DataSheet.es    


PDF KDC-7021SE Data sheet ( Hoja de datos )

Número de pieza KDC-7021SE
Descripción (KDC-xxxx) CD-Receiver Instruction Manual
Fabricantes Kenwood 
Logotipo Kenwood Logotipo



Hay una vista previa y un enlace de descarga de KDC-7021SE (archivo pdf) en la parte inferior de esta página.


Total 40 Páginas

No Preview Available ! KDC-7021SE Hoja de datos, Descripción, Manual

KDC-V7521
KDC-B7021
KDC-7021
KDC-7021SE
CD-RECEIVER
INSTRUCTION MANUAL
© B64-2591-00/00 (EF)

1 page




KDC-7021SE pdf
About RDS
The marking of products using lasers
(Except for some areas)
CLASS 1
LASER PRODUCT
The label is attached to the chassis/case and
says that the component uses laser beams
that have been classified as Class 1. It means
that the unit is utilizing laser beams that are of
a weaker class. There is no danger of
hazardous radiation outside the unit.
RDS (Radio Data System)
When listening to an RDS station, the program
service name of the station is displayed,
advising you quickly which station is being
received.
RDS (Radio Data System) stations also
transmit alternative frequency data for the
same station. When you are making long trips,
this function automatically switches to the
particular frequency with the best reception
for the particular network of stations that you
want to listen to. The data is automatically
stored, allowing you to switch quickly to
another RDS stations, broadcasting the same
program, that has better reception. These
include stations stored in the station preset
memory that you often listen to.
Enhanced Other Network
Stations that offer <Enhanced Other
Network> also transmit information about
other RDS stations that have traffic
information. When you are tuned to a station
that is not transmitting traffic information, but
another RDS station starts transmitting a
traffic bulletin, the tuner automatically
switches to the other station for the duration
of the bulletin.
Alarm
When an emergency transmission (announcing
disasters, etc.) is sent, all current functions are
interrupted to allow the warning to be
received.
—5—

5 Page





KDC-7021SE arduino
Theft Deterrent Faceplate
The faceplate of the unit can be detached and taken with you,
helping to deter theft.
Removing the Faceplate
1 Turn the ignition OFF or press the [SRC] button for at least 1
second.
The power turns OFF and the faceplate slides open.
2 Holding the center part of the faceplate pull it out.
Hiding the Control Panel
Prevents tampering with the unit while your car is being serviced
etc.
Hiding the control panel
Press the [SRC] button for at least 1 second.
The faceplate slides open.
When the time set in <OFF Wait Time Setting> (page 24) lapses,
the faceplate is hidden and the power turns OFF.
Showing the control panel
Press the left part at the upper side of the faceplate.
The faceplate will open and show the control panel.
• When the faceplate is kept remove open, according to the <OFF
Wait Time Setting> (page 24) setting, the faceplate is hidden and
the power turns OFF.
• The faceplate is a precision piece of equipment and can be
damaged by shocks or jolts. For that reason, keep the faceplate in
its special storage case while detached.
• Do not expose the faceplate or its storage case to direct sunlight
or excessive heat or humidity. Also avoid places with too much
dust or the possibility of water splashing.
Reattaching the Faceplate
1 Set the left side of the faceplate in the faceplate bracket.
TEL Mute
The audio system automatically mutes when a call comes in.
When a call comes in
"CALL" is displayed.
The audio system pauses.
Listening to the audio during a call
Press the [SRC] button.
The "CALL" display disappears and the audio system comes back
ON.
When the call ends
Hang up the phone.
The "CALL" display disappears and the audio system comes back
ON.
2 Press the right side of the faceplate until it locks.
— 11 —

11 Page







PáginasTotal 40 Páginas
PDF Descargar[ Datasheet KDC-7021SE.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
KDC-7021SE(KDC-xxxx) CD-Receiver Instruction ManualKenwood
Kenwood

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar