING TRANSISTOR
COLLECTOR 1
COMMON 2
BASE 3
SINK 4
DRIVE 5
OVER-CURRENT
PROTECTION
6
FDBK 7
INHIBIT 8
VIN 9
DRIVE
OSC.
FAULT
S
FAULT
LATCH
R
REF.
UVLO
Dwg. PK-001
ABSOLUTE MAXIMUM RATINGS
Supply Voltage, VIN ........................... 15 V
Output Voltage, VCEX ....................... 850 V
VEBO ................................................ 7 V
Continuous Output Current,
IC .......................................... See Table
1 ms Single-Pulse Output Current,
ICM ........................................ See Table
Sink Current, IS ......................... See Table
Drive Current, ID .......................... -700 mA
Feedback Current, IFDBK ................. 20 mA
Inhibit Voltage, VINH ........................... 15 V
Over-Current Protection Voltage Range,
VOCP ............................................ ±3.5 V
Insulation Voltage,VWM(RMS) ........... 2000 V
Package Power Diss., PD ........ See Graph
Output Junction Temperature, TJ .. +150°C
Internal Frame Temperature, TF ... +125°C
Operating Temperature Range,
TA ............................... -20°C to +125°C
Storage Temperature Range,
Tstg ............................. -40°C to +125°C
The STR-S6707, STR-S6708, and STR-S6709 are specifically
designed to meet the requirement for increased integration and reliabil-
ity in off-line quasi-resonant flyback converters. These devices incorpo-
rate the primary control and proportional drive circuit with a third-
generation high-voltage bipolar switching transistor.
Crucial system parameters such as maximum ON time and OFF
time are fixed during manufacture. Local control circuit decoupling and
layout are optimized within each device.
Cycle-by-cycle current limiting, under-voltage lock-out with hyster-
esis, over-voltage protection, and thermal shutdown protect these
devices during all normal and overload conditions. Over-voltage
protection and thermal shutdown are latched after a short delay. A
versatile triple-level inhibit circuit includes the OFF time synchronization
required to establish quasi-resonant operation. The inhibit function has
also been expanded to initiate operation in stand-by mode in which the
power supply delivers a small fraction of the steady-state output power.
The dual requirements of dielectric isolation and low transient thermal
impedance and steady-state thermal resistance are satisfied in an over-
molded single-in-line power package.
Proven in substantial volumes, these devices and their fixed-
frequency counterparts represent a significant advance in off-line SMPS
reliability growth and integration.
FEATURES
I Quasi-Resonant Operation for Low EMI and High Efficiency
I Output Power to 220 W
I Low-Power Output Standby Mode
I Pulse-by-Pulse Over-Current Protection
I Latched Over-Voltage and Thermal Protection
I Third-Generation Switching Transistor with Proportional Drive
I Maximum ON Time and Off Time Set During Manufacture
I Internal Under-Voltage Lockout with Hysteresis
I Over-Molded SIP with Integral Isolated Heat Spreader
Always order by complete part number:
Part Number
Max. Cont.
Current, IC
Peak
Current, ICM
STR-S6707
STR-S6708
STR-S6709
6A
7.5 A
10 A
12 A
15 A
20 A
Max. Sink
Current, IS
1.5 A
1.5 A
2A

1 page




S6707 pdf
www.DataSheet4U.com
STR-S6707 THRU STR-S6709
OFF-LINE
QUASI-RESONANT FLYBACK
SWITCHING REGULATORS
TYPICAL QUASI-RESONANT FLYBACK CONVERTER
WARNING: lethal potentials are present. See text.
9
+
7
R
SQ
8
+
+
+
+
5
4
3
1
2
6
#
+ OUTPUT
+
VOLTAGE
SENSE
– OUTPUT
Dwg. EK-004A
APPLICATIONS INFORMATION
WARNING These devices are designed to be operated at lethal voltages and energy levels. Circuit
designs that embody these components must conform with applicable safety requirements. Precau-
tions must be taken to prevent accidental contact with power-line potentials. Do not connect
grounded test equipment.
The use of an isolation transformer is recommended during circuit development and breadboarding.
Recommended mounting hardware torque:
4.34 5.79 lbfft (6 8 kgcm or 0.588 0.784 Nm).
Recommended metal-oxide-filled, alkyl-degenerated oil base, silicone grease:
Dow Corning 340, or equivalent
www.allegromicro.com

5 Page










PáginasTotal 8 Páginas
PDF Descargar[ Datasheet S6707.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
S6705MGInfrared Laser DiodeRoithner Lasertechnik
Roithner Lasertechnik
S6707 STRS6707 / STR-S6707Allegro MicroSystems
Allegro MicroSystems
S6708 STR-S6708Allegro MicroSystems
Allegro MicroSystems

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar