|
|
PDF FTM-3001C Data sheet ( Hoja de datos )
| Número de pieza | FTM-3001C | |
| Descripción | SFP Transceiver | |
| Fabricantes | Fiberxon | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de FTM-3001C (archivo pdf) en la parte inferior de esta página. Total 11 Páginas | ||
|
No Preview Available !
Apr. 27, 2005
155Mbps SFP Transceiver
( For 15km～80km transmission )
Members of FlexonTM Family
Standard
Compliant with SFP MSA
Compliant with ITU-T G.957 and G.958
Compliant with Telcordia GR-253-CORE
Compliant with FCC 47 CFR Part 15, Class B
Compliant with FDA 21 CFR 1040.10 and
m1040.11, Class I
.coFeatures
UUp to 155Mbps data-rate
t41310nm FP laser and PIN photodetector for
15km and 40km transmission
e1550nm uncooled DFB laser and PIN
ephotodetector for 80km transmission
Standard serial ID information compliant with
hSFP MSA
SSFP MSA package with duplex LC connector
taVery low EMI and excellent ESD protection
+3.3V single power supply
aOperating case temperature:
Standard : 0 to +70°C
.DIndustrial : -40 to +85°C
wApplications
wSDH STM-1, S-1.1, L-1.1, L-1.2
wSONET OC-3 IR1, LR1, LR2
Description
Fiberxon 155Mbps SFP transceiver is high
performance, cost effective module that supports
data-rate of 155Mbps and transmission distance
from 15km to 80km.
The transceiver consists of two sections: The
transmitter section incorporates a FP or uncooled
DFB laser, and the receiver section consists of a
PIN photodiode integrated with a trans-impedance
preamplifier (TIA). All modules satisfy class I laser
safety requirements.
The optical output can be disabled by a TTL logic
high-level input of Tx Disable. Tx Fault is provided to
indicate that degradation of the laser. Loss of signal
(LOS) output is provided to indicate the loss of an
input optical signal of receiver.
The standard serial ID information compliant SFP
Other optical links
MSA describes the transceiver’s capabilities,
omstandard interfaces, manufacturer and other
.cinformation. The host equipment can access this
Uinformation via the 2-wire serial CMOS EEPROM
t4protocol. For further information, please refer to SFP
eeMulti-Source Agreement (MSA).
.DataShFiberxon Proprietary and Confidential, Do Not Copy or Distribute
wwwPage 1 of 11
1 page  
155Mbps SFP Transceiver
15～80 km transmission
Apr. 27, 2005
FTM-5001C-S80 (1550nm DFB and PIN, 80km)
Table 6 - Optical and Electrical Characteristics
Parameter
Symbol
Min.
Typical
Max.
Unit Notes
Centre Wavelength
Average Output Power
Spectral Width (-20dB)
Transmitter
λC 1480
P0ut -5
∆λ
1580
0
1
nm
dBm
nm
1
Side Mode Suppression Ratio
SMSR
30
dB
Extinction Ratio
EX 10
dB
Jitter Generation (RMS)
0.01
UI
Jitter Generation (pk-pk)
0.1 UI
Output Optical Eye
Compliant with Telcordia GR-253-CORE and ITU-T G.957
2
Data Input Swing Differential
Input Differential Impedance
TX Disable
Disable
Enable
VIN 300
1860
mV
3
ZIN 90 100 110 Ω
2.0 Vcc V
0 0.8 V
TX Fault
Fault
Normal
2.0
Vcc+0.3
V
0 0.8 V
Centre Wavelength
Receiver Sensitivity
Receiver
λC 1260
1580
-34
nm
dBm
4
Receiver Overload
-3
dBm
4
Optical Path Penalty
1 dB 5
LOS De-Assert
LOS Assert
LOS Hysteresis
LOSD
LOSA
-45
1
-37 dBm
dBm
4 dB
Data Output Swing Differential
LOS
High
Low
VOUT
370
2.0
0
1800
Vcc+0.3
0.8
mV
V
V
6
Notes:
1. The optical power is launched into SMF.
2. Measured with a PRBS 223-1 test pattern @155Mbps.
3. PECL input, internally AC coupled and terminated.
4. Measured with a PRBS 223-1 test pattern @155Mbps, worst-case extinction ratio, BER ≤1×10-10.
5. Measured with a PRBS 223-1 test pattern @155Mbps, over 80km G.652 SMF, BER ≤1×10-10.
6. PECL output, internally AC coupled.
Fiberxon Proprietary and Confidential, Do Not Copy or Distribute
Page 5 of 11
5 Page 
155Mbps SFP Transceiver
15～80 km transmission
Apr. 27, 2005
© Copyright Fiberxon Inc. 2005
All Rights Reserved.
All information contained in this document is subject to change without notice. The products described in this
document are NOT intended for use in implantation or other life support applications where malfunction may
result in injury or death to persons.
The information contained in this document does not affect or change Fiberxon product specifications or
warranties. Nothing in this document shall operate as an express or implied license or indemnity under the
intellectual property rights of Fiberxon or third parties. All information contained in this document was obtained
in specific environments, and is presented as an illustration. The results obtained in other operating
environment may vary.
THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN ”AS IS” BASIS. In no event
will Fiberxon be liable for damages arising directly from any use of the information contained in this document.
Contact
U.S.A. Headquarter:
5201 Great America Parkway, Suite 350
Santa Clara, CA 95054
U. S. A.
Tel: 408-562-6288
Fax: 408-562-6289
Or visit our website: http://www.fiberxon.com
Fiberxon Proprietary and Confidential, Do Not Copy or Distribute
Page 11 of 11
11 Page | ||
| Páginas | Total 11 Páginas | |
| PDF Descargar | [ Datasheet FTM-3001C.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| FTM-3001C | SFP Transceiver | Fiberxon |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |